2016 Nissan Quest Technical Service Bulletins

130 technical service bulletins (TSBs) are on record for the 2016 Nissan Quest. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10109214Mar 20, 2017Fuel system. NISSAN; FUEL TANK IS SLOW OR DIFFICULT TO FILL IF YOU CONFIRM The fuel tank is slow or difficult to fill (filling nozzle shuts off before tank is full). IMPORTANT: Make sure this incident has been duplicated at a gas station by dealer service staff. ACTION Perform the Service Procedure in this bulletin, starting on the next page.
• 10109159Jan 27, 2017Equipment, Engine. NISSAN; OIL LEAKING AROUND VALVE TIMING CONTROL SOLENOID VALVE This bulletin applies only to Maxima, Quest, Altima Coupe, Altima, Pathfinder and Murano vehicles equipped with V6 engine OR Titan/Titan XD equipped with VK56 engine IF YOU CONFIRM Engine oil is leaking from a valve timing control solenoid valve, And The valve timing control solenoid valve operates correctly and is not externally damaged.
• 10109114Dec 14, 2016Equipment. PLASTIC INTERIOR TRIM PROTECTIVE COVERING REMOVAL SERVICE INFORMATION Vehicles are delivered with plastic interior trim protective covering on the front and rear seats, front and rear door panel finishers, steering wheel, and sun visors (see examples on page 2). When removing the protective covering, care must be used to avoid scuffs, scrapes, cuts, and other abrasive contact to interior trim components. DO NOT use…
• 10119282Nov 28, 2016Engine. NISSAN; DIAGNOSIS INFORMATION FOR ABS DTC C1130 SERVICE INFORMATION When diagnosing for DTC C1130 (ENGINE SIGNAL): ECM related DTCs (P-codes) must be diagnosed, repaired, and DTCs erased first. - DTC C1130 is an ABS DTC that indicates an output signal of the ECM is not recognized. - Absent or incorrect ECM signals, that are indicated by corresponding P-codes, may trigger C1130 in the ABS control unit.
• 10119281Nov 18, 2016Suspension. ESM CORRECTIONS FOR FRONT WHEEL ALIGNMENT SPECIFICATIONS SERVICE INFORMATION For the Applied Vehicles listed above, some front wheel alignment specifications listed in the Electronic Service Manual (ESM), section FSU-Front Suspension, are listed incorrectly and have been corrected. - Updated ESMs will be distributed to the field as quickly as possible. - Until the updated ESMs are made available, please use the…
• 10091528Aug 25, 2016Transmission and drivetrain. "enhanced diagnostic logic for cvt pathfinder and altima with v6 engine only if you confirm the customer reports a transmission judder (shake, shudder, single or multiple bumps or vibration). Note: a new diagnostic logic has been established to enhance the diagnostic process by storing diagnostic trouble codes (dtcs) on applied vehicles. The new dtcs are: p17f1 (cvt_judder [c/u inspection]) p17f0 (cvt_judder [t/m…
• 10091503Aug 4, 2016Equipment. "all model year 2012 and newer nissan vehicles; evap leak dtc p0442, p0455, p0456 information this bulletin has been amended. The title has been revised, and the bulletin now includes vehicles in production as of the date of this update. No other changes have been made. Please discard all previous versions of this bulletin."
• 10091072Jul 29, 2016Electrical system. "rear o2 sensor voluntary emissions recall campaign ***** campaign summary ***** nissan is conducting a voluntary emissions recall campaign to update the electronic control module (ecm) software on certain model year 2016 nissan maxima (a36), and model year 2015-16 altima (l33), juke (f15), pathfinder (r52), murano (z52) and quest (e52) vehicles.
• 10091322Jul 28, 2016Engine. "voluntary emissions recall campaign ecm reprogramming introduction nissan is conducting a voluntary emission recall campaign on certain model year 2015-2016 altima, 2015-2016 juke, 2016 maxima, 2015-2016 murano, 2015-2016 quest, and 2015-2016 pathfinder vehicles. Nissan has discovered that these vehicles are equipped with an on-board diagnostics (obd) calibration that, if not repaired, may not detect a rear oxygen…
• 10192841Jun 9, 2016Electrical system, Transmission and drivetrain. SERVICE INFORMATION The Service Procedure (starting on page 2) in this bulletin contains the steps to perform TCM Calibration Data Write Procedures. These procedures are used when a complete CVT is replaced, or a CVT control valve (valve body) is replaced, or a Transmission Control Module (TCM) is replaced. See this bulletin for further detail.
• 10192840Jun 9, 2016Tires, Equipment. SERVICE INFORMATION Temporary tire Flat Spotting is common on New Dealer In-Stock vehicles that have not been occasionally moved. Flat Spotting can occur after the vehicle has been parked (not moved) for a few days, or longer. In most cases it is temporary. In extreme cases it can be permanent. Vehicles should be moved every 30 days, in one direction only, enough to rotate the tires 90° (see Figure 1). Moving…
• 10192833Jun 2, 2016Transmission and drivetrain, Equipment. IMPORTANT: Metal debris and friction material may become trapped in the radiator, cooling hoses, bypass valve or external CVT fluid cooler. This debris can contaminate the newly serviced transmission, control valve or torque converter. In severe cases this debris can block or restrict flow and may cause damage to the newly serviced CVT.
• 10192816Apr 29, 2016Equipment, Transmission and drivetrain. IF YOU CONFIRM: The customer reports a transmission judder (shake, shudder, single or multiple bumps or vibration) AND One of these DTCs is stored: - P17F0 (CVT_JUDDER (T/M INSPECTION)) - P17F1 (CVT_JUDDER (C/U INSPECTION)) NOTE - If a transmission judder (as described above) is not reported, this bulletin does not apply. - If either P17F0 or P17F1 are not stored, this bulletin does not apply. - NTB15-014, Enhanced…
• 10192805Apr 18, 2016Equipment. IF YOU CONFIRM A refrigerant leak at a refrigerant pipe/hose joint location. ACTIONS 1. Inspect the metal surfaces of the pipe/hose joint for damage or contamination. NOTE: Do not replace a refrigerant pipe, hose, or other A/C component if an o-ring seal will solve the leak incident, if it should occur. 2. If no damage is found to the joint metal surfaces, replace the O-ring seal. See this bulletin for further…
• 10192801Apr 13, 2016Equipment, Forward collision avoidance. SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement "Certification Label" or "VIN Plate / Label" may be needed. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. See this bulletin for further detail.
• 10194179Apr 7, 2016Transmission and drivetrain. Nissan; Procedure to clean CVT Transmission fluid coolers
• 10194181Mar 31, 2016Transmission and drivetrain. Pathfinder, Quest, Murano, Maxima, Altima V6, CVT Judder and DTC P17F0 or P17F1 Stored
• 10194173Mar 31, 2016Transmission and drivetrain. CVT/TDCM Calibration Data "Write" Procedure
• 10194184Mar 29, 2016Fuel system, Equipment. Fuel Filler Cap tether clip service information
• 10192787Mar 29, 2016Fuel system, Equipment. SERVICE INFORMATION If the clip for the fuel filler cap tether becomes lost or is detached for any reason, it is no longer necessary to replace the fuel filler cap. The clip or "pin" is now available as a separate service part. NOTE - Do not replace the fuel filler cap if only the pin is needed. See this bulletin for further detail.
• 10192750Feb 26, 2016Exterior lighting. SERVICE INFORMATION Occasionally customers may notice water vapor or fog in the headlamps. The information, illustrations, and flow chart in this bulletin are provided to help you in determining if an incident for water/condensation in the headlamps is normal or not. Nissan?s new vehicle limited warranty does not cover physically damaged (cracked or broken) headlamps. All current headlamp assemblies are vented to…
• 10192744Feb 22, 2016Electrical system. IF YOU CONFIRM The MIL is "ON" with DTC P0603 (ECM BACK UP/CIRCUIT). ACTION 1. Confirm that the battery voltage is 11 volts, or more, with the ignition ON (engine OFF, not running). 2. Erase DTC 3. Perform DTC confirmation steps in the Service Procedure. 4. Confirm 1st trip DTC P0603 is not stored. NOTE: P0603 is often the result of low battery voltage, discharged battery or battery terminal disconnections. Please…
• 10192739Feb 17, 2016Engine cooling. IF YOU CONFIRM: The MIL is ON with DTC P0101 (MAF SEN/CIRCUIT-B1) and There are no drivability issues. ACTION: 1. Refer to step 6 in the SERVICE PROCEDURE to confirm this bulletin applies to the vehicle you are working on. 2. If this bulletin applies, reprogram the ECM. NOTE: If this bulletin does apply (the ECM needs to be reprogrammed), do NOT replace the mass air flow sensor. Please see this bulletin for further…
• 10192727Jan 28, 2016Visibility (wipers, defrost, mirrors). SERVICE INFORMATION The purpose of this bulletin is to give Nissan dealers guidelines to help determine if windshield breakage is covered under warranty or is the customer?s responsibility. Nissan North America (NNA) is not responsible for damage to glass that is a result of objects striking or scratching the glass. However, NNA is responsible for manufacturing issues such as distorted glass and cracks that are due…
• 10192707Dec 17, 2015Electrical system. SERVICE INFORMATION The Intelligent Keys used on the various Nissan vehicles may not be interchangeable between models and years. See this bulletin for further detail.
• 10192687Nov 20, 2015Electrical system. SERVICE INFORMATION Design and process changes have been made to improve battery voltage at dealer receipt. Our goal is to deliver vehicles to customers with a 12 volt battery in excellent condition. Proper dealership storage and maintenance of vehicle 12 volt batteries is essential to insuring good battery operating life and customer satisfaction. Dealers are responsible for maintaining vehicles in their inventory.
• 10192677Nov 16, 2015Visibility (wipers, defrost, mirrors). SERVICE INFORMATION Windshield "foreign material" that is on the surface of the glass in some cases can be cleaned off with a very particular type and grade of steel wool. * Most any foreign material on the surface of the Windshield can be cleaned off by using #0000 super fine steel wool. >The #0000 grade super fine steel wool can be found in most hardware stores. Please see this bulletin for further details.
• 10192662Oct 27, 2015Electrical system. SERVICE INFORMATION For Applied Vehicles, the USB cover (Figure 1) has been deleted (Figure 2). The USB cover is no longer a standard component and should not be considered missing and should not be installed. Do not submit a warranty claim for installation of a missing USB cover. Please see this bulletin for further detalls.
• 10192574May 7, 2015Wheels. SERVICE INFORMATION The appearance of painted alloy wheels can be damaged if acidic cleaners are used. DO NOT use Chrome Wheel Cleaner on Painted Wheels. Many chrome wheel cleaners have acidic ingredients. Make sure to follow all instruction in the Appearance and Care Section of the Owner?s Manual. Damage to wheel appearance due to the use of inappropriate chemicals or cleaning products is not covered under…
• 10192354Apr 29, 2014Electrical system. SERVICE INFORMATION Warranty claims coding for repairing wiring harnesses for all Nissan vehicles has changed. This bulletin gives an outline of the technician?s responsibilities in assisting the dealer?s claims administrator to properly code a harness repair. Failure to provide correct information may result in claims suspension or rejection. See this bulletin for further detail.

← All problems reported for the 2016 Nissan Quest