1996 Dodge RAM Recalls
NHTSA lists 10 recall campaigns for the 1996 Dodge RAM. A recall applies only to vehicles built within the affected range, so check your own VIN at nhtsa.gov/recalls. Repairs for recalls are free at a franchised dealer.
- Vehicle speed controlCovers: Dodge RAM 1994–1996
Reported issue: Vehicle description: pickup trucks equipped with diesel engines. The throttle cable could unravel (fray) or break resulting in loss of throttle control.
Possible consequence: A throttle that does not return to idle could result in unexpected acceleration, increasing the risk of a crash.
Remedy: Dealers will inspect and replace the throttle cable and upper bell crank lever. Owner notification began august 3, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact daimlerchrysler at 1-800-853-1403.
- Latches/locks/linkages › Hood › LatchCovers: Dodge RAM 1994–1999
Reported issue: On certain pickup trucks originally sold in or currently registered in the following "salt belt" states: maine, new hampshire, vermont, massachusetts, rhode island, connecticut, new york, new jersey, pennsylvania, delaware, maryland, the district of columbia, west virginia, ohio, indiana, michigan, illinois, wisconsin, minnesota, iowa, and missouri. Corrosion of the return spring on the hood secondary latch could…
Possible consequence: If the primary latch is not engaged, the hood could open unexpectedly.
Remedy: Dealers will replace the secondary hood latch. Owner notification began september 17, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact daimlerchrysler at 1-800-853-1403.
- Electrical system › Ignition › SwitchCovers: Dodge RAM 1994–1996
Reported issue: Vehicle description: light duty pickup trucks. The affected vehicles were built with an ignition switch and wiring that could overheat. High electrical current loads pass through the switch when the blower motor is operated on high for an extended periods of time.
Possible consequence: This could cause the ignition switch and wiring to overheat.
Remedy: Dealers will install a relay and overlay harness.
- Power train › Clutch assemblyCovers: Dodge RAM 1994–1999
Reported issue: Vehicle description: pickup trucks equipped with manual transmission, v10 engines and four-wheel-drive transfer cases. Under sustained maximum rated vehicle load, while driving up a steep grade in four-wheel-drive low range in hot ambient conditions, the local exhaust temperature proximate to the hydraulic clutch line can generate line temperatures that exceed the temperature limit of the clutch line material. If…
Possible consequence: The fluid could ignite on the hot exhaust possibly resulting in a vehicle fire.
Remedy: Dealers will replace the hydraulic clutch assembly.
- Air bags › FrontalCovers: Dodge RAM 1995–1997
Reported issue: Vehicle description: van and wagon model passenger vehicles. If water/road salt gets on the interior floor of the vehicle in the proximity of the air bag electronic control module (aecm), the aecm can corrode. The resulting corrosion can cause the driver side air bag to deploy inadvertently.
Possible consequence: Deployment of the air bag without warning could cause a driver to lose vehicle control, increasing the risk of a crash and personal injury.
Remedy: Dealers wil replace the aecm with an aecm that is sealed from moisture intrusion.
- Fuel system, gasoline › Delivery › Hoses, lines/piping, and fittingsCovers: Dodge RAM 1994–1996
Reported issue: Vehicle description: light duty pickup trucks equipped with gasoline engines. The fuel tank mounted rollover valve can allow liquid fuel to leak onto the ground under certain vehicle operating conditions.
Possible consequence: Fuel leakage could result in a fire if an ignition source was present.
Remedy: Dealers will replace the fuel tank rollover valve with a float type rollover valve.
- Power train › Automatic transmission › Cooling unit and linesCovers: Dodge RAM 1994–1997
Reported issue: Under certain high load operating conditions, the transmission fluid temperature can exceed the melting point of the material used in the connector to retain the fluid line to the transmission.
Possible consequence: When these temperatures occur, the fluid line will not stay connected with the transmission and fluid can spray onto the exhaust manifold, resulting in smoke or fire.
Remedy: Dealers will replace the high temperature side of the transmission fluid cooler line connector fittings with connectors that incorporate a stainless steel retainer.
- Service brakes, hydraulic › Power assist › Vacuum › Hoses, lines/piping, and fittingsCovers: Dodge RAM 1995–1996
Reported issue: Vehicle description: pickup trucks equipped with diesel engines. The engine driven vacuum pump can allow engine oil into the vacuum hoses due to the absence of an internal check valve. The oil can cause the hose to deteriorate and partially collapse, reducing the vacuum supply to the brake booster.
Possible consequence: Reduced power brake assist can result increasing the risk of a vehicle crash.
Remedy: Dealers will add a vacuum pump check valve to the vacuum pump. In addition, the vacuum hose connected to the vacuum pump will be replaced with a hose that is engine oil resistant.
- Equipment › Other › LabelsCovers: Dodge RAM 1996
Reported issue: The involved vehicles have tire/wheel specification information on the vehicle certification label which indicates a smaller size tire than required. This does not comply with label requirements of fmvss no. 120, "tire selection and rims for motor vehicles other than passenger cars."
Possible consequence: Consequence of non-compliance: the smaller tires would not have sufficient load capacity for the vehicles specified gross weight rating, increasing the potential for a premature tire failure and an accident.
Remedy: Owners will be mailed an overlay label with the correct tire/wheel certification information and instructions for installing the label on their vehicles. If owners prefer, their dealer can install the label for them.
- Electrical system › Alternator/generator/regulatorCovers: Dodge RAM 1996
Reported issue: The fasteners which secure the generator cartridge fuse to the power distribution center may have an improper clamp load. Improper clamping can result in arcing at the connection.
Possible consequence: This condition can potentially cause a fire in the engine compartment.
Remedy: Dealers will tighten the generator cartridge fuse fasteners properly.
NHTSA investigations
- RQ00012HOOD LATCHClosed · May 3, 2000
- DP00002Steering column fireClosed · Jan 20, 2000
- EA99027Steering column firesClosed · Sep 10, 1999
- PE99031Ignition switchClosed · May 5, 1999
- RQ98002Transmission quick connectorsOpen · Mar 10, 1998
- EA98005Clutch hydraulic lineClosed · Feb 27, 1998
- PE97043Clutch hydraulic line failureClosed · Oct 20, 1997
- PE96070Transmission fluid firesClosed · Nov 26, 1996
← All problems reported for the 1996 Dodge RAM
About this data. Data from NHTSA (ODI) complaints, recalls, TSBs and investigations, updated Oct 29, 2026. Complaints are unverified consumer reports and may be duplicated or inaccurate.