2000 GMC Sonoma Recalls

NHTSA lists 3 recall campaigns for the 2000 GMC Sonoma. A recall applies only to vehicles built within the affected range, so check your own VIN at nhtsa.gov/recalls. Repairs for recalls are free at a franchised dealer.

• 00V258001Sep 8, 2000223,194 vehicles potentially affected
  Equipment › Other › Labels
  Covers: GMC Sonoma 2000, Chevrolet S10 2000, Oldsmobile Bravada 2000

  Reported issue: Vehicle description: light duty pickup trucks and sport utility vehicles. Some of these vehicles were built with incorrect payload information on the vehicle certification label. The payload shown on the label is greater than the maximum validated payload. If the vehicle were loaded to the incorrectly labeled payload, it may not ride and handle in the manner that the driver expects.

  Possible consequence: This could result in a loss of control of the vehicle or an inability to stop the vehicle within expected stopping distances.

  Remedy: Owners will be sent a new label for installation on the driver's door of the vehicle.

  Full campaign details →

• 00V055000Feb 28, 200010,674 vehicles potentially affected
  Service brakes, hydraulic › Antilock/traction control/electronic limited slip
  Covers: GMC Sonoma 2000, Sierra 2000, Chevrolet Silverado 2000 +1 more

  Reported issue: Vehicle description: light duty pickup trucks equipped with 4-wheel disc brakes. Some of these vehicles have an antilock brake system (abs) motor containing an out-of-specification spring clip. This clip could allow the motor bearing to become misaligned. If misalignment occurs, eventually the abs would be non-functional.

  Possible consequence: The base brakes would remain fully functional, but the dynamic rear proportioning (drp) system, which optimizes front to rear brake balance, would become inoperative.

  Remedy: Dealers will replace the brake pressure module valve assembly.

  Full campaign details →

• 99V220000Aug 11, 19993,947 vehicles potentially affected
  Service brakes, hydraulic › Antilock/traction control/electronic limited slip
  Covers: GMC Sonoma 2000, Jimmy 2000, Chevrolet Blazer 2000 +1 more

  Reported issue: Vehicle description: s -trucks equipped with 2 wheel drive. These vehicles may have had the right-hand antilock brake system (abs) module feed pipe and/or brake crossover pipe tube nuts tightened without seating the pipe-flared-ends enough to withstand normal assembly and vehicle inputs without partially unseating. This does not comply with requirements of fmvss no. 105, "hydraulic service brake normal, emergency…

  Possible consequence: If this occurred, the seating seal could be broken during vehicle assembly, or from early road inputs or brake fluid cycling, and a leak could occur increasing the brake stopping distance.

  Remedy: Dealers will inspect the brake pipe union for signs of brake fluid, and if necessary, install a new brake pipe union.

  Full campaign details →

← All problems reported for the 2000 GMC Sonoma