2000 Mazda B-Series Truck Recalls

NHTSA lists 2 recall campaigns for the 2000 Mazda B-Series Truck. A recall applies only to vehicles built within the affected range, so check your own VIN at nhtsa.gov/recalls. Repairs for recalls are free at a franchised dealer.

• 07V347000Aug 7, 200776,000 vehicles potentially affected
  Vehicle speed control
  Covers: Mazda B-Series Truck 1998–2002

  Reported issue: On certain trucks equipped with a speed control system, the speed control deactivation switch may, under certain conditions, leak internally and then overheat, smoke, or burn.

  Possible consequence: This could result in an underhood fire.

  Remedy: Dealers will install a fused wiring harness. An interim notice was sent to owners on september 7, 2007, directing them to have the speed deactivation control switch disconnected temporarily. A second notification letter to owners was in february 2008 advising them to return to dealers for installation of the repair…

  Full campaign details →

• 00V228002Aug 18, 2000460 vehicles potentially affected
  Seat belts
  Covers: Mazda B-Series Truck 2000

  Reported issue: Vehicle description: light duty trucks equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."

  Possible consequence: In the event of a vehicle crash, the occupant may not be properly restrained.

  Remedy: Dealers will inspect the buckle assemblies to determine whether the buckle assembly build date codes are within the suspect range. Those within the suspect date code range will be replaced.

  Full campaign details →

← All problems reported for the 2000 Mazda B-Series Truck