2013 Audi A3 Technical Service Bulletins

864 technical service bulletins (TSBs) are on record for the 2013 Audi A3. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10124499Jul 19, 2013Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 12-40 dated February 28, 2012. Rough gear changes, both when accelerating and when slowing down. There is a rough driving power disruption that occurs sporadically and lasts for less than a second. After a mechatronics, torque converter, or complete gearbox replacement, the clutches must be adapted to the new component. This requires a gradual move of the clutch…
• 10053883Jul 19, 2013Steering. Audi: in some vehicles, the clutches, after having torque converter, complete gearbox replacement or mechatronics, must adapt to new components with gradual moving of clutch linings in most diverse load conditions. Models 2004-14, a3, tt, q7, a4, a5, a6, a7, a8, q5, s4, s5, s6, s7, rs5.
• 10124525Jul 16, 2013Equipment, Electrical system. Supersedes Technical Service Bulletin Group 91 number 12-61 dated September 25, 2012. The customer complains that when he or she is trying to place a phone call from the vehicle while using a Bluetooth®-connected phone, the phone call disconnects before it begins and an error shows on the MMI display. The message may be "Function not supported" or "Network error". The customer is using a phone with the Android…
• 10251020Jul 12, 2013Suspension. Alignment - Repair Authorization
• 10124504Jul 12, 2013Steering. Supersedes Technical Service Bulletin Group 44 number 13-37 dated February 25, 2013. Vehicle pulls - left or right. Steering wheel not leveled or off-center. In some cases both concerns may be reported. the alignment concern is due to outside influence (e.g. accident), this TSB does not apply.
• 10128035Jul 10, 2013Electrical system. Supersedes Technical Service Bulletin Group 91 number 11-29 dated December 20, 2011. The Bluetooth telephone bonding tone is too loud or quiet for the customer. When a telephone is connected to the vehicle via the Bluetooth wireless connection, a tone is played over the audio system. The volume of this tone correlates to the volume level of the phone preparation voice control. This volume level is independent of…
• 10124574Jul 10, 2013Equipment. Supersedes Technical Service Bulletin Group 96 number 12-37 dated June 11, 2012. The customer may report that the handheld transmitter cannot be programmed to the garage door opener control module, J530. The customer's door opener system may not be compatible with J530. The battery in the handheld transmitter may be too weak for a good signal. The battery charge may be sufficient to operate the garage door opener…
• 10243788Jul 8, 2013Equipment. Audi Elsa Newsletter
• 10124505Jul 8, 2013Brakes, Electrical system. Customer may report sporadically hearing the parking brake being actuated after the vehicle has been switched off. If the customer does not identify the sound as the sound of the parking brake being actuated, he or she may simply complain of hearing noises from the rear brakes. Ignition is switched off. Steering is locked. Park is selected. Parking brake is not engaged.
• 10072547Jul 5, 2013Equipment. Summary to be provided on a future date.
• 10243787Jul 1, 2013Equipment. Audi Elsa Newsletter
• 10123534Jun 27, 2013Equipment. This document contains the Audi pre-delivery checklist.
• 10250204Jun 24, 2013Equipment. AUDI delivery guidelines
• 10216701Jun 24, 2013Fuel system, Suspension. Because of exhaust gas pulsations, the wastegate flap and rods vibrate at the start of the boost air control. This vibration causes rattling or jarring noises.
• 10123585Jun 24, 2013Engine cooling. Supersedes Technical Service Bulletin Group 21 number 12-09 dated May 16, 2012. Rattling and/or jarring noises heard from the engine compartment/exhaust system between 1800 and 2900 rpm. Because of exhaust gas pulsations, the wastegate flap and rods vibrate at the start of the boost air control. This vibration causes rattling or jarring noises.
• 10228314Jun 21, 2013Fuel system. The use of contaminated gasoline or gasoline with a low content of deposit control additives may result in one or more conditions.
• 10224993Jun 21, 2013Fuel system. The use of contaminated gasoline or gasoline with a low content of deposit control additives may result in one or more conditions.
• 10221966Jun 21, 2013Fuel system. The use of contaminated gasoline or gasoline with a low content of deposit control additives may result in one or more conditions.
• 10123591Jun 21, 2013Electrical system, Fuel system. Supersedes Technical Service Bulletin Group 00 number 10-01 dated February 5, 2010. Excessive accumulation of deposits on intake valves, intake manifold, fuel injectors and combustion chambers. Engine runs rough after cold start. Excessive engine cranking time. Hesitations while driving. Rough engine idle. Reduced engine performance. Poor fuel economy.
• 10123587Jun 20, 2013Engine cooling. Supersedes Technical Service Bulletin Group 19 number 13-35 dated March 25, 2013. Discontinuation and mixing of Audi-approved engine coolants. G11, G12, and G12+ coolants have been replaced by an improved version. G12++ coolant (for service available) has been introduced in MY 2005 for all engines. G13 has been introduced in MY 2008 as factory filling and service.
• 10123548Jun 12, 2013Equipment. Audi is committed to enhancing the Initial Quality Experience for our Customers within the first days of vehicle ownership. We want to resolve any knowledge or technical concerns a customer may have about a new vehicle, and build a strong, positive, enduring relationship between dealer and customer. To support this commitment to both our dealers and our customers, Audi is introducing the Audi Second Delivery…
• 10228309Jun 6, 2013Engine cooling. Moisture from the intake air condenses and collects in the charge air cooler. At cold temperatures, this moisture can freeze, causing blockage of the intake air system.
• 10224988Jun 6, 2013Engine cooling. Moisture from the intake air condenses and collects in the charge air cooler. At cold temperatures, this moisture can freeze, causing blockage of the intake air system.
• 10221961Jun 6, 2013Engine cooling. Moisture from the intake air condenses and collects in the charge air cooler. At cold temperatures, this moisture can freeze, causing blockage of the intake air system.
• 10123596Jun 6, 2013Electrical system. Engine will not start after standing in cold weather below 0°C (32°F). MIL may be illuminated with various induction and/or boost system faults stored in ECM. Moisture from the intake air condenses and collects in the charge air cooler. At cold temperatures, this moisture can freeze, causing blockage of the intake air system.
• 10065638Jun 6, 2013Engine. Summary to be provided on a future date.
• 10052518Jun 6, 2013Engine. Audi: some vehicles may experience rough running. Excess moisture maybe found in the intake pipe. It is also probable that the engine may not start.
• 10123564Jun 4, 2013Transmission and drivetrain. Supersedes Technical Service Bulletin Group 66 number 12-24 dated August 24, 2012. Customer may report the license plate attachment screws do not install properly. The license plate brackets are designed to be used with the appropriate length screw installed by hand with a screwdriver. Damaged warranty parts have been returned to Audi of America with evidence of excessive torque used when installing the screw…
• 10074156Jun 1, 2013Equipment. Summary to be provided on a future date.
• 10210650May 29, 2013Brakes. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who consciously or unconsciously drive with their left foot resting on the brake pedal are prone to experience this condition. With the introduction of Electronic Power Control (EPC) (no accelerator cable) to fuel injection systems, an engine RPM control feature has been incorporated into the engine…
• 10052307May 29, 2013Vehicle speed control. Audi: some vehicles may lack power or will not move after stop due to simultaneously depressing the brake and accelerator pedals.
• 10124923May 21, 2013Equipment. This document contains the Auid On Track - IQS Newsletter.
• 10216676May 15, 2013Fuel system. Beginning with MY2013, the filler necks of all A3 TDI vehicles are equipped with a misfueling guard (Figure 1). The guard minimizes the likelihood that fuel other than ultra-low sulfur diesel will be put into the vehicle. The misfueling guard is designed to remain in a locked position when a nozzle with a diameter typically suited for non-diesel fuels (approximately 13/16?, or 20.6mm) is inserted, to prevent…
• 10065745May 15, 2013Engine. Summary to be provided on a future date.
• 10228289May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10224968May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10221941May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10124941May 14, 2013Engine. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10228372May 13, 2013Fuel system, Electrical system. Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Additional component replacement may be necessary to ensure that no contamination or debris remains after repair. Reasons for fuel contamination can include: water ingress in the fuel station?s holding tanks, errors made in fuel transport, or incorrect fuel has been dispensed into the vehicle.
• 10225051May 13, 2013Fuel system. Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Additional component replacement may be necessary to ensure that no contamination or debris remains after repair. Reasons for fuel contamination can include: water ingress in the fuel station?s holding tanks, errors made in fuel transport, or incorrect fuel has been dispensed into the vehicle.
• 10222024May 13, 2013Fuel system. Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Additional component replacement may be necessary to ensure that no contamination or debris remains after repair. Reasons for fuel contamination can include: water ingress in the fuel station?s holding tanks, errors made in fuel transport, or incorrect fuel has been dispensed into the vehicle.
• 10124956May 13, 2013Electrical system. Supersedes Technical Service Bulletin Group 01 number 13-79 dated March 20, 2013. MIL on. DTCs are stored in the engine control module (address word 01). Excess rattling (?diesel clatter?) coming from engine. No start or hard starting condition. Contaminated fuel found in fuel system. Rust or metal debris found in fuel system. Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery…
• 10065701May 13, 2013Fuel system. Summary to be provided on a future date.
• 10052289May 13, 2013Fuel system, Engine. Audi: the rail fuel pressure is too high. Fuel may be contaminated by rust or metal debris.
• 10243785Apr 22, 2013Equipment. Audi Elsa Newsletter
• 10228363Apr 15, 2013Electrical system. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10225042Apr 15, 2013Electrical system. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10222015Apr 15, 2013Electrical system. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10123904Apr 15, 2013Equipment, Engine. MIL on. Rough idle. DTCs are stored in the Engine Control Module (ECM), J623 (address word 01). Engine may have reduced performance without significant loss of power or stalling. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are…
• 10123930Apr 4, 2013Exterior lighting. Headlight range control warning displayed in instrument cluster. DTCs may or may not be present. Vehicle is equipped with cornering light and headlight range control module. Only vehicles equipped with Xenon headlight are affected. Manufacturing issues with J745 control units.

← All problems reported for the 2013 Audi A3