2004 Mitsubishi Lancer Suspension Problems

“I was going to replace the front control arms on my own but now I am only going to be able to replace the front passenger control arm because the driver side control arm is corroded and the bolt does not come out. I was going to buy the crossmember myself but than a family member showed me a link that says this crossmember on my model could be a recall. Before I realized how corroded it was I took it to a dealership due to a recall on the passenger air bag and the dealership replace it and they sprayed some anti-corrosion on the crossmember but forgot to mention the hole the crossmember had. …”

“The contact owns a 2004 Mitsubishi Lancer. While driving 25 MPH, the vehicle independently stopped on a train track. The vehicle was towed to an independent mechanic where it was diagnosed that the subframe, steering control arm, and tie rod failed and needed to be replaced. The manufacturer was not notified of the failure. The failure mileage was approximately 80,000.”

“The contact owns a 2004 Mitsubishi Lancer. The contact stated that the vehicle was pulling to one side and the tires were worn down. The vehicle was taken to an independent tire facility where it was diagnosed that the cross member needed to be replaced. The manufacturer was contacted and stated that the vehicle was not included in NHTSA campaign number: 16v458000 (suspension). No further assistance was provided. The dealer was not contacted. The vehicle was not repaired. The approximate failure mileage was 148,000.”

“2004 Mitsubishi Lancer wagon. Consumer writes in regards to corrosion of lower control arm safety recall. The consumer stated while backing out of a parking space, the vehicle backed into a truck at a high speed. Updated 09/12/2017 updated 10/19/17 the consumer stated the vehicle was totaled. Updated 11/1/2017”

“The contact owns a 2004 Mitsubishi Lancer. The contact stated that the recall notice for NHTSA campaign number: 16v458000 (suspension) was received on june 23, 2016 regarding corrosion affecting the control arm. The contact stated that the exhaust system corroded and made noise. The dealer diagnosed that the exhaust fell outside of the scope of the recall. The manufacturer was not notified of the failure. The failure mileage was unknown. Updated 12/20/16”