2005 Mazda RX-8 Technical Service Bulletins

178 technical service bulletins (TSBs) are on record for the 2005 Mazda RX-8. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10091406Mar 30, 2016Equipment. When installing a navigation sd card, confirm that the card is unlocked. Also, mazda does not recommend swapping navigation system sd cards from one vehicle to another for testing. If swapped, the sd card that is installed into the other vehicle becomes “linked” to the vin of that vehicle.
• 10091393Mar 30, 2016Visibility (wipers, defrost, mirrors). This article provides hvac heater/defroster operating tips using mode selector dial. This includes the use of intermediate positions.
• 10091265Mar 30, 2016Equipment. When installing a navigation sd card, confirm that the card is unlocked. Also, mazda does not recommend swapping navigation system sd cards from one vehicle to another for testing. If swapped, the sd card that is installed into the other vehicle becomes “linked” to the vin of that vehicle.
• 10091263Mar 30, 2016Visibility (wipers, defrost, mirrors). This article provides hvac heater/defroster operating tips using mode selector dial. This includes the use of intermediate positions.
• 10185969Mar 24, 2016Equipment. Some customers may complain about a rattle type noise coming from the rear of the vehicle when driving on rough roads. This may be caused by a loose spare tire jack.
• 10185968Mar 24, 2016Equipment, Electrical system. Some customers may complain about a blurry rear view monitor display. This may be caused by an aftermarket accessory device.
• 10091433Mar 24, 2016Equipment. Some customers may complain about a blurry rear view monitor display. This may be caused by an aftermarket accessory device
• 10091361Mar 24, 2016Equipment. Some customers may complain about a rattle type noise coming from the rear of the vehicle when driving on rough roads. This may be caused by a loose spare tire jack.
• 10091266Mar 24, 2016Equipment. Some customers may complain about a blurry rear view monitor display. This may be caused by an aftermarket accessory device.
• 10185904Mar 7, 2016Steering. Some customers may complain that the steering wheel is off center more than 3" even when driving straight on a flat road.
• 10101062Mar 7, 2016Steering. Some customers may complain that the steering wheel is off center more than 3° even when driving straight on a flat road.
• 10090812Mar 7, 2016Steering. Some customers may complain that the steering wheel is off center more than 3° even when driving straight on a flat road.
• 10213429Feb 26, 2016Equipment. Paint damage Mazda pocket paint guide
• 10213326Feb 26, 2016Equipment. Mazda guidelines for factory scheduled maintenance
• 10105891Feb 26, 2016Brakes. Some vehicles exhibit brake related concerns such as brake noise, brake judder or brake dragging. If you encounter a customer complaint for any one of these symptoms, refer to the following information to understand why symptoms may occur, and to better assist the customer in resolving their specific brake concern.
• 10213425Feb 17, 2016Electrical system. Speedometer replacement procedure
• 10213333Feb 15, 2016Equipment, Electrical system. Battery test procedure requirements using the GR81291
• 10213422Feb 2, 2016Equipment. Proper usage of driver's floor mat.
• 10100888Jan 25, 2016Exterior lighting. Some customers may complain of condensation/fog inside the front (headlamp/headlight) or rear (taillamp/tail-light) combination lights. The recent new models have been fitted with a clear lens which can cause the symp-tom to be more noticeable, however, it does not affect the performance of the light. This condensation/fog is a natural phenomenon that occurs when there is a fairly large temperature difference…
• 10105855Jan 8, 2016Wheels. Some automotive cleaning products contain strong acid or alkali. When these types of cleaners are used to clean the wheels on mazda vehicles, the chemicals contents penetrate the clear coating of the wheel surface and damage the paint under the clear coating. The damaged area has the appearance of dark stains.
• 10105481Aug 7, 2015Equipment. Mazda infotainment systems require contacting the proper source for diagnostic support, parts authorization, and parts exchange. Some components require prior authorization before ordering as exchange. Refer to dag exchange central (mxconnect>parts and accessories>parts>programs>exchange central) for component availability, source of technical support and prior authorization requirement.
• 10100708Feb 27, 2015Equipment. Use the following repair procedure to minimize the need to replace the catalyst converter/exhaust pipe when removing oxygen sensors and/or air fuel ratio sensors.
• 10098895Nov 4, 2014Steering. Some customers may complain that the steering wheel is off center more than 3° even when driving straight on a flat road. Follow steering wheel alignment procedure.
• 10059471Nov 4, 2014Steering. Summary to be provided on a future date.
• 10061487Aug 22, 2014Electrical system. Summary to be provided on a future date.
• 10098367Aug 15, 2014Equipment. In accordance with federal regulations, follow the procedure listed below when replacing a speedometer.note:•mazda vehicles are manufactured with tamper-proof speedometers.•when a speedometer is replaced, the new speedometer will read zero (0) miles.•this procedure is extremely important to accurately represent actual vehicle mileage.•prior to speedometer removal, complete the information required on the…
• 10098282Jun 10, 2014Equipment. This service bulletin provides information regarding the proper use of the driver’s floor mat to avoid any potential interference with the foot pedals. The following are possible causes of floor mat interference, which can be avoided with proper usage. • floor mat moves forward due to improper installation. • inappropriate floor mat (such as aftermarket, non-factory-equipped, or non-genuine) is used. • floor mat is…
• 10098245Jun 10, 2014Equipment. Mazda north american operations received many requests from our dealers asking us to approve additional on-car brake lathes as an option for mnao authorized equipment. Due to your feedback and after evaluating a few on-car brake lathes, we are pleased to announce that we have added the pro cut on-car brake lathe to mnao authorized equipment program. The accu-turn is still an approved brake lathe but it is no longer…
• 10098121May 20, 2014Equipment. Some customers may complain that the ambient temperature display is not accurate, or it takes too long for the display to show actual temperature.when you encounter a customer with this concern, first verify the condition when the customer noticed this symptom.
• 10098103May 20, 2014Brakes. Some vehicles exhibit brake related concerns such as brake noise, brake judder or brake dragging. If you encounter a customer complaint for any one of these symptoms, refer to the following information to understand why symptoms may occur, and to better assist the customer in resolving their specific brake concern.
• 10098022Feb 14, 2014Equipment. When replacing the siriusxm satellite radio unit (or a mazda connect tuner and amp unit (tau)) with replacement tuner for any reason, a call must be made to inform siriusxm of the existing radio id and the new/ replacement sat radio id as soon as possible to ensure the customer leaves the dealership with active (working sat radio.
• 10097982Jan 24, 2014Exterior lighting. Some customers may complain of condensation/fog inside the front or rear combination lights. The recent new models have been fitted with a clear lens which can cause the symptom to be more noticeable, however, it does not affect the performance of the light. This condensation/fog is a natural phenomenon that occurs when there is a fairly large temperature difference between the inside and the outside of the light…
• 10098003Jan 21, 2014Brakes. Some customers may report a slight clunk/bang/buzz noise or jolt from the front of the vehicle. This concern will most likely occur during the vehicles first forward movement after starting the engine. This is a normal operating noise of the anti-lock brake system (abs). Do not attempt any repairs.
• 10097967Dec 19, 2013Seats. Some vehicles may exhibit a chattering noise and the driver-side seat lift cannot be adjusted because the lock plate guide comes off the guide cam when operating the lift. If the lift lever is then operated with the lock plate guide off, the guide cam can be damaged. The shape of both ends of the guide cam has now been changed to stop the lock plate guide from coming off.
• 10110991Nov 19, 2013Air bags, Electrical system. This information is provided to help address Passenger Airbag Deactivation (PAD) Indicator illumination con-cerns during vehicle service.
• 10110996Nov 11, 2013Brakes. Some vehicles exhibit brake related concerns such as brake noise, brake judder or brake dragging. If you encounter a customer complaint for any one of these symptoms, refer to the following information to understand why symptoms may occur, and to better assist the customer in resolving their specific brake concern.
• 10110995Nov 11, 2013Wheels. Some automotive cleaning products contain strong acid or alkali. When these types of cleaners are used to clean the wheels on Mazda vehicles, the chemicals contents penetrate the clear coating of the wheel surface and damage the paint under the clear coating. The damaged area has the appearance of dark stains.Use extra care when cleaning wheels.
• 10097722Aug 22, 2013Steering. Some customers may complain that the steering wheel is off center more than 3° even when driving straight on a flat road.
• 10097394Jun 4, 2013Equipment. Some customers may complain that the ambient temperature display is not accurate, or it takes too long for the display to show actual temperature. When you encounter a customer with this concern, first verify the condition when the customer noticed this symptom.
• 10097375Apr 17, 2013Equipment. Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner’s manual. Services performed outside of mazda’s factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers.
• 10097377Apr 10, 2013Steering. Some customers may complain that the steering wheel is off center more than 3° even when driving straight on a flat road.
• 10097343Mar 11, 2013Equipment. This service bulletin provides information regarding the proper use of the driver’s floor mat to avoid any poten-tial interference with the foot pedals. The following are possible causes of floor mat interference, which can be avoided with proper usage.•floor mat moves forward due to improper installation.•inappropriate floor mat (such as aftermarket, non-factory-equipped, or non-genuine) is used.•floor mat is…
• 10052155Mar 11, 2013Equipment. Mazda: on some vehicles, to avoid potential interference of foot placed on pedals, information is provided regarding proper use, and placement, of driver's floor mat. Various models and model years.
• 10097320Feb 19, 2013Steering. Some customers may complain that the steering wheel is off center more than 3° even when driving straight on a flat road.
• 10097295Jan 15, 2013Equipment. Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner’s manual. Services performed outside of mazda’s factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers.
• 10097300Jan 14, 2013Equipment. Some customers may complain of signs of oil on the struts or shock absorbers. In most cases the oil that is present is normal, and a result of the oil that remains on the shaft during the normal sweeping process of the shaft seal. Follow the inspection guidelines to determine if the condition is a result of the normal sweeping process or a failure of the shaft seal.
• 10097941Dec 21, 2012Exterior lighting. Some customers may complain of condensation/fog inside the front or rear combination lights. The recent new models have been fitted with a clear lens which can cause the symptom to be more noticeable, however, it does not affect the performance of the light. This condensation/fog is a natural henomenon that occurs when there is a fairly large temperature difference between the inside and the outside of the light…
• 10097942Dec 19, 2012Equipment. Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner’s manual. Services performed outside of mazda’s factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers.
• 10059870Dec 19, 2012Engine, Equipment. Summary to be provided on a future date.
• 10097754Oct 19, 2012Equipment. The multi information display (mid) and navigation system support for diagnostics, parts authorization, and parts exchange require contacting the proper source. Please contact the appropriate source by referring to the following tables.

← All problems reported for the 2005 Mazda RX-8