2014 MINI Cooper Technical Service Bulletins

431 technical service bulletins (TSBs) are on record for the 2014 MINI Cooper. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10150203Nov 1, 2013Engine cooling. N16 Engine: FC 2D9B Knock Sensor, Signal Is Stored in the DME. Certain areas of the US experience extremely cold climate conditions during the winter months, which can cause the Service Engine Soon lamp to illuminate while the engine temperature is increasing to full operating temperature. The following fault may be stored in the DME: ??FC 2D9B Knock Sensor, Signal CAUSE Unfavorable DME knock sensor diagnostic at…
• 10150198Nov 1, 2013Body and structure. This is an update to the Delivery Stop that was issued on certain 2014 model year MINI Cooper, Cooper S and John Cooper Works Convertibles produced between July and October 2013. During closing, it is possible that the convertible top locating pin is not correctly positioned in the landing plate, at the top of the A-pillar (passenger?s side). The repair procedure is pending the release of warranty information which…
• 10150190Nov 1, 2013Equipment. This is an update to the Delivery Stop that was issued on certain 2014 model year MINI Cooper, Cooper S and John Cooper Works Convertibles produced between July and October 2013. During closing, it is possible that the convertible top locating pin is not correctly positioned in the landing plate at the top of the A-pillar (passenger?s side). The repair procedure is now available in Service Information bulletin M54…
• 10150309Oct 1, 2013Seats. Squeaking Noise from Front Seat. A noise may be heard from the front driver's seat back when the customer applies sideways pressure during cornering. CAUSE Surface corrosion on the metal seat back frame can make a squeaking noise when rubbing against the foam rubber padding of the seat back.
• 10150307Oct 1, 2013Body and structure. Creaking/Cracking Noise from the Upper Roof Area. A creaking noise can be heard from the rear roof area when driving on rough roads or uneven surfaces. CAUSE The body shell roof support area, where the C-pillar is joined to the roof, is buckling, creating the noise.
• 10150305Oct 1, 2013Wheels. Adjusting Rear Camber. Rear camber cannot be adjusted properly. CAUSE Repair instructions not followed properly
• 10152363Sep 1, 2013Latches, locks and linkages. Convertible Top Cannot Be Locked or Secured when Fully Opened or Closed. The convertible top cannot be locked or secured when it is in the fully opened or closed position. CAUSE Folding sunroof drive unit hardware error
• 10152362Sep 1, 2013Engine cooling. "Service Action: Retrofit of the Engine Coolant Temperature Sensor. Internal corrosion could form in the engine coolant temperature sensor. This corrosion leads to internal bridging of the contacts, which can cause an inaccurate engine temperature reading. This false reading could lead to difficulty in the engine starting and/or a ""Service Engine Soon"" lamp being illuminated."
• 10150241Aug 1, 2013Equipment. Incorrect Customer Relations Telephone Number Is Saved in the Vehicle. The customer is not connected to MINI Customer Relations after dialing the number displayed in the vehicle Kombi or radio. CAUSE During the Pre-Delivery Inspection (PDI), the incorrect telephone number is being written into the vehicle. INFORMATION 1. When performing the PDI test plan, it is extremely important that you select MINI if the ISID…
• 10150237Aug 1, 2013Electrical system. ?N18 Engine: FC 2BF2 Rail Pressure Sensor Is Stored in DME Fault Memory. The customer states that the Service Engine Soon lamp is illuminated and the following fault is stored in the DME: FC 2BF2 Rail pressure sensor, workspace: pressure too high CAUSE A DME calibration error in the fuel pressure diagnostics results in an increased sensitivity.
• 10150268Jul 1, 2013Electrical system. Battery Charge Condition Not Available in Energy Diagnosis. When performing an Energy Diagnosis test plan, the battery charge condition information is not available. CAUSE The power management system was not reset properly at the end of vehicle production, leaving the IBS in a failsafe mode.
• 10150043Jul 1, 2013Equipment. Vehicle Document Pouch Missing. The pouch in which the vehicle documents (e.g., Owner's Manual, Service and Warranty booklet, tire manufacturer warranty CD, etc.) are to be inserted during QC1 may be missing from the some of the vehicles in this production period. CAUSE There was a temporary supply shortage during a change of pouch suppliers.
• 10150091Jun 1, 2013Equipment, Electrical system. "DWA (Anti-theft Alarm System): False Alarm Is Triggered Intermittently. INFORMATION Parts replacement will not solve the problem if one or more of the conditions described in the situation above caused the alarm to trigger. The sensitivity of the interior ultrasonic sensor cannot be reduced.
• 10150087Jun 1, 2013Engine. The customer states that a small engine oil leak can be seen from the underside of the engine. CAUSE The internal sealing of the oil pump volume control solenoid valve is compromised, allowing engine oil to leak from the oil pump volume control solenoid.
• 10149624May 1, 2013Equipment. "Harman Kardon HiFi Amplifier: Audio Output Is Inoperative. The audio output is inoperative, intermittently or permanently. * The display is illuminated * All buttons are working * Fault Code ""0xA1A8 - Device has over temperature"" is stored in the Harman Kardon HiFi amplifier (AMPHH2) Hardware fault in the HiFi amplifier"
• 10149623May 1, 2013Vehicle speed control, Electrical system. "Discharged Battery: Energy Diagnosis Must Be Performed. MINI electrical systems and advancements in vehicle technology have resulted in an increased demand on the vehicle battery. This SI will help the dealer handle ""discharged battery"" complaints. A discharged battery can have various causes, most unrelated to the battery. A failed battery is often the symptom and not the cause.
• 10149622May 1, 2013Electrical system. Change in Thermostat Electrical Connector on Replacement Engine Harness. Vehicles produced from 3/2013 are no longer equipped with an engine coolant thermostat that incorporates the engine coolant temperature sensor (thermostat P/N 11 53 7 647 751). The engine coolant temperature sensor is now an individual component.
• 10149505Apr 1, 2013Equipment, Body and structure. "White Wear Marks on Canvas Top. Wear marks appear on the convertible top on the left and/or right side C-pillar areas. A For vehicles produced to December 12, 2011 1. Replace the defective canvas convertible top. Refer to ISTA Repair Instruction 54 34 120, ""Replacing soft top fabric."" Note: The following repair steps must be performed before the new top is installed to prevent a repeat repair for wear marks. 2.
• 10149502Apr 1, 2013Electrical system, Engine. SI M12 02 12 Engine Electrical Systems April 2013 Technical Service . After reprogramming the vehicle to integration level R056-11-11-503 (ISTA/P P45.1.3.0) or higher, one of the following fault codes are stored in the DME fault memory: Vehicles with N16 engine: * 2F42 Engine ventilation heating, Control The Service Engine Soon lamp is not illuminated. Vehicles with N18 engine: * 37DE Engine ventilation, heating…
• 10149501Apr 1, 2013Engine cooling. Service Action: Replace the Coolant Pump. Coolant is leaking from the coolant pump. CAUSE The coolant pump may develop cracks in the plastic housing. These cracks may result in a coolant leak.
• 10149500Apr 1, 2013Engine. Engine Oil Leak. The customer states that a small engine oil leak can be seen from the underside of the engine. CAUSE The internal sealing of the oil pump volume control solenoid valve is compromised, allowing engine oil to leak from the oil pump volume control solenoid.
• 10149468Feb 1, 2013Engine cooling. CHAMP2: Integrated Cooling Fan Is Noisy Intermittently. INFORMATION Do not replace parts and do not perform a repair attempt! Explain to the customer that this only happens at high ambient temperatures, which keep the fan running after the ignition is turned off. This Service Information will be updated as soon as a solution is available. A software solution is expected to be available with ISTA/P 2.49.0 in March…
• 10149465Feb 1, 2013Steering. Noise from Steering Column when Turning or Adjusting Height. A squeaking noise is heard from the area around the steering column when turning or adjusting its height. CAUSE Material contact between the upper steering column bearing inner race and the plastic sleeve
• 10149464Feb 1, 2013Engine cooling. "N16 Engine: FC 2D9B Knock Sensor, Signal Is Stored in the DME. Certain areas of the US experience extremely cold climate conditions during the winter months, which can cause the Service Engine Soon lamp to illuminate while the engine temperature is increasing to full operating temperature.
• 10149332Jan 1, 2013Brakes. Erroneous "Service due" Message Though Brake Lining Thickness Sufficient. The CBS data calculated for the remaining distance of the front and/or rear brake pads does not agree with the actual brake pad thickness. The yellow brake lining service due indicator illuminates even though the pad thickness is greater than the minimum wear limit (approximately 3.7 mm); the brake wear sensor has not yet been activated (from…
• 10149330Jan 1, 2013Suspension. Cracking or Popping Noise from Rear Axle. A cracking or popping noise is heard from the rear axle during take-offs or during load reversal. CAUSE Rear axle nut incorrectly torqued
• 10149329Jan 1, 2013Suspension. Cracking or Popping Noise from Front Axle. A cracking or popping noise is heard from the front axle during take-offs or during load reversal CAUSE Front axle nut not correctly torqued
• 10149327Jan 1, 2013Engine cooling. Service Action: Retrofit of the Engine Coolant Temperature Sensor. Internal corrosion could form in the engine coolant temperature sensor. This corrosion leads to internal bridging of the contacts, which can cause an inaccurate engine temperature reading. This false reading could lead to difficulty in the engine starting and/or a "Service Engine Soon" lamp being illuminated.
• 10149326Jan 1, 2013Engine cooling. Service Action: Retrofit of the Engine Coolant Temperature Sensor. Internal corrosion could form in the engine coolant temperature sensor. This corrosion leads to internal bridging of the contacts, which can cause an inaccurate engine temperature reading. This false reading could lead to difficulty in the engine starting and/or a "Service Engine Soon" lamp being illuminated.
• 10149325Jan 1, 2013Engine cooling. Service Action: Retrofit of the Engine Coolant Temperature Sensor. Internal corrosion could form in the engine coolant temperature sensor. This corrosion leads to internal bridging of the contacts, which can cause an inaccurate engine temperature reading. This false reading could lead to difficulty in the engine starting and/or a "Service Engine Soon" lamp being illuminated.
• 10149323Jan 1, 2013Engine. Engine Oil Leak. The customer states that a small engine oil leak can be seen from the underside of the engine. CAUSE The internal sealing of the oil pump volume control solenoid valve is compromised, allowing engine oil to leak from the oil pump volume control solenoid.

← All problems reported for the 2014 MINI Cooper