2008 Mazda MX-5 Technical Service Bulletins

201 technical service bulletins (TSBs) are on record for the 2008 Mazda MX-5. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10213329Feb 5, 2016Electrical system, Engine cooling. Engine Start /Stop Procedure with room fuse removed
• 10213422Feb 2, 2016Equipment. Proper usage of driver's floor mat.
• 10100890Jan 25, 2016Equipment. Always be sure to use the correct automatic transmission fluid when replacing atf. Using the wrong atf may cause shift quality complaints or may even damage the transmission.note:• atf m-v (type m5) is not the same fluid as mercon®v or mercon®lv atf.• atf m-v (type m5) has a greater viscosity than mercon®v and mercon®lv atf in low temperatures.• atf m-v (type m5) has a greater anti-judder specification than…
• 10100888Jan 25, 2016Exterior lighting. Some customers may complain of condensation/fog inside the front (headlamp/headlight) or rear (taillamp/tail-light) combination lights. The recent new models have been fitted with a clear lens which can cause the symp-tom to be more noticeable, however, it does not affect the performance of the light. This condensation/fog is a natural phenomenon that occurs when there is a fairly large temperature difference…
• 10105855Jan 8, 2016Wheels. Some automotive cleaning products contain strong acid or alkali. When these types of cleaners are used to clean the wheels on mazda vehicles, the chemicals contents penetrate the clear coating of the wheel surface and damage the paint under the clear coating. The damaged area has the appearance of dark stains.
• 10105481Aug 7, 2015Equipment. Mazda infotainment systems require contacting the proper source for diagnostic support, parts authorization, and parts exchange. Some components require prior authorization before ordering as exchange. Refer to dag exchange central (mxconnect>parts and accessories>parts>programs>exchange central) for component availability, source of technical support and prior authorization requirement.
• 10100708Feb 27, 2015Equipment. Use the following repair procedure to minimize the need to replace the catalyst converter/exhaust pipe when removing oxygen sensors and/or air fuel ratio sensors.
• 10098885Nov 24, 2014Exterior lighting. When dealing with customer complaints of excessive condensation and/or water within the headlamp unit, first determine if all the bulb sockets are present and correctly installed. In most cases you will find that the bulb seal no. 1 (a) or hid bulb seal no. 1 (b) and bulb seal no.
• 10098895Nov 4, 2014Steering. Some customers may complain that the steering wheel is off center more than 3° even when driving straight on a flat road. Follow steering wheel alignment procedure.
• 10059471Nov 4, 2014Steering. Summary to be provided on a future date.
• 10098543Sep 9, 2014Equipment. Some vehicles may exhibit a whining noise from the rear differential when driving.the concern may be caused by improper tooth contact pattern of the rear differential gear from abnormal wear. This abnormal wear is caused by gear tooth lapping compound (used during the production) being left on beyond the allowable amount. The production control has been improved to reduce the amount of remaining lapping compound.
• 10061517Sep 9, 2014Equipment. Summary to be provided on a future date.
• 10059486Sep 9, 2014Transmission and drivetrain. Summary to be provided on a future date.
• 10098367Aug 15, 2014Equipment. In accordance with federal regulations, follow the procedure listed below when replacing a speedometer.note:•mazda vehicles are manufactured with tamper-proof speedometers.•when a speedometer is replaced, the new speedometer will read zero (0) miles.•this procedure is extremely important to accurately represent actual vehicle mileage.•prior to speedometer removal, complete the information required on the…
• 10098282Jun 10, 2014Equipment. This service bulletin provides information regarding the proper use of the driver’s floor mat to avoid any potential interference with the foot pedals. The following are possible causes of floor mat interference, which can be avoided with proper usage. • floor mat moves forward due to improper installation. • inappropriate floor mat (such as aftermarket, non-factory-equipped, or non-genuine) is used. • floor mat is…
• 10098245Jun 10, 2014Equipment. Mazda north american operations received many requests from our dealers asking us to approve additional on-car brake lathes as an option for mnao authorized equipment. Due to your feedback and after evaluating a few on-car brake lathes, we are pleased to announce that we have added the pro cut on-car brake lathe to mnao authorized equipment program. The accu-turn is still an approved brake lathe but it is no longer…
• 10098103May 20, 2014Brakes. Some vehicles exhibit brake related concerns such as brake noise, brake judder or brake dragging. If you encounter a customer complaint for any one of these symptoms, refer to the following information to understand why symptoms may occur, and to better assist the customer in resolving their specific brake concern.
• 10098022Feb 14, 2014Equipment. When replacing the siriusxm satellite radio unit (or a mazda connect tuner and amp unit (tau)) with replacement tuner for any reason, a call must be made to inform siriusxm of the existing radio id and the new/ replacement sat radio id as soon as possible to ensure the customer leaves the dealership with active (working sat radio.
• 10097982Jan 24, 2014Exterior lighting. Some customers may complain of condensation/fog inside the front or rear combination lights. The recent new models have been fitted with a clear lens which can cause the symptom to be more noticeable, however, it does not affect the performance of the light. This condensation/fog is a natural phenomenon that occurs when there is a fairly large temperature difference between the inside and the outside of the light…
• 10098003Jan 21, 2014Brakes. Some customers may report a slight clunk/bang/buzz noise or jolt from the front of the vehicle. This concern will most likely occur during the vehicles first forward movement after starting the engine. This is a normal operating noise of the anti-lock brake system (abs). Do not attempt any repairs.
• 10110991Nov 19, 2013Air bags, Electrical system. This information is provided to help address Passenger Airbag Deactivation (PAD) Indicator illumination con-cerns during vehicle service.
• 10054788Nov 19, 2013Air bags. Mazda: information provided regarding the indicator light illumination of the passenger airbag deactivation (pad).
• 10110996Nov 11, 2013Brakes. Some vehicles exhibit brake related concerns such as brake noise, brake judder or brake dragging. If you encounter a customer complaint for any one of these symptoms, refer to the following information to understand why symptoms may occur, and to better assist the customer in resolving their specific brake concern.
• 10110995Nov 11, 2013Wheels. Some automotive cleaning products contain strong acid or alkali. When these types of cleaners are used to clean the wheels on Mazda vehicles, the chemicals contents penetrate the clear coating of the wheel surface and damage the paint under the clear coating. The damaged area has the appearance of dark stains.Use extra care when cleaning wheels.
• 10097805Oct 28, 2013Equipment. A musty/mildew type odor may come from the vents when the air conditioning (a/c) system is operating. It is most noticeable when the a/c is first turned on. This odor is the result of mold growth in the a/c evaporator/cooling unit which is caused by condensation, dust, and pollen within the cooling unit. This condition is usually worse during high humidity conditions. “mazda air cooling coil coating” is available…
• 10097722Aug 22, 2013Steering. Some customers may complain that the steering wheel is off center more than 3° even when driving straight on a flat road.
• 10097375Apr 17, 2013Equipment. Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner’s manual. Services performed outside of mazda’s factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers.
• 10097377Apr 10, 2013Steering. Some customers may complain that the steering wheel is off center more than 3° even when driving straight on a flat road.
• 10097348Mar 11, 2013Transmission and drivetrain. Always be sure to use the correct automatic transmission fluid when replacing atf. Using the wrong atf may cause shift quality complaints or may even damage the transmission.note:•atf m-v (type m5) is not the same fluid as mercon®v or mercon®lv atf.•atf m-v (type m5) has a greater viscosity than mercon®v and mercon®lv atf in low temperatures.
• 10097343Mar 11, 2013Equipment. This service bulletin provides information regarding the proper use of the driver’s floor mat to avoid any poten-tial interference with the foot pedals. The following are possible causes of floor mat interference, which can be avoided with proper usage.•floor mat moves forward due to improper installation.•inappropriate floor mat (such as aftermarket, non-factory-equipped, or non-genuine) is used.•floor mat is…
• 10052155Mar 11, 2013Equipment. Mazda: on some vehicles, to avoid potential interference of foot placed on pedals, information is provided regarding proper use, and placement, of driver's floor mat. Various models and model years.
• 10097369Mar 4, 2013Equipment. When dealing with customer complaints of excessive condensation and/or water within the headlamp unit, first determine if all the bulb sockets are present and correctly installed. In most cases you will find that the bulb seal no. 1 (a) or hid bulb seal no. 1 (b) and bulb seal no.
• 10052160Mar 4, 2013Exterior lighting. Mazda: on various model years and model vehicles, the headlamp assembly would have excessive condensation or water within and should be checked and replaced, if necessary for correct installation.
• 10097320Feb 19, 2013Steering. Some customers may complain that the steering wheel is off center more than 3° even when driving straight on a flat road.
• 10097277Jan 30, 2013Equipment. The front disc plate fixing screws (a) have been discontinued. With this change, the disc plate (b) and wheel hub (c) have been modified without fixing holes, eliminating the need for the fixing screws (a).
• 10059487Jan 30, 2013Brakes. Summary to be provided on a future date.
• 10097295Jan 15, 2013Equipment. Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner’s manual. Services performed outside of mazda’s factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers.
• 10097300Jan 14, 2013Equipment. Some customers may complain of signs of oil on the struts or shock absorbers. In most cases the oil that is present is normal, and a result of the oil that remains on the shaft during the normal sweeping process of the shaft seal. Follow the inspection guidelines to determine if the condition is a result of the normal sweeping process or a failure of the shaft seal.
• 10097941Dec 21, 2012Exterior lighting. Some customers may complain of condensation/fog inside the front or rear combination lights. The recent new models have been fitted with a clear lens which can cause the symptom to be more noticeable, however, it does not affect the performance of the light. This condensation/fog is a natural henomenon that occurs when there is a fairly large temperature difference between the inside and the outside of the light…
• 10097942Dec 19, 2012Equipment. Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner’s manual. Services performed outside of mazda’s factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers.
• 10046279Oct 3, 2012Engine. Mazda: some vehicles experiences no start or engine stall condition that may be difficult to duplicate and should have aftermarket electronic devices checked. Model 2008-13 mx-5.
• 10043662Jan 11, 2012Tires. Mazda: tpms warning light illumindated. This may be caused by damage to the valve nut and/or valve stem of the wheel.
• 10034634Feb 23, 2011Engine cooling. Mazda: variable valve timing (vvt) noise when starting engine. When engine is first started, some vehicles may exhibit a loud ticking noise from the variable valve timing (vvt) (a). This is caused by the lock pin of the variable valve timing actuator not fully engaging or from a worn lock pin hole. *pe updated on 06/08/2011.
• 10037949Feb 7, 2011Exterior lighting. Mazda: there is possible excessive condensation or water inside the headlamp unit on many mazda models.
• 10037655Dec 23, 2010Exterior lighting. Mazda: there is condensation and fog in the front and rear combination lights.
• 10037266Oct 15, 2010Body and structure. Mazda: some vehicles with soft tops may experience water accumulation in the footwells, because the drains are clogged with debris.
• 10034005Oct 15, 2010Fuel system. Mazda: determining evaporative system leak location for dtcs p0441, p0442, p0455, p0455. Some vehicles may have a mil illumination with dtcs stored in memory. *pe updated 4/18/11.
• 10030350May 15, 2009Equipment, Body and structure. Mazda: water accumulation in footwell/plugged soft top drains. Some vehicles equipped with the folding soft top may experience water accumulation in the foot wells due to the soft top drains becoming clogged with leaves and other debris.
• 10028524Feb 11, 2009Engine cooling. Mazda: vehicles may exhibit a concern of unstable idling or, in some rare cases, stalling, just after the vehicle stops with no dtcs detected. Problem is due to the accumulation of carbon deposits inside the throttle body causing air flow to decrease.
• 10026042Jul 11, 2008Transmission and drivetrain. Mazda: vehicles may experience the mil on with dtc p0507 set. P0507 idle air control system rpm higher than expected. (transmission) (mt - mil on - p0507 set).

← All problems reported for the 2008 Mazda MX-5