2012 Cadillac Escalade Technical Service Bulletins

1,582 technical service bulletins (TSBs) are on record for the 2012 Cadillac Escalade. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10138655Feb 28, 2014Visibility (wipers, defrost, mirrors), Equipment. This technical bulletin provides a procedure to install double sided tape to the windshield molding to correct the customers concern of a tapping or clicking noise at the winshield area.
• 10138652Feb 27, 2014Equipment. This preliminary bullin provides a procedure to replace the mobile microphone speaker to correct the customers concern for poor voice quality when using bluetooth.
• 10111966Feb 26, 2014Electrical system. This Preliminary Information communication provides information to the technician about vehicles that have an OnStar system that will not power up. Technician should turn off the ignition and cancel retained accessory power. After the vehicle has powered down, remove power to the OnStar module for five minutes. After the power has been removed for five minutes, if the OnStar system is working release the vehicle.
• 10111964Feb 26, 2014Electrical system. This Preliminary Information communication provides information to the technician about vehicles that have the OnStar system does not respond properly to some numbers and/or voice commands. Dealer should direct the customer to review the operational characteristics in the OnStar Users Guide.
• 10138646Feb 25, 2014Transmission and drivetrain, Engine, Equipment. This informational bulletin provides a process to the service agents that are not required to contact PQC, to determine when to replace a assembly as opposed to repairing and if an engine or transmission is being returned, that it has all the information in relation to that part being returned.
• 10111962Feb 25, 2014Electrical system. This Preliminary Information communication advises the technician that when replacing the camshaft part number 12626660. Technician will need to ensure that the date code and the finish of the camshaft. If the cam is discolored or has chatter marks, have parts department send the cam back as (MR code7) new defective.
• 10066134Feb 25, 2014Equipment, Body and structure. "12286a - service update (revised expiration date). This bulletin provides a service procedure to install a rubber and a foam spacer to the backside of both rear side door window reveal moldings on certain vehicles. On some of these vehicles, there may be inadequate clearance between the rear side door and the molding. During molding installation, paint damage may have occurred. In addition, when the molding is…
• 10138640Feb 21, 2014Visibility (wipers, defrost, mirrors). This warranty bulletin explains how to determine if an outside mirrior was damaged by the customer and what is considered warranty and non-warranty.
• 10138639Feb 21, 2014Equipment, Wheels. This informational bulletin provides the technician the proper way to install and torque the wheel.
• 10138638Feb 21, 2014Wheels. This informational bulletin explains how to balance a chrome wheel without damaging the chrome face of the rim.
• 10138637Feb 21, 2014Wheels, Equipment, Tires. This informational bulletin provides technicians with ways to decrease the tire slipping on the rim and reduce to possible chances of the customers concerns over tire vibration are repair.
• 10138631Feb 18, 2014Tires, Wheels. This technical bulletin provides a procedure on cleaning a leaking rim, to correct a customers concern of having a slow tire leak and low tire psi message on.
• 10138630Feb 18, 2014Equipment, Tires. This informational bulletin explains the use of Nitrogen in GM tires.
• 10138629Feb 18, 2014Tires. This bulletin provides information regarding the normal tire wear condition of slight or mild tire feathering and recommended practices.
• 10138621Feb 17, 2014Equipment. This informational bulletin helps the technician quick reference repairs to bulletins as opposed to replacing parts that may be un necessary.
• 10111934Feb 17, 2014Equipment, Engine cooling. This Preliminary Information communication advises the technician that the Drive Motor Generator Control Module, also known as PIM) for the 2-Mode Hybrid Utilities and Trucks are being placed on restriction through the General Motors Technical Assistance Center. Dealer will need to contact General Motors Technical Assistance Center for further assistance.
• 10111927Feb 12, 2014Brakes, Fuel system, Equipment. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp. Technician may find Diagnostic Trouble Code P0442. Technician will need to review Techlink article from May 2013 titled "Using the Evaporative Emissions System Tester" Technician will need to follow these steps to help diagnose the issue. First after the P0442…
• 10138609Feb 10, 2014Equipment. The informational bulletin provides a procedure to remove and repair rust from a Hem Flange.
• 10138606Feb 10, 2014Visibility (wipers, defrost, mirrors), Equipment. This warranty administration bulletion provides the dealer technician information and guidelines for claiming a windshield.
• 10138605Feb 10, 2014Equipment. This technical bulletin provides a procedure to correct the customers concern of odor coming from the Air conditioning.
• 10111911Feb 7, 2014Equipment. This Preliminary Information communication provides information to the technician that First Responder Guides for General Motors vehicles can be accessed via the web at http://www.gmstc.com.
• 10138601Feb 6, 2014Equipment, Transmission and drivetrain. This preliminary informational bulletin provides a procedure to inspect the transmissions filter for splits or cracks to correct the customers concern for no forward, reverse or slips.
• 10111894Feb 4, 2014Equipment. This Preliminary Information communication provides information to the technician that General Motors and General Motors of Canada Company do not support cross border sales. The General Motors of Canada Customer Care Centre is the sole authorized provider of a certification confirmation letter which helps our customers identify if their vehicles meets the required USA regulatory standards necessary for importation…
• 10111892Feb 4, 2014Engine. This Preliminary Information communication provides information to the technician about vehicles that may have a cold engine tick noise for 50 seconds at start up. Technician determines if the tick noise is possibly coming from the exhaust manifold, as this noise could easily be mistaken for an engine tick noise.
• 10190932Feb 1, 2014Equipment, Wheels. Refinishing Aluminum Wheels This bulletin updates General Motor's position on refinishing aluminum wheels. GM does not endorse any repairs that involve welding, bending, straightening o re-machining. Only cosmetic refinishing of the wheel's coatings, using recommended procedures, is allowed. Evaluating Damage In evaluating damage, it is the GM Dealer's responsibility to inspect the wheel for corrosion, scrapes…
• 10190931Feb 1, 2014Equipment, Wheels. Refinishing Aluminum Wheels This bulletin updates General Motor's position on refinishing aluminum wheels. GM does not endorse any repairs that involve welding, bending, straightening o re-machining. Only cosmetic refinishing of the wheel's coatings, using recommended procedures, is allowed. Evaluating Damage In evaluating damage, it is the GM Dealer's responsibility to inspect the wheel for corrosion, scrapes…
• 10137784Jan 31, 2014Equipment. This informational bulletin provides information for the dealer technician to gather as much information to help aid Engineers by completely filling out requested reports.
• 10112045Jan 31, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicles that has no XM audio on certain channels but XM channel info is displayed. Technician will need to contact XM and deactivate and activate the module.
• 10112033Jan 28, 2014Electrical system, Equipment. This Preliminary Information communication provides information to the technician about vehicles that have navigation or radio screen is blank or flashes on and off, no sound from speakers, and rear DVD screen inoperative. Technician will find Diagnostic Trouble Codes B1265, B1288, or B1289. Technician will need to repair circuit 7066.
• 10112032Jan 28, 2014Electrical system, Back-over prevention (rear camera). This Preliminary Information communication provides information to the technician about vehicles that have a rear camera display being inoperative when shifting into reverse. Technician should check for a loose or disconnected X421/X322 connector behind the right side "C" pillar trim. Technician should also check for pinched, Open or shorted wires on camera circuits 7641, 7642, and 6799.
• 10137781Jan 23, 2014Equipment. This informational bulletin was created to inform that any accessories that are install from the GM factory will be covered under the standard vehicle warranty and dealer installed accessories will be cover for a full year (12months).
• 10112013Jan 22, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicles that may have an issue when using Bluetooth voice recognition with an iPhone. Technician should work with the customer to insure the phone contacts to not have any Emojis loaded to any contact.
• 10112009Jan 21, 2014Electrical system. This Preliminary Information communication provides information to the technician about vehicles that the speedometer needle appears to be inaccurate. Dealer should advise the customer the specification for speedometer needle accuracy is +/- 2 MPH at any given speed when looking straight at the needle.
• 10112005Jan 21, 2014Electrical system, Engine cooling. This Preliminary Information communication provides information to the technician about vehicles that have a Diagnostic Trouble Code C0569 that will not clear. Technician should be advised if there are any issues with the rotational position sensor, incremental position sensor, encoder motor, motor A or B circuits, rotational position sensor or incremental position sensor circuits when the transfer case control…
• 10112001Jan 17, 2014Brakes, Suspension. This Preliminary Information communication provides information to the technician about vehicles that have a Service Suspension System message on the Driver Information Center and the rear suspension ride height is incorrect. Technician will find Diagnostic Trouble Code C0696 or C0711 set in Electronic Suspension Control. Technician will need to inspect air compressor assembly for wire damage and repair any damage…
• 10112000Jan 17, 2014Transmission and drivetrain. This Preliminary Information communication provides information to the technician of a complaint of a sag or hesitation when accelerating. The concern is present when coasting at low speeds of less than 15 miles per hour and then aggressively applying the throttle, or after making a hard stop followed by an aggressive throttle.
• 10111997Jan 16, 2014Equipment. This Preliminary Information communication advises the technician that a noise or a vibration in the vehicle that seems to be abnormal may not have been there when the vehicle was purchased. Technician should look for Non - General Motors aftermarket accessories installed on the vehicle that can cause these issues.
• 10137777Jan 14, 2014Equipment, Electrical system. This Informational bulletin explains the warranty and policy exchange program for electronic devices and products, what can be approved by TAC and where the electronic parts can be returned to.
• 10137776Jan 14, 2014Transmission and drivetrain. This information was created to inform the technician that the 2-3 upshift and the 3-2 downshift clunk is caused by the releasing of the 2-4 band and application of the 3-4 clutch assembly during an upshift. Also during a 3-2 downshift, the releasing of the 3-4 clutch during the application of the 2-4 band, can cause torque reversal down the output shaft creating a clunk. This is a normal condition.
• 10111986Jan 14, 2014Engine cooling. This Preliminary Information communication provides information to the technician that some vehicles may have a Service Engine Soon lamp, engine misfire on cylinder 1, 4, 6, or 7 and/or tick noise. Technician will follow service information diagnosis first. If service information diagnosis does not isolate the cause of this concern perform a cylinder deactivation active fuel management system compression test in…
• 10137775Jan 8, 2014Equipment. This warranty administration bulletin provide policy information of the JOB CARD, for a repair on vehicles and what is acceptable - customer authorization; Service manager approvals and transaction authorization; Details of concern, cause and correction; Labor Time; Technician ID and acoutablity of labor time; Proper documentation and retension of warranty parts; Accurate sublet charges and receipts; Add on…
• 10111978Jan 7, 2014Electrical system. This Preliminary Information communication provides information to the technician about vehicles that have an aftermarket, add-on back up alarm will sound when unlocking the doors with the Remote Keyless Entry remote. Technician can correct this concern by turning off the perimeter lighting feature on vehicles with Driver Information Center controls or install an isolation relay in-line to the backup alarm.
• 10111977Jan 7, 2014Engine. This Preliminary Information communication provides information to the technician about vehicles that are setting Diagnostic Trouble Code P0300 after engine repairs. Technician will need to ensure that injector connectors for cylinder 5-7 and 6-8 are not crossed.
• 10137774Jan 3, 2014Equipment. This warranty administration bulletin provides information on Premium care maintenance eligibility for vehicle services and maintenance in the U.S. and Canada.
• 10137773Jan 2, 2014Equipment. This warranty administration bulletin provides information on GM?s policy for comprehensive courtesy transportation to its customers.
• 10137772Jan 2, 2014Equipment. This warranty administration bulletin provide policy information of the JOB CARD, for a repair on vehicles and what is acceptable - customer authorization; Service manager approvals and transaction authorization; Details of concern, cause and correction; Labor Time; Technician ID and acoutablity of labor time; Proper documentation and retension of warranty parts; Accurate sublet charges and receipts; Add on…
• 10245805Jan 1, 2014Equipment. Cadillac Premium Care Maintenance Eligibility for United States and Canadian Vehicles
• 10190934Jan 1, 2014Equipment, Body and structure. Underbody Component Corrosion The following information may be helpful when addressing underbody component corrosion with customers. Some customers may comment that one or more of their vehicle's underbody components are showing some form of corrosion. This corrosion may be red in appearance (rust) if the component is steel, forged iron or cast iron. This corrosion may also be grey or white in color if the…
• 10190933Jan 1, 2014Body and structure, Equipment. Underbody Component Corrosion The following information may be helpful when addressing underbody component corrosion with customers. Some customers may comment that one or more of their vehicle's underbody components are showing some form of corrosion. This corrosion may be red in appearance (rust) if the component is steel, forged iron or cast iron. This corrosion may also be grey or white in color if the…
• 10133103Dec 16, 2013Back-over prevention (rear camera). This informational bulletin provides directions on submitting different PIRs

← All problems reported for the 2012 Cadillac Escalade