2019 Chevrolet Tahoe Technical Service Bulletins

965 technical service bulletins (TSBs) are on record for the 2019 Chevrolet Tahoe. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10167461Oct 25, 2019Vehicle speed control. This Preliminary Information communication provides information to the technician about vehicles that have a detent / click with a feel of increased resistance when the accelerator pedal is about ¾ of the way. The new accelerator pedal design has a built-in detent position near the last 1/4 of pedal travel. Dealer should communicate to the customer this is a normal operating characteristic of the vehicle and no…
• 10167460Oct 25, 2019Lane departure. This Preliminary Information communication provides information to the technician about vehicles that may have Service Front Camera, Service Lane Departure Warning, and Service Lane Keep Assist Message. Technician may find Diagnostic Trouble Code B1008 Sym 4B set. Technician will need to check the windshield to ensure it is not aftermarket. Technician will also check for anything that may impair the front view…
• 10167459Oct 25, 2019Engine cooling. This Preliminary Information communication provides information to the technician on the steps needed to diagnose and repair vehicles that may have a rattle noise from the dash. Technician will need to inspect for the rear heater pipes contacting the passenger side exhaust manifold. If the rear heater pipe is found to be contacting the exhaust manifold, reposition the heater pipe so it no longer makes contact.
• 10168207Oct 16, 2019Equipment. This informational bulletin provides information for dealers how to submit a product information report (PIR) (Canada Only).
• 10167442Oct 15, 2019Electrical system. This Preliminary information communicates if the liftglass will not open using keyless entry to verify Valet Mode is not enabled.
• 10167439Oct 15, 2019Electrical system. This Preliminary Information communication provides information to the technician on how the radio display gets the air ambient temperature. On 1500 series trucks and all sport utility vehicle with regular production option code IO3 radio the ambient air temperature sensor is hard wired to the engine control module and then the signal goes on high speed local area network to the body control module from there on…
• 10168175Oct 14, 2019Transmission and drivetrain. This Bulletin provides guidelines for Dealers Not Required and for Dealers Required to Contact the PQC for engine or transmission assembly replacement and explains the PQC process, GWM Transaction submission, vehicle service record retention and proper handling of assembly returns.
• 10168185Oct 11, 2019Electrical system. This technical bulletin provides a procedure for testing the battery cables for voltage drop, Checking for a bad ground at g218, Inspecting for a short at the starter B+ to shield and testing for a faulty battery.
• 10168186Oct 10, 2019Equipment. This informational bulletin provides information for dealers/technicians on the process to disable and enable passive unlocking.
• 10168208Oct 9, 2019Equipment. This informational bulletin provides information on key code security and information on GM key code look up applications.
• 10168205Oct 9, 2019Engine cooling. This informational bulletin provides guidelines and diagnostic/repair information to technicians regarding vehicle engine oil consumption.
• 10168214Oct 8, 2019Other or unknown. This preliminary bulletin provides a procedure to reprogram more than 8 keys for the PPV.
• 10167426Oct 3, 2019Electrical system. This Preliminary Information communication provides information and definitions to the technician about vehicles that have fishbite, chuggle, misfire, AFM disturbances or torque converter shudder/vibration concerns. Technician are advised to use PICO software to determine root cause of the concern. If torque converter shudder is confirmed technicians are referred to Torque Converter Diagnosis in SI.
• 10167425Oct 3, 2019Forward collision avoidance. This Preliminary information communicates a "Forward Collision System Reduced" message displayed on the DIC when the Forward Automatic Braking has been set to the "Alert" setting. This is normal when the FAB has been set to "Alert".
• 10168204Oct 2, 2019Equipment. This informational bulletin provides information on comebacks prevention information and using customer concern verification sheets (CCVS).
• 10168188Oct 2, 2019Equipment. This Warranty Administration bulletin provides information for dealers/Service advisors on when and how to submit a Pre-Repair Authorization (PRA) (US dealers only).
• 10165920Sep 30, 2019Body and structure. This Preliminary Information communication provides information to the technician about vehicles with erratic or hesitation when opening and closing the power liftgate. There may be a diagnostic trouble code B153A set in the power liftgate module. This concern could occur if the left liftgate actuator is internally coming apart. The actuator will need to be replaced however care must be taken when removing the…
• 10165914Sep 30, 2019Engine cooling. This Preliminary Information communication provides information to the technician on how to diagnose and repair vehicles that may have Diagnostic Trouble Code P06DD or no or low oil pressure. Technician will replace timing chain tensioner guide. If oil pump face is damaged and or worn thru replace oil pump. Inspect bearings for damage wear due to debris from oil pump.
• 10165905Sep 26, 2019Body and structure. This Preliminary information communicates and issue with the hood ajar message being displayed when the hood is not ajar. Inspect the body ground strap to insure it is connected in the proper locations and the strap eyelets are tight and do not rotate.
• 10165904Sep 25, 2019Electrical system. This Preliminary Information communication provides information to the technician about a no start or another concern after swapping an Engine Control Module or other modules from one vehicle to another. The Global Architecture electrical system associated with these vehicles does not allow controller swaps between vehicles.
• 10165902Sep 24, 2019Engine cooling. This Preliminary information communicates A vehicle may have a tick noise from the engine cold, initial start in the morning. A lifter may not have sufficient amount of oil during cold start operation (not pumped up). As information comes in the Pi will be updated and when the final repair is out this this PI will be changed to a Bulletin
• 10166243Sep 19, 2019Brakes. N182206730 01 - Customer Satisfaction Program - Certain vehicles equipped with special service package (RPO 5W4) and certain 2018 ?
• 10166638Sep 18, 2019Equipment. This warranty administration bulletin provides information regarding the field action courtesy transportation policy.
• 10166240Sep 17, 2019Equipment, Engine cooling. N192257100 - EM - General Motors has decided to conduct a voluntary emissions recall involving certain 2019 Chevrolet Silverado, Suburban, Tahoe and GMC Sierra vehicles equipped with a performance air intake system. The required Vehicle Emission Control Information (VECI) label may not have been installed. Since a new label can be easily installed, and to reduce customer inconvenience, the label will be sent…
• 10166640Sep 11, 2019Engine cooling. This technical bulletin provides a procedure to measure vibration and install engine mounts to correct a Rough Idle in Drive concern.
• 10165870Sep 5, 2019Engine cooling. This Preliminary Information communication advises the technician with a tip when the vehicle stops running after it has been idling for 2.5 hours. This is normal operation of the vehicle built with regular production code BTM and without Regular Production Option Code AVF. If the vehicle was built with regular production code BTM and AVF only has a 1 hour idle time.
• 10165868Sep 5, 2019Forward collision avoidance. This Preliminary information communicates a "Forward Collision System Reduced" message displayed on the DIC when the Forward Automatic Braking has been set to the "Alert" setting. This is normal when the FAB has been set to "Alert".
• 10165865Sep 4, 2019Steering. This Preliminary Information communication provides information to the technician with additional information on the functionality of Lane Keep Assist. Starting with 2016 model year Lane Keep Assist Regular Production Option Code (UHX) replaced Lane Departure Warning Regular Production Option Code (UFL). Lane Keep Assist is designed to assist the driver in keeping the vehicle from drifting out of a driving lane…
• 10165120Aug 30, 2019Equipment. This technical bulletin provides repair information to correct a customer concern of Phone Charging Cycles On and Off When Connected to the Single Port USB Hub.
• 10164789Aug 29, 2019Engine cooling. This Preliminary Information communication provides information to the technician on how to diagnose and repair vehicles that may have Diagnostic Trouble Code P06DD or no or low oil pressure. Technician will replace timing chain tensioner guide. If oil pump face is damaged and or worn thru replace oil pump. Inspect bearings for damage wear due to debris from oil pump.
• 10165127Aug 23, 2019Electrical system. This preliminary information bulletin provides information om Service Programming System (SPS) Error Codes E4398, E4399, E4403, M4404, M4413, E4414, E4423, E4491 or E6961).
• 10165087Aug 23, 2019Equipment. This warranty administration bulletin provides policy information, proper labor operation selection and causal part identification for warranty transactions (U.S. Only).
• 10165124Aug 21, 2019Engine cooling. This bulletin provides information on identifying Non-GM Engine Calibrations for Gasoline Engines using the Tech 2 or GDS 2.
• 10165126Aug 19, 2019Equipment. This bulleting provides Wiring, Terminal and Connector Repair Information including how to determine the Service Part Number in eSI and how to locate the part(s) in the EPC.
• 10165121Aug 15, 2019Engine cooling. This informational bulletin provides information on replacing the intake manifold when the engine is replaced after severe internal engine damage.
• 10165122Aug 13, 2019Engine cooling. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement.
• 10165114Aug 13, 2019Equipment. This informational bulletin provides information for dealers/technicians on Mandatory VECI Label Replacement for (5W7) Performance Air Intake Kits.
• 10165440Aug 12, 2019Brakes. N182206730 - Customer Satisfaction Program. Certain vehicles equipped with special service package (RPO 5W4) and certain 2015 ?
• 10165123Aug 12, 2019Transmission and drivetrain. This informational bulletin provides information on Some vehicles may rock or move slightly forward or rearward while in Park at start up after cold soak. This condition may be accompanied by a clunk noise. This is a slight movement that is more often seen visually, rather than felt, when viewed from the outside and using the auto-start feature, if equipped.
• 10164758Aug 9, 2019Transmission and drivetrain. This Preliminary information communicates to the dealer technician that the torque converters for the 10L80 and 10L90 10 speed transmission are on restriction through the Product Quality Center. Dealers are advised to contact the Product Quality Center if diagnostics has lead to replacement of the transmission torque converter.
• 10164757Aug 8, 2019Steering, Visibility (wipers, defrost, mirrors), Electrical system. This Preliminary Information communication provides information to the technician about vehicles that may have any of these concerns remote keyless entry, passive Entry and Start Inoperative, No Fob detect message on driver information center, service tire pressure system, no audio, touch screen Inoperative, Steering Wheel Controls Inoperative, Service Stabilitrak, rear power windows inoperative, rear wiper…
• 10164756Aug 8, 2019Forward collision avoidance, Electrical system, Equipment. This Preliminary information communicates a Service Adaptive Cruise With DTC C018C SYM3A After Replacing K14 Distance Sensing Cruise Control Module and provides tips for completing all necessary steps and to contact TCSC if configuration does not complete correctly.
• 10165104Aug 7, 2019Transmission and drivetrain. This technical bulletin provides a procedure to replace the torque converter and inspect the front pump and the TEHCM for metal.
• 10164749Aug 7, 2019Visibility (wipers, defrost, mirrors). This Preliminary Information communication provides the technician with steps to resolve the issue of an oily substance that may be found on the inside windshield surface, and appears to be leaking from the rear view mirror area. Technician will remove the moisture sensor and clean the glass and mounting bracket with alcohol wipe. If the gel separates from the sensor the sensor will need to be replaced.
• 10165097Aug 6, 2019Electrical system. This technical bulletin provides repair information to correct a customer concern of add-on equipment inoperative, melted terminals on auxiliary relay, new auxiliary battery relay for Police Tahoe Vehicles.
• 10165079Aug 5, 2019Steering. This technical bulletin provides a procedure inspecting for excess grease or Sealant on the Exterior of the steering gear due to seeing grease or sealant on certain locations on the gear.
• 10163690Jul 31, 2019Equipment. This Preliminary information communicates AFM / DFM usage Information. providing additional information on the AFM and DFM systems
• 10164113Jul 30, 2019Electrical system, Equipment. This informational bulletin provides information for dealers/technicians on Information on Head-Up Display (HUD) on Vehicles Model Year 2017 and Newer Has Rotational Feature that Allows for Adjusting of the Angle of the HUD Image.
• 10163684Jul 29, 2019Electrical system. This Preliminary Information communication advises the technician with a tip when the vehicle stops running after it has been idling for 2.5 hours. This is normal operation of the vehicle built with regular production code BTM and without Regular Production Option Code AVF. If the vehicle was built with regular production code BTM and AVF only has a 1 hour idle time.
• 10163682Jul 29, 2019Transmission and drivetrain. This Preliminary information communicates to the dealer technician that the 10L90 and 10L80 transmissions part restriction has ended.

← All problems reported for the 2019 Chevrolet Tahoe