2000 Workhorse P320032 Brakes Problems
- Complaints
- 5about this part
- Share
- 63%of 8 total for the year
- Median mileage
- 40,981miles
- Trend
- Not enough dataFewer than 15 complaints, too few for a reliable trend.
NHTSA recorded 5 complaints about the brakes of the 2000 Workhorse P320032, 63% of the 8 complaints for this model year. Where a mileage was given, the median is 40,981 miles. 1 recall campaign on record is filed under a similar system.
Fewer than 15 complaints name this part, so treat the figures as a rough indication only.
Example complaints
Selected from NHTSA records; personal details are removed. They are consumer reports, not findings.
“On may 14, 2009 while on route 15 near frederick,md driver noticed that brake pedal went to floor when depressed with reduced braking. The feel of the brake pedal was as if there was a leak in the hydraulic braking system. An inspection by a mechanic indicated that the front calipers had locked up overheating the brakes. The front calipers, hoses, pads , and rotors were replaced. The motorhome, a 2000 damon challenger had 7500 miles on it at the time of the brake failure.”
NHTSA complaint #10269851, filed 2009-05, 7,500 miles“The contact owns a 2000 Workhorse P320032. While driving 35 MPH, the driver side tire began to skid. The contact inspected the vehicle and believed that the rear driver side brakes locked. As of september 19, 2007, the dealer had not inspected the vehicle. The manufacturer stated that his VIN was not included in NHTSA campaign id number 00v139000 (service brakes, hydraulic:antilock). The failure mileage was 60,000 and current mileage was 64,000. Updated 01-14-08. The brake caliper was over extendeed and became jammed. Updated 12/12/07.”
NHTSA complaint #10203416, filed 2007-09, 60,000 miles“The contact owns a 2000 Workhorse p31 chassis (na). The contact stated that the brake pedal sporadically softens due to the brake fluid boiling. In addition, the calipers become stuck in the applied position. As a result, abnormal heat generation occurs at the wheel end and causes the brakes to drag. The stopping distance also increases. The manufacturer stated that his VIN was excluded from NHTSA campaign id number 09v110000 (service brakes, hydraulic); therefore, they would not assume responsibility for the repairs. The failures still persist. …”
NHTSA complaint #10272932, filed 2009-06Related recalls
- 00V139000May 15, 2000Vehicle description: motor home and commercial chassis equipped with jb8 power hydraulic brake option. An incorrect anti-lock brake control module was…Covers: Workhorse P320032 1999–2000, P320042 1999–2000
Brakes: other model years
Other parts of the 2000 Workhorse P320032
← All problems reported for the 2000 Workhorse P320032
About this data. Data from NHTSA (ODI) complaints, recalls, TSBs and investigations, updated Oct 31, 2026. Complaints are unverified consumer reports and may be duplicated or inaccurate.
To check a specific vehicle for open recalls, use its VIN at nhtsa.gov/recalls. Methodology