2006 Infiniti QX56 Technical Service Bulletins

90 technical service bulletins (TSBs) are on record for the 2006 Infiniti QX56. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10192693Dec 1, 2015Visibility (wipers, defrost, mirrors). SERVICE INFORMATION Windshield "foreign material" that is on the surface of the glass in some cases can be cleaned off with a very particular type and grade of steel wool. * Most any foreign material on the surface of the Windshield can be cleaned off by using #0000 super fine steel wool. >The #0000 grade super fine steel wool can be found in most hardware stores. Please see this bulleitn for further details.
• 10192639Sep 15, 2015Lane departure, Wheels, Back-over prevention (rear camera), Brakes. SERVICE INFORMATION This bulletin has compiled Tire Pressure Monitor System (TPMS) and Low Tire Pressure Warning System (LTPWS) information for: - Basic diagnosing of TPMS/LTPWS systems - Radio frequency interference causing a "No Data" (C1708, C1709, C1710, C1711) condition - Sensor leaks - Moving TPMS/LTPWS wheel assemblies from one vehicle to another and TPMS/LTPWS sensor registration - Air pressure changes with…
• 10192589Jun 24, 2015Engine cooling. SERVICE INFORMATION After ECM reprogramming, the Calibration Verification Number (CVN) needs to be automatically calculated prior to State emissions testing (also known as Inspection Maintainence, I/M, or SMOG testing depending upon location). Allowing the vehicle to idle for 22 minutes will allow for faster CVN calculation. It is recommended that customers utilize this method if the vehicle needs to be tested for…
• 10192514Jan 16, 2015Air bags, Equipment, Back-over prevention (rear camera). SERVICE INFORMATION Changes or modifications to the front seat assembly trim materials may affect the proper operation of the Front Seat-Mounted Side-Impact Supplemental Air Bags and Passenger Occupant Classification Sensor and could result in serious personal injury or death. Infiniti STRONGLY RECOMMENDS AGAINST making any change to seat trim materials from the factory equipped condition.
• 10192505Jan 5, 2015Equipment. SERVICE INFORMATION Two methods are used to update/upgrade Navigation Map Data: 1. The customer goes to www.infinitinavigation.com and is mailed update disc(s) or SD card and installs data, OR 2. The dealership is mailed update disc(s) and the customer must visit the dealership to have data installed. Use the matrix in this bulletin to determine which method is utilized for each Applied Vehicle. See this bulletin…
• 10192475Nov 20, 2014Transmission and drivetrain, Electrical system. SERVICE INFORMATION If a customer describes lack of power or poor acceleration, perform the following checks before attempting any repair: * Check for stored DTCs. * Check if the driver is resting their left foot on the brake pedal while accelerating. Advise the customer not to rest their foot on the brake while accelerating. * Use CONSULT-III plus in Engine Data Monitor to check operation of the brake lamp circuit…
• 10192427Aug 21, 2014Electrical system, Engine, Equipment. IF YOU CONFRIM An oil leak at the right side block ball plug behind the alternator. ACTION: Use a punch to seat the block ball plug in the hole (refer to the Service Procedure). See this bulletin for further detail.
• 10192396Jun 24, 2014Equipment, Electrical system. SERVICE INFORMATION Related to communication codes U1000, U1001, U1002, U1010: - Always diagnose the communication codes first. - When a module reports a U1000 code, it is typically operating normally; however, there is a communication error external to that module on the CAN network. - U1000 indicates an error. V-CAN diagram or CAN Diag Support Monitor provides data to determine the location of the error. See this…
• 10192314Jan 27, 2014Electrical system, Air bags. SERVICE INFORMATION Information necessary to service the Supplemental Restraint System (SRS) safely is included in the "RESTRAINTS" section of the Electronic Service Manual (ESM) for each vehicle IMPORTANT: Turn the ignition switch OFF, disconnect both battery terminals, and wait at least 3 minutes before performing any service on the SRS. See this bulletin for further detail.
• 10032305Jan 27, 2014Air bags. Infiniti: srs precautions during service. Included in the restraints section of the electronic service manual (esm) for each vehicle is information necessary to service the supplemental restraint system (srs) safely. Improper maintenance, including incorrect removal and installation of the srs, can lead to a serious injury or death caused by unintentional activation of the srs. No model or model years listed. *pe…
• 10032304Nov 27, 2013Exterior lighting. Infiniti: exterior lamp fogging. Water in the exterior lamps. This is generally not due to a defect. All current exterior lamp assemblies are vented to the atmosphere (not sealed). Moisture in the air sometimes travels into and out of the lamp assembly through these vents. Necessary to allow for expansion and contraction of air from temperature variations (warmer or colder) without damage to the lamp. Certain…
• 10192235Aug 27, 2013Equipment, Wheels. Infiniti Original Equipment or Genuine Accessory Alloy wheels, along with their finish coating (clear, chrome, titanium, etc.), are specifically developed to achieve Infiniti design and performance standards. These Original Equipment or Genuine Accessory wheels are subjected to testing to ensure they meet Infiniti's standards.
• 10192232Aug 26, 2013Electrical system. SERVICE INFORMATION This TSB is for troubleshooting of CAN Modules with "Diag-On-CAN" Diagnostics. The flow charts below are meant to troubleshoot current CAN DTCs. The flow charts are intended to diagnose one module at a time; repeat the process as needed for additional control units. Please see this bulletin for further details.
• 10192219Jul 23, 2013Steering, Suspension, Brakes. SERVICE INFORMATION - This bulletin is to assist you in responding to customer questions about brake operation, and provides diagnostic and repair information for each item listed, if any should occur. - Most brake issues fall into the following categories: a. Brake Noise: A squeak, squeal, clunk, or groan that occurs when the brakes are applied or released. b. Brake Judder: A vibration that can be felt in the…
• 10192218Jul 23, 2013Brakes, Wheels, Steering. If YOU CONFIRM: A vehicle needs to have the brake rotors resurfaced (front or rear). ACTION: Use the ProCut PFM Series on-car brake lathe to perform brake rotor resurfacing and follow the tips listed in this bulletin. - The ProCut PFM Series brake lathe has been chosen as the approved tool for rotor resurfacing. - The ProCut PFM Series brake lathe can be ordered from TECH-MATE at 1-800-662-2001. - ProCut technical…
• 10192191Jun 7, 2013Electrical system. As part of an enhanced emissions test for Inspection & Maintenance (I/M), some States may require the System Readiness Test (SRT) status be checked. - The SRT is used to indicate whether the engine control module (ECM) has completed self diagnosis of major emissions systems and components. - In these instances the State may require completion of the SRT before permitting the emissions inspection to proceed. Refer…
• 10051765Apr 3, 2013Latches, locks and linkages. Infiniti: lock/unlock request button on outside door handle outside door handle does not respond. Lock/unlock request button located on outside door handles of vehicles can be disabled (or enabled) through either the "comfort & conv" settings of the audio/visual/navigation system or through the "combination meter settings" depending on the vehicle model, year, and trim level.
• 10192146Mar 19, 2013Suspension. SERVICE INFORMATION This bulletin provides information to identify: - A leaking strut or a shock absorber that qualifies for replacement under warranty. - A strut or shock absorber that has slight oil seepage, a condition which is considered normal, does not affect strut/shock absorber operation or performance, and does not require replacement. - A strut or shock absorber that should be replaced due to rod…
• 10044526Jul 6, 2012Electrical system. Infiniti: reprogramming electronic control unit (ecu) on all qualifying vehicles. No models listed. Model years 1998-2013.
• 10043948Apr 10, 2012Electrical system. Infiniti: the electronic control module (ecm) needs to be replaced on a 2004 my and later vehicle.
• 10043815Mar 22, 2012Steering. Infiniti: power steering hose service part change. The hose now comes without the pressure sensor. If only pressure sensor needs replacement do not replace any hoses.
• 10032790Oct 6, 2011Transmission and drivetrain, Suspension. Infiniti: clicking noise from rear axles during take-off/acceleration. *pe updated 11/2/11.
• 10034905Oct 6, 2010Suspension. Infiniti: front suspension noise. A noise (clunking, squeaking, popping) can be heard when performing at least one of the following actions-turning steering wheel left/right; driving over speed bumps; driving on rough roads; accelerating/decelerating and noise is coming from the front stabilizer bar bushing.
• 10031304Sep 30, 2010Tires. Infiniti: tire pressure monitoring system (tpms) warning light on/blinking. No models or model years listed. *pe updated on 08-11-2011.
• 10032994Apr 27, 2010Exterior lighting. Infiniti: a xenon headlamp is not functioning because of an issue inside the headlamp assembly (an internal issue). Refer to the appropriate service manual, follow the diagnostic and repair information for xenon headlamps.
• 10032629Apr 8, 2010Electrical system, Equipment. Infiniti: the propeller shaft u joint (journal/journal bearings) is the source of noise and/or vibration on an applied vehicle. Diagnose by evaluating the u joint with the propeller shaft removed.
• 10033227Feb 11, 2010Transmission and drivetrain. Infiniti: 5 speed a/t dtc diagnoses for p1701, p1702, p1703, p1704, p1705, p1754, p1759, p1764, p1769, p1774. Applies to re 5r05a only transmissions (5 speed a/t). If one or more dtcs listed are found stored in self diagnosis, use the repair flow chart to assist in diagnosis.
• 10032524Nov 17, 2009Equipment. Infiniti: vent control valve replacement. No applied vehicles affected: all models; no model years listed.
• 10033008Nov 12, 2009Seat belts. Infiniti: d ring residue can cause slow seat belt retraction. Seat belt retraction of the front seat belt(s) is slow, caused by residue build up on the d rings. Models fx35/fx45(03-08); g35 coupe(03-07); g35(03-06); i30/i35 (00-04); q45(02-06); qx4(00-03); qx56(04-07.
• 10030145Apr 6, 2009Electrical system. Infiniti: electronic control unit damage can result from improper battery connection. The battery is required to stay connected when the engine is running. No model years listed.
• 10025521Jul 21, 2008Air bags. Srs precautions during service; incorrect removal and installation of the srs, can lead to a serious injury or death caused by unintentional activation of the srs on all infiniti models with the srs systems.
• 10025005Jun 13, 2008Seats. Seat back board removal/installation.
• 10024688Apr 28, 2008Transmission and drivetrain. Infiniti; special automatic transmission fluid requirement. 2004 to current infinit vehicles.
• 10022431Jul 11, 2007Wheels. Cam bolts for front wheel alignment.
• 10021696Jun 6, 2007Engine cooling. Low power with wide open throttle.
• 10021509Apr 18, 2007Exterior lighting. Exterior lamp fogging.
• 10020027May 12, 2006Brakes. Abs and/or brake warning light on with dtc c1179.
• 10019293Mar 31, 2006Engine cooling. Malfunction indicator lamp with diagnostic trouble code u1000 or u1010 stored in engine control unit. 2002 - 2006 infiniti vehicles with can communication.
• 10019411Mar 2, 2006Brakes. Groan noise from front brakes.
• 10019286Feb 14, 2006Transmission and drivetrain. Voluntary service campaign front axle flange bolts (4wd). There is the possibility that the bolts attaching the front drive shafts to the front final drive assembly may not have been tightened properly.

← All problems reported for the 2006 Infiniti QX56