1990 Jeep Cherokee Recalls

NHTSA lists 5 recall campaigns for the 1990 Jeep Cherokee. A recall applies only to vehicles built within the affected range, so check your own VIN at nhtsa.gov/recalls. Repairs for recalls are free at a franchised dealer.

• 98V005000Jan 12, 1998293,369 vehicles potentially affected
  Service brakes, hydraulic › Foundation components › Disc › Rotor
  Covers: Jeep Cherokee 1990–1991, Eagle Premier 1988–1991, Dodge Monaco 1990–1991 +4 more

  Reported issue: Vehicle description: passenger and multi-purpose vehicles originally sold or currently registered in the states of connecticut, illinois, indiana, maine, maryland, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, or wisconsin, and the district of columbia. The front disc brake rotors can experience severe corrosion if operated for an extensive period in the…

  Possible consequence: The reduced strength can allow the cast iron wear surface to separate from the hub, reducing the brake effectiveness of the vehicle.

  Remedy: Dealers will replace these rotors with rotors that are coated with a corrosion protection.

  Full campaign details →

• 96V260000Dec 27, 199652,000 vehicles potentially affected
  Service brakes, hydraulic › Antilock/traction control/electronic limited slip
  Covers: Jeep Cherokee 1989–1991, Wagoneer 1989–1991

  Reported issue: Vehicle description: vehicles equipped with antilock brake system (abs). The antilock brake system (abs) hydraulic control unit can experience excessive brake actuator piston seal wear which could cause pump-motor deterioration.

  Possible consequence: If this occurs, the abs function would be lose and reduced power assist would be experienced during vehicle braking. The instrument panel warning lights will signal system impairment and the base manual brakes will remain functional.

  Remedy: Dealers will test the vehicle's abs and repair as necessary. The warranty on all abs components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will be reimbursed for previous abs component repair…

  Full campaign details →

• 91V003000Oct 2, 199133,000 vehicles potentially affected
  Service brakes, hydraulic › Foundation components › Hoses, lines/piping, and fittings
  Covers: Jeep Cherokee 1989–1990, Wagoneer 1989–1990

  Reported issue: There may be hydraulic fluid contamination from condensation formation that can plug the abs brake booster pump filter; stress corrosion of the master cylinder snap ring has been traced to chlorine leaking from the low pressure hydraulic hose which may cause it to break; front brake hose to tire interference which may cause failure of the brake hose.

  Possible consequence: Contamination of the hydraulic fluid can causemalfunctioning of the anti-lock brake system; low pressure hose leakage causesloss of brake fluid and also results in corrosion and failure of the mastercylinder snap ring, resulting complete brake failure; failure of the front brakehose due to hose to tire interference…

  Remedy: Replace abs low pressure hose; rebuild master brake cylinder; inspect, service interference problems, and replace front brake hose as necessary.

  Full campaign details →

• 91V063000Apr 15, 199117,000 vehicles potentially affected
  Service brakes, hydraulic › Foundation components › Hoses, lines/piping, and fittings
  Covers: Jeep Cherokee 1990–1991, Wagoneer 1990

  Reported issue: Improper insertion/crimping of the hose-to-end fittings of the high pressure hose on the anti-lock brake system can cause detachment of the hose from the abs system, and discharge of hydraulic fluid.

  Possible consequence: Detachment of the hose from the abs system causes theloss of the abs function and hydraulic brake assist, leaving only manual brakesand decreasing stopping ability, which could result in an accident. Discharge ofhydraulic fluid in the area of the hot exhaust system could result in an enginecompartment fire.

  Remedy: Replace the abs high pressure hose.

  Full campaign details →

• 90V177000Oct 2, 1990165,000 vehicles potentially affected
  Vehicle speed control › Cruise control
  Covers: Jeep Cherokee 1989–1990, Comanche 1989–1990, Wagoneer 1989–1990

  Reported issue: Malfunction of fuel injection system throttle postition sensor could cause intermittent high engine idle speed immediately after starting engine.

  Possible consequence: High engine idle when car is first placed in gear couldresult in unexpected acceleration.

  Remedy: Replace throttle position sensors with sensors that would send correct signals to the fuel injection system.

  Full campaign details →

NHTSA investigations

• EA97001Brake disc/hub separationClosed · Jan 13, 1997
• PE96053Brake disc/hub separationClosed · Sep 5, 1996
• PE95049Rear axle shaft separationClosed · Aug 17, 1995
• PE93057Driveshaft/univ.joint failClosed · Jun 14, 1993
• PE91067Steering gear lockupClosed · Apr 16, 1991
• EA90024Failed antilock brakesClosed · Apr 26, 1990

← All problems reported for the 1990 Jeep Cherokee