2015 GMC Yukon Technical Service Bulletins

2,535 technical service bulletins (TSBs) are on record for the 2015 GMC Yukon. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10137935May 29, 2014Engine, Transmission and drivetrain. This informational bulletin provides a process to the service agents that are not required to contact PQC, to determine when to replace a assembly as opposed to repairing and if an engine or transmission is being returned, that it has all the information in relation to that part being returned.
• 10137934May 29, 2014Engine cooling, Transmission and drivetrain. This informational bulletin provides information to the technician on what parts of an engine or transmission will require the PQC to be notified.
• 10112091May 29, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicles that may have an air condition that has poor performance during high ambient temperatures. Technician will need to check the refrigerant charge and record the recovered amount on the repair order. Technician should recharge the system if needed. Technician will also need to verify if Global Diagnostic System 2 high side…
• 10137932May 28, 2014Electrical system, Equipment. This warranty bulletin explains how to use the EL-50313 Midtronic GR8 Battery tester to test a battery and determin if it is warranty or not.
• 10112089May 28, 2014Visibility (wipers, defrost, mirrors). This Preliminary Information communication provides information to the technician about vehicle that may have wind whistle noise heard from the right or left rear quarter glass area when driving at highway speeds or with a cross wind. Technician will inspect the quarter glass for excessive urethane. If excessive urethane is found use a sharp knife and cut off the excessive urethane. Also the technician will install…
• 10112088May 28, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicles that may have a rear Heater-Vent-Air Conditioning is inoperative, but the front Heater-Vent-Air Conditioning blows cold and works normally. Technician will need to replace the Thermo Static Expansion Valve with part number 25914263 into the liquid line.
• 10061382May 28, 2014Equipment. Summary to be provided on a future date.
• 10112086May 27, 2014Electrical system, Equipment. This Preliminary Information communication provides information to the technician about vehicles that may have any of these concerns remote keyless entry, passive Entry and Start Inoperative, No Fob detect message on driver information center, service tire pressure system, no audio, touch screen Inoperative, Steering Wheel Controls Inoperative, Service Stabilitrak, rear power windows inoperative, rear wiper…
• 10112084May 27, 2014Engine cooling, Electrical system. This Preliminary Information communication provides information to the technician about vehicles that during very cold ambient temperatures there may be a no crank or a click no crank condition. Technician will need to check the battery voltage while trying to crank the engine. Replace the battery if it fails the GR8 test. If the battery has more than 11.4 volts while starting and there is a click noise is heard…
• 10112083May 23, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicles that may have a rolling video display. Dealer should advise the customer that we apologize for this inconvenience and that General Motors is working on a solution for this concern.
• 10061374May 23, 2014Equipment. Summary to be provided on a future date.
• 10137928May 22, 2014Equipment, Tires. This informational bulletin explains a normal condition of new tires may shake and vibrate for the first few miles.
• 10137927May 22, 2014Equipment, Tires. This informational bulletin provides the technician with information on tire radial force variations and how to balance a tire using the balancer.
• 10061373May 22, 2014Equipment. Summary to be provided on a future date.
• 10061370May 22, 2014Equipment. Summary to be provided on a future date.
• 10137919May 19, 2014Equipment. This informational bulletin helps the technician quick reference repairs to bulletins as opposed to replacing parts that may be un necessary.
• 10137918May 19, 2014Electrical system, Equipment. This informational bulletin explains if the fuse is open when the customer plugs in the trailer, that it may be the cause if diagnostics finds no problems to that point.
• 10137914May 16, 2014Equipment. This informational bulletin provides tips on how to care for the interior of the vehicle using products.
• 10112072May 16, 2014Transmission and drivetrain, Equipment. This Preliminary Information communication provides information to the technician about vehicles with a crankshaft balancer appears to be out of balance or wobbling while watching it with the engine running. Technician will need to check crankshaft balancer run out. If the balancer run out is greater than 0.25mm the crankshaft balancer will need to be replaced.
• 10061189May 15, 2014Transmission and drivetrain. Summary to be provided on a future date.
• 10112070May 14, 2014Equipment, Suspension, Electrical system. This Preliminary Information communication provides information to the technician with the correct way to remove the front shock electrical connector terminals. Technician will need to slightly bend the end of the J-38125-12A release tool. There is a purple Terminal Position Assurance that will align itself in the release position when the release tool is inserted into the release hole.
• 10112069May 14, 2014Engine, Engine cooling. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have a Service Engine Soon Malfunction Indicator Lamp on at low mileage. Technician may find Diagnostic Trouble Codes P0420 and or P0430 stored. Technician should be advised that the catalytic converter efficiency Diagnostic Trouble Codes P0420 and P0430 are disabled for the first…
• 10137906May 13, 2014Electrical system. This technical bulletin provides a procedure to disconnect the battery if the repairs were done to the vehicle and the technician was unable to clear the codes.
• 10137903May 12, 2014Equipment. This preliminary bulletin states to add the DTC symptom byte to the documentation to help aid engineering pinpoint concerns when trying to locate a root cause.
• 10112067May 12, 2014Body and structure. This Preliminary Information communication provides information to the technician about vehicles that have a pop or scrape noise when the lift gate or lift glass is opened. Technician will need to inspect to see if the truck was built with shims between the left hinge and the spoiler. Technician will need to remove the shims if they are present. If removing the shims does not correct the concern, the spoiler will…
• 10137902May 9, 2014Fuel system, Equipment. This preliminary bulletin provides directions on testing the in tank fuel pump and which bulletin to refer to after the diagnostics are complete.
• 10112064May 8, 2014Electrical system. This Preliminary Information communication provides information to the technician about vehicles that may have the driver's power seat or the memory seat functions become inoperative. Technician will need to inspect terminal tension at the left instrument panel fuse block (X51L) connector X1 terminals 27 and 28. If terminal tension is found to be poor, it will need to be replaced.
• 10112063May 8, 2014Body and structure. This Preliminary Information communication provides information to the technician about vehicles with erratic or hesitation when opening and closing the power lift gate. There may be a diagnostic trouble code B153A set in the power lift gate module. This concern could occur if the left lift gate actuator is internally coming apart. The actuator will need to be replaced however care must be taken when removing the…
• 10112057May 6, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicles that the radio display does not always return to the previous source screen when a Bluetooth call has ended. Dealer should communicate to the customer this condition is a normal operating characteristic of their vehicle.
• 10112055May 6, 2014Brakes, Transmission and drivetrain. This Preliminary Information communication provides information to the technician with the steps on diagnosing and repairing vehicles that may have unwanted grade braking, reduced engine power with no Driver Information Center messages "Brake Pedal Override Feature", transmission busy or frequent shifting up or down. Technician will use this preliminary information to find the brake pedal position data parameters…
• 10112054May 5, 2014Electrical system, Equipment. This Preliminary Information communication provides information to the technician the steps to diagnose and repair the concern of the display is showing 32° F (0° C) after a battery or reprogramming a module. The outside temperature will begin to update if driven above 20 mph for at least 5 minutes. If the vehicle speed drops below 20 mph, the timer will reset and the display will stop updating.
• 10112053May 5, 2014Seats, Equipment. This Preliminary Information communication provides information to the technician on how to diagnose and repair vehicles that may have a rattle noise from the second row seat. Technician will need to "forcefully" slam the seat down into the latched position and Repeat this 7 to 8 times. Technician can now latch the seat down using normal force and verify the rattle noise is corrected.
• 10137890May 2, 2014Equipment, Transmission and drivetrain, Engine cooling. This informational bulletin provides information to the technician on what parts of an engine or transmission will require the PQC to be notified.
• 10112052May 2, 2014Transmission and drivetrain, Equipment. This Preliminary Information communication provides information to the technician about vehicles that may have a delayed engagement into drive, shudder at a launch, or the transmission is slipping when shifting into 1st, 2nd, 3rd or 4th gears. This may be due to loose stator support to pump cover bolts causing a leak at the stator support to pump cover gasket. Technician will check for the bolts to be loose.
• 10112050May 2, 2014Transmission and drivetrain, Suspension. This Preliminary Information communication provides information to the technician with the steps to diagnose and repair vehicles that may have a whine noise at highway speeds from the rear of the vehicle. If the technician has diagnosed the noise to be a rear axle related whine noise at highway speed, then use published Service Information "Symptoms - Rear Drive Axle". Technician should also compare the concern…
• 10112048May 2, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicles that have a touchscreen that is inaccurate or that the display does not seem to respond with the desired operation when pressed. Technician will need to perform a touch screen calibration and re-evaluate the concern.
• 10253373May 1, 2014Engine cooling, Electrical system. Engine Cranks But Will Not Start May Set P00C6.
• 10253122May 1, 2014Engine cooling. Engineering Information
• 10248771May 1, 2014Equipment. Base Radio Lock Up
• 10248469May 1, 2014Electrical system, Suspension. Front Shock Electrical Connector Terminal Removal.
• 10248456May 1, 2014Electrical system. Front Shock Electrical Connector Terminal Removal.
• 10248455May 1, 2014Visibility (wipers, defrost, mirrors), Body and structure. Pop Or Scrape Noise When Liftgate Or Glass Is Opened Or Power Liftgate Reverses.
• 10247322May 1, 2014Transmission and drivetrain. Transmission Oil Cooler Connection
• 10246506May 1, 2014Electrical system, Other or unknown. Unable to Clear BCM DTCs After Completing Repair
• 10246505May 1, 2014Other or unknown, Electrical system. Unable to Clear BCM DTCs After Completing Repair
• 10245968May 1, 2014Body and structure. Power Liftgate Erratic Operation Will Not Power Close DTC B153A And/Or Motor Running But Does Not Move.
• 10245758May 1, 2014Equipment. Transport Mode On Message Displayed in Driver Information Center (DIC) and/or Battery Light is Flashing (Follow Procedure as Outlined Below)
• 10137889May 1, 2014Equipment, Electrical system. This technical bulletin provides a procedure on how to turn the transport mode message off and reset the battery light flashing.
• 10074045May 1, 2014Engine. Summary to be provided on a future date.
• 10073745May 1, 2014Equipment. Summary to be provided on a future date.

← All problems reported for the 2015 GMC Yukon