1989 Dodge Raider Recalls

NHTSA lists 2 recall campaigns for the 1989 Dodge Raider. A recall applies only to vehicles built within the affected range, so check your own VIN at nhtsa.gov/recalls. Repairs for recalls are free at a franchised dealer.

• 95V103003May 24, 1995920,000 vehicles potentially affected
  Seat belts › Front › Buckle assembly
  Covers: Dodge Raider 1987–1989, Colt 1986–1991, RAM 50 1986–1991 +7 more

  Reported issue: The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." if a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.

  Possible consequence: The safety belts would not provide adequate protection to an occupant in a vehicle crash.

  Remedy: Owners should promptly check the condition and operation of both front safety belt buckles and carefully inspect the red release button for any breaks or cracks. They should ensure that both buckles are operating properly by inserting each latch plate into its buckle, tugging on the belt to make sure the latch is…

  Full campaign details →

• 89V027000Feb 28, 19894,300 vehicles potentially affected
  Vehicle speed control
  Covers: Dodge Raider 1989

  Reported issue: Throttle blade icing may occur during extended highway driving at temperatures below 10 degrees f.

  Possible consequence: Ice formation can prevent throttle blade from closingto the idle postion when the accelerator pedal is released, creating apotential for loss of control, which could result in an accident.

  Remedy: Install anchor plate under base of throttle; heated engine coolant will be flowed through an adapter plate to eliminate ice formation on the throttle blade.

  Full campaign details →

← All problems reported for the 1989 Dodge Raider