2001 GMC Sierra 3500 Technical Service Bulletins

143 technical service bulletins (TSBs) are on record for the 2001 GMC Sierra 3500. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10245951Nov 1, 2014Equipment. Canadian Customers Unable To Place Calls And Turn By Turn Inoperative In The United States.
• 10112251Sep 24, 2014Engine cooling. This Preliminary Information communication provides information to the technician about finding needle bearings during an oil change. Technician will gain access to the roller rockers to inspect them. Only replace the roller rocker that is missing needle bearings. Be sure to clean the oil drains to retrieve the needle bearings. Each roller rocker has 66 bearings.
• 10246647Sep 1, 2014Brakes. Pre-Formed and Pre-Flared Hydraulic Brake Pipe Kits Now Available for Service
• 10112160Aug 8, 2014Equipment. This Preliminary Information communication provides information to the technician about installing General Motors Accessory pats. Technician can check Service Information for some accessories. Technician can also contact Partect for assistance. Technician can also contact Techline Customer Support Center for programming issues.
• 10112144Jul 31, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicle that has no XM audio on certain channels but XM channel info is displayed. Technician will need to contact XM and deactivate and activate the module.
• 10112137Jul 30, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicle that may have an OnStar system that has progression tones when pressing the blue or red button. Technician will need to call General Motors Technical Assistance Center with the scan tool data from the OnStar system.
• 10112116Jul 17, 2014Engine cooling. This Preliminary Information communication provides information to the technician about engine block of possible cylinder bore damage, scoring or out of round as the possible cause of engine oil consumption, misfire, cylinder leakage or blow by. Technician will need to inspect the engine for Cylinder damage or scoring, An out of round cylinder bore, Dirt intrusion, and Catalytic Converter failure.
• 10137833Jul 16, 2014Equipment, Engine cooling. This information bulletin advises of a new tool used to aid in installing Duramax glow plugs.
• 10250012Jul 1, 2014Fuel system, Equipment. Duramax® Diesel Glow Plugs Difficult to Install Due to Carbon Buildup - New Glow Plug Bore Reamer Available
• 10246499Jul 1, 2014Other or unknown, Equipment, Electrical system, Fuel system. Duramax® Diesel Glow Plugs Difficult to Install Due to Carbon Buildup - New Glow Plug Bore Reamer Available
• 10248444Jun 30, 2014Equipment. Vehicle Recalls
• 10125953Jun 16, 2014Equipment. This Preliminary Information communication provides information to the technician on the programming and activation of the OnStar system. For many 2008 and prior model year GM vehicles, the programming is performed using the Tech 2 and the activation is initiated by a Service Programming System.
• 10246952Jun 1, 2014Equipment. Programming And Activation Of Replacement OnStar Modules.
• 10247681Mar 1, 2014Equipment. Information On Requests To Add OnStar Bluetooth Option.
• 10245950Mar 1, 2014Equipment. Canadian Customers Unable To Place Calls In The United States
• 10190932Feb 1, 2014Equipment, Wheels. Refinishing Aluminum Wheels This bulletin updates General Motor's position on refinishing aluminum wheels. GM does not endorse any repairs that involve welding, bending, straightening o re-machining. Only cosmetic refinishing of the wheel's coatings, using recommended procedures, is allowed. Evaluating Damage In evaluating damage, it is the GM Dealer's responsibility to inspect the wheel for corrosion, scrapes…
• 10190931Feb 1, 2014Equipment, Wheels. Refinishing Aluminum Wheels This bulletin updates General Motor's position on refinishing aluminum wheels. GM does not endorse any repairs that involve welding, bending, straightening o re-machining. Only cosmetic refinishing of the wheel's coatings, using recommended procedures, is allowed. Evaluating Damage In evaluating damage, it is the GM Dealer's responsibility to inspect the wheel for corrosion, scrapes…
• 10190934Jan 1, 2014Equipment, Body and structure. Underbody Component Corrosion The following information may be helpful when addressing underbody component corrosion with customers. Some customers may comment that one or more of their vehicle's underbody components are showing some form of corrosion. This corrosion may be red in appearance (rust) if the component is steel, forged iron or cast iron. This corrosion may also be grey or white in color if the…
• 10190933Jan 1, 2014Body and structure, Equipment. Underbody Component Corrosion The following information may be helpful when addressing underbody component corrosion with customers. Some customers may comment that one or more of their vehicle's underbody components are showing some form of corrosion. This corrosion may be red in appearance (rust) if the component is steel, forged iron or cast iron. This corrosion may also be grey or white in color if the…
• 10246645Nov 1, 2013Brakes. Pre-Formed and Pre-Flared Hydraulic Brake Pipe Kits Now Available for Service
• 10112331Nov 1, 2013Engine cooling. This Preliminary Information communication provides information to the technician about engine block of possible cylinder bore damage, scoring or out of round as the possible cause of engine oil consumption, misfire, cylinder leakage or blow by. Technician will need to inspect the engine for Cylinder damage or scoring, An out of round cylinder bore, Dirt intrusion, and Catalytic Converter failure.
• 10246631Sep 1, 2013Engine cooling. Expanded Availability for Remanufacture and Return (R&R) Electronic Control Modules
• 10139066May 23, 2013Engine cooling, Equipment. This informational bulletin provides information for Engine Squealing Type Noise on Start-up or Vibration Condition.
• 10112857Feb 13, 2013Electrical system. This Preliminary Information communication advises the technician that, when testing any circuit for open or resistance, it is imperative that all related terminal pin fit and tension be checked when the test steps require disconnection of the connector or component, prior to any component replacement. Always use the recommended terminal test tool during these tests.
• 10112664Dec 13, 2012Electrical system. This Preliminary Information communication provides information to the technician about vehicles may have a no power or no connect concern. Technician will find that the OnStar led is red and Diagnostic Trouble Code U1500 is set. Technician will need to replace the Vehicle Communication Interface Module if the Station Identification number falls in the ranges 14,000,000 - 16,000,000 or 22,000,000 - 23,200,000.
• 10112641Dec 12, 2012Engine cooling. This Preliminary Information communication provides information to the technician that fluid contamination may be directed to one of the following testing centers according to the type of fluid needing testing. Dealer should send the correct fluid to the proper testing center.
• 10112600Nov 26, 2012Transmission and drivetrain. This Preliminary Information communication provides information to the technician with the axel setup information from American Axle Manufacturing. Technician should be advised that the maximum pinion shim to be used or stacked behind the pinion is 0.050?, and the minimum pinion shim is 0.020? for an 8.6 axle. The range for available pinion depth shims for the 10.5? axle is 0.006? to 0.024?. When setting the…
• 10138211Nov 20, 2012Equipment. This warranty administration bulletin provides information regarding customer concerns not duplicated and which labor operations to claim when the concern cannot be duplicated. Also provides information on how to submit claims within the global warranty managment.
• 10137469Nov 20, 2012Equipment. This warranty administration bulletin provides information regarding customer concerns not duplicated and which labor operations to claim when the concern cannot be duplicated. Also provides information on how to submit claims within the global warranty managment.
• 10137458Nov 13, 2012Equipment. This informational bulletin provides information for requesting a new key code for customers with lost or stolen keys
• 10138191Nov 8, 2012Equipment, Visibility (wipers, defrost, mirrors). This warranty administration bulletin provides information on what should be considerd warranty damage or damage that was at fault of the cutomer and how to properly claim them on the warranty paperwork
• 10137448Nov 8, 2012Equipment. This warranty administration bulletin provides information on what should be considerd warranty damage or damage that was at fault of the cutomer and how to properly claim them on the warranty paperwork
• 10112528Nov 1, 2012Electrical system. This Preliminary Information communication provides information to the technician about vehicles that during battery parasitic drain test, there may be some confusion as to what the normal power consumption reading should be from the OnStar system. Technician should understand the power cycles of the various OnStar systems. All Generation 6, 7, 8, and 9 systems are powered up continuously for 48 hours from ignition…
• 10112494Oct 18, 2012Equipment. This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts. Technician can check Service Information for some accessories. Technician can also contact Partech for assistance.
• 10118639Oct 15, 2012Engine cooling. This informational bulletin provides Information on Identifying Duramax Diesel Overpower Engine Breakdown/Non-Function Due to Aftermarket Power-Up Devices vs Non Overpower Engine Non-Function of Pistons, Cylinders, Valvetrain Components, DTC P003A or P111D Set
• 10112468Oct 12, 2012Visibility (wipers, defrost, mirrors). This Preliminary Information communication provides information to the technician about the percentage of Ultraviolet protection or tint offered by the windshield or side glass. Technician should be advised Windshield reduces Ultraviolet rays down to 4% or less. Front side door glass reduces Ultraviolet rays down to 35% or less. Windshields are SOLAR glass with a light transmittance of >/=70%. Front door glass are…
• 10246951Oct 1, 2012Equipment. Programming And Activation Of Replacement OnStar Modules.
• 10042986Nov 1, 2011Seats. General motors: information provided by bulletin for all 2012 and prior general motor trucks and passenger vehicles regarding the adjustable comfort and custom upholstery of the driver and the passenger head restraint.
• 10032435Sep 1, 2009Engine cooling. Gm: loss of power hesitates on acceleration. 4.3, 4.8, 5.3, 5.7 and 6.0 engines coupled with the 4l60e or 4l65e may experience a condition of hesitates, misses or loss of power under acceleration. The vehicle may operate as if it is in reduced power mode.
• 10025667Jan 1, 2008Transmission and drivetrain. 4l80e, mt1 and 4l85e, mn8 simplified valve body reconditioning instructions, dtc p0741, p0742, p0752, p0752, p0756, p0757, p0894, harsh or delayed shifts, slips, no drive, no reverse. *pe updated 6/11/10.
• 10022259Apr 1, 2007Transmission and drivetrain. Delayed engagement with allison transmission, cold hesitation, malfunction indicator lamp (mil) illuminated, dtc's p0701, p1709, p1711, p1713, p0841, p0843, p0847, p0870, p0872, and p0875.
• 10016212Sep 1, 2004Equipment. A/c low pressure switch diagnosis.
• 10013205Apr 29, 2004Engine cooling. Engine may have a condition in which the exhaust valve stem may become deformed. This includes 1999-01 chevrolet and gmc 4500 and 5500 models.

← All problems reported for the 2001 GMC Sierra 3500