2017 Buick Encore Technical Service Bulletins

1,121 technical service bulletins (TSBs) are on record for the 2017 Buick Encore. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10171879Jan 8, 2020Engine cooling. This technical bulletin provides a procedure to install a PCV heater or a charge air cooler to correct the turbo charger system from freezing causing cold weather performance issues.
• 10171878Jan 2, 2020Equipment, Fuel system. This informational bulletin advises of a new fuel injection cleaner kit used for decarbonizing the intake valves to correct conditions of rough idle, Crank no start, extended crank or misfire, MIL with DTCs, and explains how Top Tier fuels should be used to reduce carbon build-up.
• 10170498Dec 12, 2019Equipment. This preliminary information bulletin provides information om Service Programming System (SPS) Error Codes (E4398, E4399, E4403, M4404, M4413, M6954, M6955, E4414, E4423, E4491 or E6961).
• 10169353Nov 27, 2019Visibility (wipers, defrost, mirrors). This technical bulletin provides a procedure to correct a condition of wiper blades streaky, Do Not Clean and/or Noisy.
• 10169357Nov 26, 2019Equipment. This informational bulletin provides information on key code security rules and information on GM keycode look-up applications.
• 10169355Nov 25, 2019Equipment. This informational bulletin provides information for dealers/technicians on Use of Dealer Case Management (DCM) and Being Prepared for Contacting U.S. Technical Assistance (TAC).
• 10168978Nov 22, 2019Transmission and drivetrain. This Preliminary information communicates to the dealer technician that TAC recommends the utilization of the GDS2 software to aid in diagnosing automatic transmission concerns. TAC is requesting the GDS2 session logs be sent in before the dealer contacts TAC.
• 10169298Nov 13, 2019Transmission and drivetrain. Information on Transmission Adaptive Functions and Correcting Low Mileage Harsh Shifts, Slips, or Flares.
• 10169356Nov 12, 2019Equipment, Tires, Wheels. This technical bulletin provides a procedure on how to clean and resurface aluminum wheel bead seats for vehicles that have the condition of Tire Slowly Goes Flat, Tire Air Loss, Low Tire Pressure Warning Light Illuminated, Aluminum Wheel Bead Seat Corrosion.
• 10169354Nov 12, 2019Equipment, Exterior lighting. This informational bulletin provides information for dealers/technicians on Exterior Lamp Condensation and Replacement Guidelines.
• 10168960Nov 12, 2019Brakes, Wheels. This Preliminary Information communication provides information to the technician about changing the tire and wheel size on vehicles. General Motors will only support a tire calibration for tires that have been sized, tested and designed for the vehicle in question and its applications. Technician should not use the information that is provided by the antilock braking system tire size selection.
• 10168956Nov 5, 2019Electrical system. This Preliminary Information communication provides information to the technician about the use of J-35616-64B terminal test probe, replacement terminals, and terminated leads. The J-35616-64B is the latest test probe released for checking tension or probing the .64 series terminals. The test probe terminal has been released in the terminal repair kit (J-38125-620H) located in Lear Tray 7 part number 963716-2.
• 10168212Oct 29, 2019Transmission and drivetrain. This informational bulletin provides information on Driveline Clunk Noise and what is acceptable and what is considered normal operations.
• 10167455Oct 22, 2019Equipment. This Preliminary information communicates the use of air leak diagnostic test tool CH-52250 in addition to the information found in the service manual.
• 10168207Oct 16, 2019Equipment. This informational bulletin provides information for dealers how to submit a product information report (PIR) (Canada Only).
• 10168175Oct 14, 2019Transmission and drivetrain. This Bulletin provides guidelines for Dealers Not Required and for Dealers Required to Contact the PQC for engine or transmission assembly replacement and explains the PQC process, GWM Transaction submission, vehicle service record retention and proper handling of assembly returns.
• 10167437Oct 14, 2019Engine. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components. That any of the listed DTC's may set with or without poor engine performance.
• 10167436Oct 14, 2019Engine cooling. This Preliminary Information communication provides information to the technician about vehicles that may have a Malfunction Indicator Lamp on. The technician may find Diagnostic Trouble Codes P0299 or P0234 set. The technician is provided with a list of causes of misdiagnosis leading to returned Turbochargers with no trouble found.
• 10167434Oct 10, 2019Electrical system. This Preliminary Information communication provides information to the technician about vibration complaints that are one of the most challenging complaints to accurately diagnose and repair. Technician will need to use Pico Oscilloscope Diagnostic Kit to effectively diagnosis vehicles. Technician should drive the vehicle will using the Pico Oscilloscope to record data. After the data is recorded it should be…
• 10168208Oct 9, 2019Equipment. This informational bulletin provides information on key code security and information on GM key code look up applications.
• 10168205Oct 9, 2019Engine cooling. This informational bulletin provides guidelines and diagnostic/repair information to technicians regarding vehicle engine oil consumption.
• 10167429Oct 8, 2019Engine cooling. This Preliminary information communicates the following to the dealer. If an engine oil leak has been isolated to the front crankshaft seal, check for misfires low engine compression and/or cylinder leakage readings. These issues could cause excessive positive crankcase pressure leading to engine oil leaks.
• 10168204Oct 2, 2019Equipment. This informational bulletin provides information on comebacks prevention information and using customer concern verification sheets (CCVS).
• 10168188Oct 2, 2019Equipment. This Warranty Administration bulletin provides information for dealers/Service advisors on when and how to submit a Pre-Repair Authorization (PRA) (US dealers only).
• 10165911Sep 26, 2019Engine cooling. This Preliminary information communicates the following to the dealer. If an engine oil leak has been isolated to the front crankshaft seal, check for misfires low engine compression and/or cylinder leakage readings. These issues could cause excessive positive crankcase pressure leading to engine oil leaks.
• 10165904Sep 25, 2019Electrical system. This Preliminary Information communication provides information to the technician about a no start or another concern after swapping an Engine Control Module or other modules from one vehicle to another. The Global Architecture electrical system associated with these vehicles does not allow controller swaps between vehicles.
• 10166638Sep 18, 2019Equipment. This warranty administration bulletin provides information regarding the field action courtesy transportation policy.
• 10166236Sep 11, 2019Engine cooling. N192210240 - Special Coverage Adjustment - Certain vehicles shown above, may have a condition that could cause the evaporative emissions purge valve to not fully close. If this condition occurs, the engine could run rough, hesitate or stall at idle speeds. Additionally, the Malfunction Indicator Light (Check Engine Light) would illuminate and a diagnostic trouble code would be set.
• 10165877Sep 6, 2019Electrical system. This Preliminary Information communication provides information to the technician that General Motors Technical Assistance Center may ask for Global Diagnostic System 2 Session Log. Technician will need use Global Diagnostic System 2 to send the session logs to General Motors Technical Assistance Center for further assistance on the vehicle in question.
• 10165874Sep 5, 2019Equipment. This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts/kits. Technicians should refer to Service Information for information regarding most accessories. Technicians may also contact PARTECH and/or the Techline Customer Support Center for additional support.
• 10165127Aug 23, 2019Electrical system. This preliminary information bulletin provides information om Service Programming System (SPS) Error Codes E4398, E4399, E4403, M4404, M4413, E4414, E4423, E4491 or E6961).
• 10165087Aug 23, 2019Equipment. This warranty administration bulletin provides policy information, proper labor operation selection and causal part identification for warranty transactions (U.S. Only).
• 10165089Aug 20, 2019Engine cooling. This technical bulletin provides a procedure to repair the mechanical components and then be sure to reprogram the throttle body to prevent the conditions of a rough running engine, MIL On from happening again.
• 10165126Aug 19, 2019Equipment. This bulleting provides Wiring, Terminal and Connector Repair Information including how to determine the Service Part Number in eSI and how to locate the part(s) in the EPC.
• 10165121Aug 15, 2019Engine cooling. This informational bulletin provides information on replacing the intake manifold when the engine is replaced after severe internal engine damage.
• 10165441Aug 13, 2019Electrical system, Equipment. N192218430 - Customer Satisfaction Program. During service, certain vehicles equipped with OnStar (RPO UE1), may have received an incorrect and partially programmed/configured replacement OnStar module. This condition will disable certain OnStar features, including Remote Access (remote start, door lock/unlock, etc.), Connected Access (vehicle diagnostics, dealer maintenance notification, etc.), and Unlimited…
• 10165122Aug 13, 2019Engine cooling. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement.
• 10165123Aug 12, 2019Transmission and drivetrain. This informational bulletin provides information on Some vehicles may rock or move slightly forward or rearward while in Park at start up after cold soak. This condition may be accompanied by a clunk noise. This is a slight movement that is more often seen visually, rather than felt, when viewed from the outside and using the auto-start feature, if equipped.
• 10164749Aug 7, 2019Visibility (wipers, defrost, mirrors). This Preliminary Information communication provides the technician with steps to resolve the issue of an oily substance that may be found on the inside windshield surface, and appears to be leaking from the rear view mirror area. Technician will remove the moisture sensor and clean the glass and mounting bracket with alcohol wipe. If the gel separates from the sensor the sensor will need to be replaced.
• 10165079Aug 5, 2019Steering. This technical bulletin provides a procedure inspecting for excess grease or Sealant on the Exterior of the steering gear due to seeing grease or sealant on certain locations on the gear.
• 10163686Jul 30, 2019Equipment. This Preliminary information communicates additional information on how a LIN bus operates and diagnostic tips when working on a LIN bus.
• 10163681Jul 29, 2019Equipment. This Preliminary information communicates that when a customer or technician attempts to add a new transmitter to a vehicle following the adding transmitters without Service Programming System procedure the procedure will not complete and a message "Remote Learn Pending" will be displayed on the Driver Information Center. In the past to perform the new transmitter procedure only one previously learned transmitter…
• 10163900Jul 26, 2019Equipment. This informational bulletin provides process information for the (GWM) and (WPC) parts return program.
• 10163679Jul 25, 2019Equipment. This Preliminary Information communication provides information to the technician about vehicles that may have a Malfunction Indicator Lamp on. Technician may find Diagnostic Trouble Codes P0171 and or P1101 set. Technician will need to inspect the Air Cleaner Housing. If the air cleaner housing does not have the correct content for the engine application as shown, dealer is instructed to replace the Air Cleaner…
• 10163665Jul 16, 2019Vehicle speed control, Wheels. This Preliminary information communicates direction and examples when diagnosing multiple DTCs, one of which includes U**** Byte 71 DTC.
• 10164115Jul 12, 2019Equipment. This technical bulletin provides repair information to correct a customer concern of Audio Muting When Listening to Some SiriusXM Channels Due to Interference in Some Geographic Locations.
• 10163659Jul 10, 2019Equipment. This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts/kits. Technicians should refer to Service Information for information regarding most accessories. Technicians may also contact Partech and/or the Techline Customer Support Center for additional support.
• 10163888Jul 9, 2019Engine. This technical bulletin provides a procedure to repair the mechanical components and then be sure to reprogram the throttle body to prevent the conditions of a rough running engine, MIL On from happening again.
• 10163272Jun 26, 2019Equipment. The intent of this technical bulletin is to identify aftermarket ALDL or DLC interface devices as potential sources for causing multiple customer concerns that do not have other diagnostic methods to identify them.
• 10163268Jun 26, 2019Electrical system, Equipment. This bulletin provides information for electrical ground repairs using new General Motors replacement fasteners with conductive finish.

← All problems reported for the 2017 Buick Encore