2016 Chevrolet Equinox Technical Service Bulletins

1,245 technical service bulletins (TSBs) are on record for the 2016 Chevrolet Equinox. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10165879Sep 6, 2019Engine cooling. This Preliminary information communicates the repair recommendations for misfire in HFV6 re-manufactured engines.
• 10165877Sep 6, 2019Electrical system. This Preliminary Information communication provides information to the technician that General Motors Technical Assistance Center may ask for Global Diagnostic System 2 Session Log. Technician will need use Global Diagnostic System 2 to send the session logs to General Motors Technical Assistance Center for further assistance on the vehicle in question.
• 10165874Sep 5, 2019Equipment. This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts/kits. Technicians should refer to Service Information for information regarding most accessories. Technicians may also contact PARTECH and/or the Techline Customer Support Center for additional support.
• 10166645Sep 3, 2019Engine cooling. This technical bulletin provides a procedure on diagnosing and repair moisture/ice and possibly contamination/debris in the SAI system and how to clean it out.
• 10166625Sep 3, 2019Electrical system. This diagnostic tip advises the tech to check if the upstream O2 sensor has been replaced with a faulty or aftermarket sensor and how to verify if the sensor is the cause of the concern.
• 10165077Aug 28, 2019Electrical system. This Technical Bulletin provides procedures to upgrade a vehicle with the Android Auto feature for 2016 and 2017 Model Year vehicles.
• 10165127Aug 23, 2019Electrical system. This preliminary information bulletin provides information om Service Programming System (SPS) Error Codes E4398, E4399, E4403, M4404, M4413, E4414, E4423, E4491 or E6961).
• 10165087Aug 23, 2019Equipment. This warranty administration bulletin provides policy information, proper labor operation selection and causal part identification for warranty transactions (U.S. Only).
• 10165124Aug 21, 2019Engine cooling. This bulletin provides information on identifying Non-GM Engine Calibrations for Gasoline Engines using the Tech 2 or GDS 2.
• 10165126Aug 19, 2019Equipment. This bulleting provides Wiring, Terminal and Connector Repair Information including how to determine the Service Part Number in eSI and how to locate the part(s) in the EPC.
• 10165121Aug 15, 2019Engine cooling. This informational bulletin provides information on replacing the intake manifold when the engine is replaced after severe internal engine damage.
• 10165122Aug 13, 2019Engine cooling. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement.
• 10165123Aug 12, 2019Transmission and drivetrain. This informational bulletin provides information on Some vehicles may rock or move slightly forward or rearward while in Park at start up after cold soak. This condition may be accompanied by a clunk noise. This is a slight movement that is more often seen visually, rather than felt, when viewed from the outside and using the auto-start feature, if equipped.
• 10165079Aug 5, 2019Steering. This technical bulletin provides a procedure inspecting for excess grease or Sealant on the Exterior of the steering gear due to seeing grease or sealant on certain locations on the gear.
• 10164741Aug 2, 2019Equipment. This preliminary information was released to point out a potential issue with a lack of A/C cooling due to an evaporator freeze up concern .
• 10163686Jul 30, 2019Equipment. This Preliminary information communicates additional information on how a LIN bus operates and diagnostic tips when working on a LIN bus.
• 10163900Jul 26, 2019Equipment. This informational bulletin provides process information for the (GWM) and (WPC) parts return program.
• 10163665Jul 16, 2019Wheels, Vehicle speed control. This Preliminary information communicates direction and examples when diagnosing multiple DTCs, one of which includes U**** Byte 71 DTC.
• 10163659Jul 10, 2019Equipment. This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts/kits. Technicians should refer to Service Information for information regarding most accessories. Technicians may also contact Partech and/or the Techline Customer Support Center for additional support.
• 10163658Jul 9, 2019Engine cooling. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have oil mixed in with the engine coolant. Technician will need to inspect the oil cooler if equipped for possible leaking into the cooling system through the radiator. If no issue found replace the engine as well as all rubber coolant hoses.
• 10163272Jun 26, 2019Equipment. The intent of this technical bulletin is to identify aftermarket ALDL or DLC interface devices as potential sources for causing multiple customer concerns that do not have other diagnostic methods to identify them.
• 10163270Jun 26, 2019Steering. This technical bulletin provides a procedure to flush and bleed power steering system to correct a power steering noise or fluid leak concern that is caused during extremely low temperatures.
• 10163268Jun 26, 2019Equipment, Electrical system. This bulletin provides information for electrical ground repairs using new General Motors replacement fasteners with conductive finish.
• 10163261Jun 26, 2019Fuel system. This bulletin provides information on the TOP TIER Detergent Gasoline Licensed Brands and the TOP TIER Diesel Fuel Licensed Brands that are recommended for use in all GM vehicles and the TOP TIER FUELS website URL.
• 10163266Jun 25, 2019Equipment, Engine. This informational bulletin provides information on identifying Non-GM Engine Calibrations for Gasoline Engines using the Tech 2 or GDS 2.
• 10163260Jun 25, 2019Equipment. This informational bulletin advises about the possible issues that may occur when using a scotch brite pad or highly abrasive disk on gasket sealing surfaces or reused parts.
• 10163193Jun 25, 2019Equipment. This bulletin provides information on Engine Concerns that could result from lack of scheduled maintenance, improper service or aftermarket calibrations.
• 10162154Jun 24, 2019Engine cooling. This Preliminary information communicates the identification process for High Feature V6 camshafts in re-manufactured engines.
• 10162148Jun 24, 2019Visibility (wipers, defrost, mirrors). This Preliminary Information communication provides information to the technician about vehicles that have may a helicopter type noise when a rear window is lowered. This is a normal characteristic of this vehicle, but the concern can be minimized by lowering a front door glass approximately 1 to 2 inches.
• 10162138Jun 18, 2019Fuel system. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on. Technician will find Diagnostic Trouble Code P2097 or P2099. Technician will need to perform an injector balance or Active Fuel Injector Tester prior to going further. Technician will also need to check for a small leak in the exhaust if published Service…
• 10162124Jun 13, 2019Electrical system. This Preliminary Information communication provides information to the technician about a no start or another concern after swapping an Engine Control Module or other modules from one vehicle to another. The Global Architecture electrical system associated with these vehicles does not allow controller swaps between vehicles.
• 10163263Jun 11, 2019Electrical system, Equipment. This bulletin explains the labor operation numbers used for submitting warranty claims for module reprogramming and not when replacing a module.
• 10163237Jun 10, 2019Engine cooling. This informational bulletin provides information for dealers/technicians and customers on steam/vapor coming from the front grille or radiator area.
• 10163215Jun 6, 2019Transmission and drivetrain. This Bulletin provides guidelines for Dealers Not Required and for Dealers Required to Contact the PQC for engine or transmission assembly replacement and explains the PQC process, GWM Transaction submission, vehicle service record retention and proper handling of assembly returns.
• 10162106Jun 3, 2019Electrical system. This Preliminary Information communication provides information to the technician about the use of J-35616-64B terminal test probe, replacement terminals, and terminated leads. The J-35616-64B is the latest test probe released for checking tension or probing the .64 series terminals. The test probe terminal has been released in the terminal repair kit (J-38125-620H) located in Lear Tray 7 part number 963716-2.
• 10161046May 28, 2019Equipment. This Preliminary Information communication provides information to the technician that General Motors Technical Assistance Center may ask for Global Diagnostic System 2 Session Log. Technician will need use Global Diagnostic System 2 to send the session logs to General Motors Technical Assistance Center for further assistance on the vehicle in question.
• 10161932May 21, 2019Engine cooling. This informational bulletin advises of a new fuel injection kit used for decarbonizing the intake valves, and explains how toptier fuels should be used to reduce carbon build up.
• 10161968May 20, 2019Transmission and drivetrain. This bulletin provides information on the harmful effects of water or ethylene glycol in transmission fluid.
• 10161906May 9, 2019Tires. This informational bulletin provides information for dealers/technicians on Tire Radial Force Variation (RFV).
• 10161929May 8, 2019Equipment. This warranty administration bulletin provide policy information to cover GM's policy on performing GM covered vehicle services and maintenance on vehicles originating/sold in Canada.
• 10160987May 7, 2019Engine. This Preliminary Information communication provides information to the technician to not remove the torque converter bolts and start the engine as this may cause damage to the torque converter of the crankshaft on vehicles equipped with an automatic transmission.
• 10160986May 7, 2019Engine. This Preliminary information communicates a diagnostic trail to a likely conclusion for lean codes on these vehicles.
• 10160983May 6, 2019Equipment, Engine. This Preliminary Information communication provides information to the technician about finding needle bearings during an oil change. Technician will gain access to the roller rockers to inspect them. Only replace the roller rocker that is missing needle bearings. Be sure to clean the oil drains to retrieve the needle bearings. Each roller rocker has 66 bearings.
• 10161907May 2, 2019Equipment. This informational bulletin provides information for dealers/technicians on Use of Dealer Case Management (DCM) and Being Prepared for Contacting U.S. Technical Assistance (TAC).
• 10160704Apr 30, 2019Engine. This Preliminary Information communication provides information on a rattle, tick, or knock type noise. Any drivability concerns they should be addressed prior to the following diagnostic progression. A sound file or video with sound of the noise needs to be made prior to dis-assembly to help isolate to one area in the engine. There are four different steps to diagnosis the concern. This communication was updated…
• 10160697Apr 29, 2019Visibility (wipers, defrost, mirrors). This Preliminary Information communication provides information to the technician about vehicles that have a blower speed knob only goes to 8 with less than expected high blower speed air flow. Technician should not replace any parts for this concern. Dealer should advise the customer to turn the ECO button Off and On at different blower speed settings 6 through 8 and note the change in the audible sound and air…
• 10160690Apr 24, 2019Fuel system, Engine. This Preliminary information communicates to the dealer an issue where the vehicle's engine may crank over unprompted and not start afterward. This is the result of hooking up the Active Fuel Injector Tool incorrectly on vehicles equipped with a direct fuel injection system. This Preliminary information instructs the dealer of a repair kit they received that will prevent this issue when installed correctly.
• 10160688Apr 24, 2019Equipment, Visibility (wipers, defrost, mirrors). This Preliminary Information communication provides information to the technician about vehicles that have may a helicopter type noise when a rear window is lowered. This is a normal characteristic of this vehicle, but the concern can be minimized by lowering a front door glass approximately 1 to 2 inches.
• 10160682Apr 23, 2019Visibility (wipers, defrost, mirrors). This Preliminary Information communication advises the technician the steps on diagnosing the concern. Customer's sunroof operation intermittent, bind, noise, auto-reverse, and/or water leaks.
• 10160672Apr 16, 2019Equipment. This Preliminary Information communication provides information to the technician about vehicles that the Navigation radio does not have a global positioning system location but OnStar is able to accurately locate the vehicle. Technician should check the installation of the COAX cables to be router correctly. Technician will gain access to the Radio or Human Machine Interface depending on the vehicle build. Install…

← All problems reported for the 2016 Chevrolet Equinox