1990 Dodge Dynasty Recalls

NHTSA lists 5 recall campaigns for the 1990 Dodge Dynasty. A recall applies only to vehicles built within the affected range, so check your own VIN at nhtsa.gov/recalls. Repairs for recalls are free at a franchised dealer.

• 96V099000Jun 13, 1996321,000 vehicles potentially affected
  Service brakes, hydraulic › Antilock/traction control/electronic limited slip
  Covers: Dodge Dynasty 1990–1993, Chrysler NEW Yorker 1990–1993, Imperial 1990–1993 +7 more

  Reported issue: The abs hydraulic control unit can experience excessive brake actuator piston seal wear causing pump-motor deterioration.

  Possible consequence: If this condition occurs, the abs function could be lost and reduced power assist would be experienced during vehicle braking increasing the potential for a vehicle accident.

  Remedy: Dealers will test the vehicle's anti-lock brake system and repair the vehicles if necessary. Also the warranty on all abs components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will also be…

  Full campaign details →

• 91V191000Nov 1, 199180,000 vehicles potentially affected
  Service brakes, hydraulic › Foundation components › Hoses, lines/piping, and fittings
  Covers: Dodge Dynasty 1990–1991, Chrysler NEW Yorker 1990–1991, Imperial 1990–1991 +5 more

  Reported issue: The anti-lock brake system high pressure hose may leak or detach at its crimped end fitting resulting in the discharge of hydraulic fluid.

  Possible consequence: Fluid discharge eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.

  Remedy: Replace the abs high pressure hose with a hose of different design and construction.

  Full campaign details →

• 91V004000Oct 2, 1991125,000 vehicles potentially affected
  Visibility › Defroster/defogger/hvac system › Fan/motor
  Covers: Dodge Dynasty 1990–1991, Chrysler NEW Yorker 1990–1991, Fifth Avenue 1991

  Reported issue: Water leaking under windshield cowl in area above heater blower motor resistor block results in corrosion of the resistor terminals.

  Possible consequence: Corrosion of the resistor terminals increases electricalresistance, leading to overheating and possble ignition of the wiring connectorsand insulation, causing a fire in the cowl area.

  Remedy: The blower motor resistor block will be replaced, and a mastic patch applied to seal the cowl against water entry. Damaged wire connectors will be replaced.

  Full campaign details →

• 90V080000Apr 25, 1990257 vehicles potentially affected
  Air bags › Frontal › Sensor/control module-inactive
  Covers: Dodge Dynasty 1990, Chrysler Lebaron 1990, Dodge Daytona 1990 +2 more

  Reported issue: Air bag inflator modules may not contain diffuser holes between the ignitor and propellant chambers.

  Possible consequence: Air bags would not deploy in an impact situation, which could lead to driver injury.

  Remedy: Replace air bag inflator modules with properly machined modules.

  Full campaign details →

• 89V237000Dec 27, 1989634,000 vehicles potentially affected
  Engine and engine cooling › Engine
  Covers: Dodge Dynasty 1989–1990, Plymouth Voyager 1989–1990, Dodge Shadow 1989–1990 +12 more

  Reported issue: The engine valve cover gasket may dislocate and allow an engine oil leak at the gasket.

  Possible consequence: The leakage of oil in the engine compartment could causea fire.

  Remedy: Replace gasket cover with revised cover, and rtv sealant will be applied in place of a gasket.

  Full campaign details →

← All problems reported for the 1990 Dodge Dynasty