2015 Chevrolet Silverado 3500 Technical Service Bulletins

898 technical service bulletins (TSBs) are on record for the 2015 Chevrolet Silverado 3500. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10172883Jan 31, 2020Electrical system, Visibility (wipers, defrost, mirrors). This SKU is a Power Window Regulator and Motor Assembly. The customer communication requested return of unsold inventory to inspect the software. The software may be too sensitive to the position of a locating magnet in the assembly causing the activation of the pinch point threshold prematurely. The window will stay open when it should have closed.
• 10171896Jan 28, 2020Engine. This diagnostic tip provides a procedure to aid in performing a diagnostic test to verify if the camshaft alignment pin has been sheared away to correct a crank/No Start condition.
• 10171264Jan 10, 2020Engine cooling. This Preliminary information communicates to the dealer additional information on checking for the engne crankcase being overfull on oil causing an engine vibration concern. The technician is advised to inspect for contaminnants and adjust the engine oil level as needed.
• 10171899Jan 8, 2020Fuel system. This technical bulletin provides a procedure to replace the fuel tank, sending unit and install a piece of fuel hose to the vent and route down the fuel feed line and secure with zip ties.
• 10171259Jan 7, 2020Transmission and drivetrain, Engine. This Preliminary Information communication provides information to the technician on the steps need to diagnose and repair vehicles that may have stalling shudder and/or hard shifting into 1st gear or reverse vibration on launch (with excessive crankshaft end play). Technician will test to determine if the crank shaft end play is within specification 0.0015?0.0086 inch.
• 10171878Jan 2, 2020Fuel system, Equipment. This informational bulletin advises of a new fuel injection cleaner kit used for decarbonizing the intake valves to correct conditions of rough idle, Crank no start, extended crank or misfire, MIL with DTCs, and explains how Top Tier fuels should be used to reduce carbon build-up.
• 10169355Nov 25, 2019Equipment. This informational bulletin provides information for dealers/technicians on Use of Dealer Case Management (DCM) and Being Prepared for Contacting U.S. Technical Assistance (TAC).
• 10168206Oct 31, 2019Suspension. This technical bulletin provides a procedure to apply grease to the leaf springs to correct a condition of a squeak noise from the metals making contact.
• 10168210Oct 30, 2019Equipment. This informational bulletin provides technicians and dealership personnel with spray-in bed liner general information and repair procedures.
• 10168212Oct 29, 2019Transmission and drivetrain. This informational bulletin provides information on Driveline Clunk Noise and what is acceptable and what is considered normal operations.
• 10168181Oct 28, 2019Electrical system, Equipment. This technical bulletin provides a procedure to replace the radio for vehicles with the condition of Intermittent Pop Noise from the Speakers Followed by a Reset of the Radio and Clock due to a software issue.
• 10168197Oct 17, 2019Fuel system. This informational bulletin explains how to identify possible DEF contamination.
• 10168207Oct 16, 2019Equipment. This informational bulletin provides information for dealers how to submit a product information report (PIR) (Canada Only).
• 10168209Oct 14, 2019Engine cooling. This informational bulletin provides information on Clean Exhaust Filter See Owners Manual Now or Cleaning Exhaust Filter Keep Driving Until Message is Cleared messages Displayed on DIC, DTC P2463 May Be Set.
• 10168175Oct 14, 2019Transmission and drivetrain. This Bulletin provides guidelines for Dealers Not Required and for Dealers Required to Contact the PQC for engine or transmission assembly replacement and explains the PQC process, GWM Transaction submission, vehicle service record retention and proper handling of assembly returns.
• 10168185Oct 11, 2019Electrical system. This technical bulletin provides a procedure for testing the battery cables for voltage drop, Checking for a bad ground at g218, Inspecting for a short at the starter B+ to shield and testing for a faulty battery.
• 10167479Oct 11, 2019Brakes, Engine cooling. N182202780 01 - Special Coverage. Certain Vehicles may have a condition where customers may experience increased brake pedal effort, hardbrake pedal, and/or potentially increased stopping distance. The condition is more prevalent at low speed when softly applyingthe brakes. The engine mounted mechanical vacuum pump outputmay decrease over time decreasing the amount of vacuum/power brake assist. Failure to follow…
• 10168208Oct 9, 2019Equipment. This informational bulletin provides information on key code security and information on GM key code look up applications.
• 10168205Oct 9, 2019Engine cooling. This informational bulletin provides guidelines and diagnostic/repair information to technicians regarding vehicle engine oil consumption.
• 10168215Oct 8, 2019Equipment. This engineering informational bulletin is requesting information on a scraping noise heard from under the vehicle while driving.
• 10168176Oct 8, 2019Transmission and drivetrain. This informational bulletin explains possible normal condition of a flare from 1st to 2nd, even if the trans had been repaired for the flare and its still noticed.
• 10168204Oct 2, 2019Equipment. This informational bulletin provides information on comebacks prevention information and using customer concern verification sheets (CCVS).
• 10168188Oct 2, 2019Equipment. This Warranty Administration bulletin provides information for dealers/Service advisors on when and how to submit a Pre-Repair Authorization (PRA) (US dealers only).
• 10164754Aug 7, 2019Equipment. This preliminary information explains that there are differences between the Elevated Idle, PTO and High Idle options.
• 10163908Jul 24, 2019Engine cooling. This engineering informational bulletin is requesting information for vehicles that has had the fuel injection pump replaced and is still within warranty.
• 10165334Jul 16, 2019Equipment. This SKU is a Tire Hoist Assembly. The customer communication requested return of unsold inventory to inspect for the shape of the centerpiece of the tire hoist being round when it should be square. If the centerpiece is the incorrect shape then the tire hoist cannot be operated with the OE tools, and the end user would therefore not be able to lower the spare tire with the vehicles original tools.
• 10162149Jun 24, 2019Brakes. This Preliminary Information communication advises the technician that the Hydro-Boost is not serviceable and will need to be replaced if the brake pedal moves or applies on its own at a full turn.
• 10162143Jun 19, 2019Engine cooling. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on. Technician will find Diagnostic Trouble Codes P0340 and P0341 setting at times. Technician should use normal published Service Information diagnostics. If normal Service Information diagnostics does not isolate the concern, inspect for corrosion in connector…
• 10162136Jun 17, 2019Fuel system. This Preliminary Information communication provides information to the technician for a vehicle setting both a P2635 and P018B diagnostic trouble codes. The following steps may help to determine if this is caused by a fuel pressure sensor not reading the low end of the pressure range. Technician is to make sure the engine is cold and install the Multiple Diagnostic Interface along with Global Diagnostic System 2.
• 10162127Jun 14, 2019Suspension. This Preliminary Information communication provides information to the technician about vehicle with Service ABS and/or Traction control lights/message on, Service Power Steering System, Service Suspension System, and or Loss of communication with EBCM, SWPS, PSCM, and/or SCM. Technician may find Diagnostic Trouble Codes U0077, U0121, U0126, U0131, U0139, U0401, U0415, and/or U0428. Technician should remove the…
• 10162124Jun 13, 2019Electrical system. This Preliminary Information communication provides information to the technician about a no start or another concern after swapping an Engine Control Module or other modules from one vehicle to another. The Global Architecture electrical system associated with these vehicles does not allow controller swaps between vehicles.
• 10162108Jun 4, 2019Transmission and drivetrain. This Preliminary Information communication provides information to the technician about vehicles that are equipped with 6L80 Regular Production Option Code (MYC), 6L90 Regular Production Option Code (MYD) or 8L90 Regular Production Option Code (M5U) Automatic Transmission, now have Powertrain Grade Braking. Powertrain grade braking assists when driving on a downhill grade to help maintain desired vehicle speed by…
• 10162106Jun 3, 2019Electrical system. This Preliminary Information communication provides information to the technician about the use of J-35616-64B terminal test probe, replacement terminals, and terminated leads. The J-35616-64B is the latest test probe released for checking tension or probing the .64 series terminals. The test probe terminal has been released in the terminal repair kit (J-38125-620H) located in Lear Tray 7 part number 963716-2.
• 10161026May 17, 2019Fuel system. This Preliminary information communicates the location that dealers can find information to remove / delete the rear fuel tank from Chassis Cab trucks with RPO N2N dual fuel tanks.
• 10161929May 8, 2019Equipment. This warranty administration bulletin provide policy information to cover GM's policy on performing GM covered vehicle services and maintenance on vehicles originating/sold in Canada.
• 10161907May 2, 2019Equipment. This informational bulletin provides information for dealers/technicians on Use of Dealer Case Management (DCM) and Being Prepared for Contacting U.S. Technical Assistance (TAC).
• 10160682Apr 23, 2019Visibility (wipers, defrost, mirrors). This Preliminary Information communication advises the technician the steps on diagnosing the concern. Customer's sunroof operation intermittent, bind, noise, auto-reverse, and/or water leaks.
• 10165330Apr 9, 2019Equipment. This SKU is a Pitman Arm. The customer communication requested return of unsold inventory to inspect for incorrect taper of the spline. Incorrect taper of the spline prevents it from installing with the mating component, preventing installation of the part, and would therefore have no impact on the end user besides time required to complete installation.
• 10160642Apr 8, 2019Electrical system. This Preliminary Information communication provides information to the technician about vehicles that have a low voltage reading on the volt gauge during the first several minutes after a cold start. Dealer should communicate to the customer this condition is a normal operating characteristic of their vehicle.
• 10158864Mar 26, 2019Equipment. This warranty administration bulletin provides information on Dealer Empowerment Labor Operations and Customer Enthusiasm.
• 10158861Mar 22, 2019Equipment, Electrical system. This informational bulletin provides information for the IPC odometer programming method quick reference guide.
• 10154323Feb 25, 2019Wheels. This Preliminary Information communication provides information to the technician about vehicles that have a vibration at highway speed. Technician will need to replace the wheel for a rolled lip of aluminum in the hub opening.
• 10154322Feb 25, 2019Back-over prevention (rear camera). This Preliminary information communicates repair information for the rear vision camera or surround vision camera image being: - Yellow - Blurry - Distorted - Image scrolling - Image with NO gridlines - Screen is blue with gridlines - Screen is blue with Service Rear Vision System message
• 10154317Feb 22, 2019Transmission and drivetrain. This Preliminary Information communication provides information to the technician to refer to bulletin 16-NA-175 to aid in addressing torque converter clutch shudder concerns.
• 10154312Feb 21, 2019Transmission and drivetrain. This Preliminary Information communication provides information to the technician that a whine noise heard from the automatic transmission fluid pan hear with the the key on and engine off, or for up to one minute after the vehicle has been shut off should be deemed a normal characteristic.
• 10154310Feb 20, 2019Equipment. This Preliminary information communicates Content Theft Deterrent RPO UTJ is included and only available with Remote Vehicle Start RPO BTV. If the vehicle is not equipped with Remote Vehicle Start RPO BTV the vehicle will not have Content Theft Deterrent.
• 10154306Feb 19, 2019Engine cooling. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components. That any of the listed DTC's may set with or without poor engine performance.
• 10154301Feb 18, 2019Other or unknown, Electrical system. This Preliminary Information communication provides information to the technician that a customer may request the factory Integrated Trailer Brake Control be bypassed and their aftermarket trailer brake controller be installed instead. Technician will need to gain access to the body harness. Install trailer brake controller harness General Motors part number 23184088 into Middle Bus Electrical Center (X61A).
• 10154299Feb 18, 2019Engine cooling. This Preliminary information communicates information that will need to be provided to TAC to aid in diagnosing if a vehicle comes in with misfire and DTC Codes P0300 - P0308 and/or P050D
• 10154298Feb 15, 2019Electrical system. This Preliminary Information communication provides information to the technician with the correct way to remove the front shock electrical connector terminals. Technician will need to slightly bend the end of the J-38125-12A release tool. There is a purple Terminal Position Assurance that will align itself in the release position when the release tool is inserted into the release hole.

← All problems reported for the 2015 Chevrolet Silverado 3500