1993 Eagle Summit Recalls

NHTSA lists 3 recall campaigns for the 1993 Eagle Summit. A recall applies only to vehicles built within the affected range, so check your own VIN at nhtsa.gov/recalls. Repairs for recalls are free at a franchised dealer.

• 98V168003Oct 5, 19986,198 vehicles potentially affected
  Power train › Automatic transmission
  Covers: Eagle Summit 1992–1996, Plymouth Colt 1992–1994

  Reported issue: Vehicle description: all wheel drive passenger vehicles. Lockup of the transfer case can occur due to insufficient lubrication.

  Possible consequence: This condition can cause a loss of vehicle control, increasing the risk of a crash.

  Remedy: Dealers will inspect the vehicles for adequacy of the transfer case oil volume, transfer case oil leakage, and operational degradation of the transfer case mechanism. If oil volume is insufficient, the appropriate amount of oil will be added. If there is transfer case oil leakage, affected components will be…

  Full campaign details →

• 97V063002May 12, 199746,000 vehicles potentially affected
  Latches/locks/linkages › Doors › Latch
  Covers: Eagle Summit 1992–1993, Plymouth Colt 1992–1993, Dodge Colt 1992–1993

  Reported issue: Excess lubrication can cause the rubber door latch switch cover to deform, and the door latch switch to malfunction, so that the shoulder belt anchorage would remain at the a-pillar when the door was closed.

  Possible consequence: In the event of a crash, the seat occupant may not be properly restrained.

  Remedy: Dealers will replace the door latch switch with a switch that utilizes reduced lubricating grease, improved contact surface, and a different rubber isolation boot.

  Full campaign details →

• 97V073002May 12, 199724,000 vehicles potentially affected
  Seat belts › Front › Anchorage
  Covers: Eagle Summit 1992–1993, Plymouth Colt 1992–1993, Dodge Colt 1992–1993

  Reported issue: The guide rail on the driver's side contains a covered cable and also an angled belt guide at the top end of the webbing. The combination of these factors can lead, over time, to the cable's movement exerting abrading force to the lower edges of the cable's chamber, sufficient to cause the cable to drop out of the chamber with the shoulder belt anchorage becoming stuck.

  Possible consequence: In the event of a crash, the seat occupant may not be properly restrained.

  Remedy: Dealers will install a new replacement guide rail that incorporates a double lip dust seal and an anodic oxide coating.

  Full campaign details →

← All problems reported for the 1993 Eagle Summit