2013 GMC Yukon Technical Service Bulletins

1,728 technical service bulletins (TSBs) are on record for the 2013 GMC Yukon. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10116871Feb 5, 2016Equipment. This informational bulletin provides information on how to properly repair rust on the hem flange on doors for vehicles that have the condition of rust showing at hem flange
• 10116863Feb 1, 2016Equipment. This informational bulletin provides information on Behavior of Non-Upgraded OnStar Equipped Vehicles Operating in Canada after Decommissioning of 2G CDMA Cellular Networks
• 10095613Feb 1, 2016Equipment, Electrical system, Transmission and drivetrain. This preliminary information communication provides information to the technician on the steps for diagnosing and repairing vehicles with diagnostic trouble code p0c2b with or without p2797. Technician should not replace the auxiliary transmission fluid pump. Technician will follow published diagnosis inspect the wiring between the hpcm and the auxiliary transmission fluid pump control module.
• 10112302Jan 28, 2016Seats, Air bags. This informational bulletin provides Information on Passenger Presence Sensing System (PPS or PSS) Concerns with Custom Upholstery, Accessory Seat Heaters or Other Comfort Enhancing Devices
• 10112299Jan 27, 2016Equipment. This informational bulletin provides information on Part Restriction and Ordering Process Information for OnStar Vehicle Communication Interface Modules (VCIM) (GMNA Only)
• 10097189Jan 26, 2016Engine. This preliminary information communication provides information to the technician about vehicles that may have service engine soon and a diagnostic trouble code p0011. If the technician has followed service information diagnostic trouble code for p0011and the root cause was not found the oil pressure at the oil pressure sender should be checked. Also the number 2 cam bearing should be inspected.
• 10112287Jan 25, 2016Steering. This preliminary informational bulletin provides a procedure to apply dielectric grease and a piece of adhesive shim stock to the steering angle sensor connector to correct a condition of service stabilitak message displayed in DIC and DTC C0455 or C0710
• 10112278Jan 19, 2016Steering. This technical bulletin provides a procedure to flush and bleed the power steering system to correct a condition of power steering noise or fluid leak from power steering pump, gear or high pressure hose during extreme low temperature conditions.
• 10112277Jan 19, 2016Equipment, Electrical system. This technical bulletin provides a procedure to update your apple product to the latest software version to correct a condition of infotainment system will not return to media after bluetooth call ends
• 10112272Jan 14, 2016Engine. This informational bulletin provides information on close coupled converters and there affect on newly installed engines or engines during there break in period.
• 10246963Jan 13, 2016Equipment. Changing Turn-By-Turn Voice Response To Metric Or English Units
• 10112264Jan 7, 2016Body and structure. This informational bulletin provides information on removing paint stains on the under side of protective shipping film
• 10250067Jan 1, 2016Equipment. Infotainment System Will Not Return to Media After Bluetooth Call Ends
• 10246639Jan 1, 2016Steering. Power Steering Noise or Fluid Leak from Power Steering Pump, Gear or High Pressure Hose During Extreme Low Temperature Conditions
• 10114977Dec 18, 2015Equipment. This Preliminary Information communication provides information to the technician about what XM offerings are available for vehicles. A dealer or customer can access the website listed below for vehicle specific XM offerings and availability.
• 10114954Dec 9, 2015Fuel system, Engine cooling. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp. Technician may find Diagnostic Trouble Code P0442. Technician will need to review Techlink article from May 2013 titled "Using the Evaporative Emissions System Tester" Technician will need to follow these steps to help diagnose the issue. First after the P0442…
• 10250048Dec 1, 2015Back-over prevention (rear camera). Clunking Noise from Front of Vehicle During Turns and/or Bumps
• 10250047Dec 1, 2015Back-over prevention (rear camera). Clunking Noise from Front of Vehicle During Turns and/or Bumps
• 10250031Dec 1, 2015Fuel system. Fuel Odor During Fuel Filling or During Idle, Possible P0442 or P0455 DTCs Set
• 10246535Dec 1, 2015Suspension. Clunking Noise from Front of Vehicle During Turns and/or Bumps
• 10246534Dec 1, 2015Suspension. Clunking Noise from Front of Vehicle During Turns and/or Bumps
• 10246518Dec 1, 2015Fuel system. Fuel Odor During Fuel Filling or During Idle, Possible P0442 or P0455 DTCs Set
• 10201117Dec 1, 2015Equipment, Body and structure. Clunking Noise from Front of Vehicle During Turns and/or Bumps
• 10201115Dec 1, 2015Equipment, Other or unknown. OnStar Voice Fallback Number Update
• 10201107Dec 1, 2015Fuel system. Fuel Odor During Fuel Filling or During Idle, Possible P0442 or P0455 DTC SET
• 10201098Dec 1, 2015Transmission and drivetrain, Engine. OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification
• 10190521Dec 1, 2015Suspension. Clunking Noise from Front of Vehicle During Turns and/or Bumps Some customers may comment on a clunking noise originating from the front of the vehicle that is more predominant during turns or traveling over bumps. This may be caused by a damaged stabilizer shaft frame bracket. There have been some cases in which the bracket is cracked, as shown. This condition has been found to be the result of insufficient welds…
• 10190504Dec 1, 2015Electrical system, Equipment. IPC Odometer Programming Method Quick Reference Guide Season Odometer Programming Methods in Use Today 1. IPC reprogramming and setup using the service programming system (SPS). 2. Odometer setup at the electronic service center (ESC) when using an exchange IPC/DIC. 3. Tech 2® – The Tech 2 is used to set up a replacement BCM, which includes loading the odometer value that is displayed and stored in the IPC.
• 10190503Dec 1, 2015Engine, Transmission and drivetrain. OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification
• 10190383Dec 1, 2015Fuel system, Other or unknown. Fuel Odor During Fuel Filling or During Idle, Possible P0442 or P0455 DTCs Set Some customers may comment on a strong fuel odor during fuel filling or during vehicle idle. Cause This may be caused by the fracture or breaking of the gasoline filler neck recirculation line connector Correction If you encounter a vehicle with the above concern, complete the following procedure: 1. Raise the vehicle and visually…
• 10137258Nov 30, 2015Equipment. This informational bulletin provides information for technicians on the reuse of fasteners and the proper reading of torque specifications.
• 10115143Nov 30, 2015Engine cooling. This Preliminary Information communication provides information to the technician about gasoline powered cars, mid-size trucks, light duty trucks, and heavy duty trucks with premature catalytic converter failures. It is recommended to inspect for a poor crimp on the grounds ring terminal at the engine block for the bank with the concern and repair the wire.
• 10137255Nov 25, 2015Tires, Wheels. This informational bulletin provides additional information to the technician on how to check for Tire Radial Force Variations and the difference between balancing a flange and flangeless rim.
• 10115138Nov 25, 2015Equipment, Suspension. This Preliminary Information communication provides information to the technician about vehicles that have had multiple repair attempts are being performed on customer?s vehicles that exhibit vibration conditions without utilizing the support of General Motors Technical Assistance Center. If valid vibration frequency or Road Force Variation data has been collected and a repair attempt does not correct the customer…
• 10137250Nov 23, 2015Equipment. This preliminary informational bulletin provides repair information to correct a customer concern of poor radio hands-free voice recognition performance or sound quality after OnStar upgrade.
• 10115128Nov 23, 2015Equipment. This Preliminary Information communication provides information to the technician about vehicle's odometer appears to be inaccurate relative to a known distance traveled. Technician should obtain a hand-held GPS unit to test the odometer. If a hand held GPS unit is not available, the only other option is to verify the miles traveled using a surveyor's wheel or a dynamometer.
• 10137249Nov 20, 2015Equipment. This informational bulletin provides information on a GM of Canada OnStar cellular communication upgrade.
• 10137246Nov 20, 2015Equipment. This informational bulletin provides information on a GM of Canada OnStar cellular communication upgrade.
• 10137237Nov 12, 2015Electrical system. This warranty administration bulletin adds the 2016 model year to a communication which provides dealership personnel revised wiring repair labor operations and required additional information.
• 10137226Nov 6, 2015Transmission and drivetrain. This preliminary informational bulletin adds the 2016 model year to diagnostic tips and repair information to correct a customer concern of reduced acceleration at low speed and/or transmission slipping from a launch, DTC P0751 set.
• 10075716Nov 6, 2015Transmission and drivetrain. Some customers may comment that the vehicle has reduced acceleration at low speed and/or transmission is slipping from a launch. Technicians may find DTC P0751 set or stored in history. This condition may be caused by the Clutch Select Solenoid Valve 2 (359), located in the lower valve body, sticking in its bore resulting in a 4th gear start. Note: This condition can be very intermittent and difficult to duplicate.
• 10126401Oct 30, 2015Body and structure. This informational bulletin provides information on the PQC assembly replacement process - for dealers required to contact PQC prior to replacing an assembly (U.S. and Canada only).
• 10126395Oct 27, 2015Engine cooling. This informational bulletin provides guidelines and diagnostic/repair information to technicians regarding vehicle engine oil consumption.
• 10126393Oct 26, 2015Equipment. This warranty administration bulletin provides policy information on an updated warranty and policy exchange program for electronic products through GM authorized Electronic Service Centers (ESCs) (U.S. and Canada).
• 10114925Oct 26, 2015Equipment, Engine. This Preliminary Information communication provides information to the technician about vehicles that engine runs and idles rough. Technician will find P0171 and or P0174. Technician will need to inspect the positive crankcase ventilation tube for a vacuum leak on the left side of the engine. Replace positive crankcase ventilation air tube and cover it with conduit to protect from repeat damage.
• 10126385Oct 22, 2015Electrical system, Equipment. This preliminary informational bulletin adds the 2014 - 2016 model years to cleaning information to correct a customer concern of seeing a white film/residue on the IP pad and/or door trim panels.
• 10126384Oct 22, 2015Brakes. This preliminary informational bulletin adds the 2015 Chevrolet Colorado and GMC Canyon to diagnosis and repair information to correct a customer concern of alleged no park, vehicle rolls in park or park will not hold.
• 10114907Oct 19, 2015Body and structure, Equipment, Visibility (wipers, defrost, mirrors). This Preliminary Information communication provides information to the technician about vehicles with the inside door panel material appearing to be pulling back from the door panel backing. Technician will check the windows for aftermarket window tint. Since this failure is not the result of a manufacturer defect, it would not be considered for coverage under a General Motors Warranty.
• 10114903Oct 16, 2015Equipment, Electrical system. This Preliminary Information communication provides information to the technician about vehicles that may have an issue when using Bluetooth voice recognition with an iPhone. Technician should work with the customer to insure the phone contacts to not have any Emojis loaded to any contact.
• 10114900Oct 16, 2015Tires. This Preliminary Information communication provides information to the technician about vehicles with tire sidewall irregularities. This is a visual condition that will not affect durability, reliability or performance of the tires. Dealer should communicate to the customer that slight sidewall indentations are a common characteristic of radial tire construction.

← All problems reported for the 2013 GMC Yukon