1995 Chevrolet S10 Recalls
NHTSA lists 5 recall campaigns for the 1995 Chevrolet S10. A recall applies only to vehicles built within the affected range, so check your own VIN at nhtsa.gov/recalls. Repairs for recalls are free at a franchised dealer.
- Service brakes, hydraulic › Antilock/traction control/electronic limited slipCovers: Chevrolet S10 1991–1996, Blazer 1991–1996, GMC Jimmy 1991–1996 +1 more
Reported issue: Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with abs (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the abs system whether the vehicle is in 2-wheel or 4-wheel drive can malfunction causing increased stopping distances during abs stops while in the two-wheel drive mode.
Possible consequence: If this occurred at a time when minimum stopping distance was required, a vehicle crash could occur without prior warning.
Remedy: Dealers will replace or repair the 4-wheel/2-wheel drive switch.
- Visibility › Windshield wiper/washerCovers: Chevrolet S10 1995–1996, Suburban 1994–1996, GMC Suburban 1994–1996 +7 more
Reported issue: Vehicle description: light duty pickup trucks and sport utility vehicles, 2 and 4-wheel drive. Solder joints near the wiring harness connector can crack causing the windshield wipers to work intermittently.
Possible consequence: This condition can result in inoperative wipers, reducing a driver's visibility, and increasing the risk of a vehicle crash.
Remedy: Dealers will replace the wiper motor circuit board and cover.
- Seat beltsCovers: Chevrolet S10 1994–1997, GMC Sonoma 1994–1997, Chevrolet Blazer 1996–1997 +1 more
Reported issue: Vehicle description: extended cab pickup trucks equipped with 60/40 front bench seats and extended cab pickup trucks and 2-door utility vehicles equipped with manual locking recliner bucket seats. The outboard safety belt webbing on the driver's and/or passenger's seat can separate during a frontal impact.
Possible consequence: If a separation occurred and there were secondary crash events or vehicle rollover, there would be no belt restraint of the occupant and increased injuries could occur.
Remedy: Dealers will install a protective cover over the recliner mechanism.
- Steering › Gear box › Shaft sectorCovers: Chevrolet S10 1987–1995
Reported issue: The intermediate steering shaft loosens at the steering shaft to steering gear coupling. With this looseness, the yoke pinch bolt can wear on the splines of the shaft until there is no longer an interference between the splines and the bolt.
Possible consequence: This condition can cause body to chassis movement allowing the steering shaft to separate from the steering gear which can result in a loss of steering control.
Remedy: Dealers will retorque the upper and lower bolts to correct specifications.
- Engine and engine cooling › Cooling system › FanCovers: Chevrolet S10 1995, Blazer 1995, GMC Jimmy 1995 +1 more
Reported issue: Fan blade rivet breakage can occur causing the fan blade to separate from the spider.
Possible consequence: If this occurred while the hood was open, a person working under the hood of the vehicle or in the vicinity of the vehicle could be struck by the fan blade and injured.
Remedy: Dealers will inspect and replace, if necessary, the fan with a newer fan having thicker-headed rivets.
NHTSA investigations
- EA99018Spare tire separation from vehicleClosed · Jun 30, 1999
- PE99004Separation of spare tire from vehicleClosed · Jan 15, 1999
← All problems reported for the 1995 Chevrolet S10
About this data. Data from NHTSA (ODI) complaints, recalls, TSBs and investigations, updated Oct 31, 2026. Complaints are unverified consumer reports and may be duplicated or inaccurate.