2011 Audi A5 Cabriolet Technical Service Bulletins

976 technical service bulletins (TSBs) are on record for the 2011 Audi A5 Cabriolet. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10212659May 22, 2013Equipment, Electrical system. Humming or metallic rattling noise from under the vehicle, heard most consistently during engine idle or slow acceleration. Initial inspection indicates that the noise is coming from the exhaust system. Relative movements in the rear mounting of the exhaust system (rear silencer).
• 10210607May 22, 2013Engine cooling. Humming or metallic rattling noise from under the vehicle, heard most consistently during engine idle or slow acceleration. Initial inspection indicates that the noise is coming from the exhaust system. Relative movements in the rear mounting of the exhaust system (rear silencer).
• 10212658May 15, 2013Engine, Transmission and drivetrain. Humming or metallic rattling noise from under the vehicle, heard most consistently during engine idle or slow acceleration. Initial inspection indicates that the noise is coming from the exhaust system. Relative movements in the rear mounting of the exhaust system (rear silencer).
• 10210606May 15, 2013Back-over prevention (rear camera). Humming or metallic rattling noise from under the vehicle, heard most consistently during engine idle or slow acceleration. Initial inspection indicates that the noise is coming from the exhaust system. Relative movements in the rear mounting of the exhaust system (rear silencer).
• 10228289May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10224968May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10221941May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10124941May 14, 2013Engine. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10052352May 14, 2013Latches, locks and linkages. Audi: some vehicles, in cold weather, occasionally, cannot be unlocked using the door handle touch sensor. Also inclded are model a4 my 2014, model a5 cabriolet my 2014, model q5 my 2014, model rs5 cabriolet my 2014, and model s5 cabriolet my 2011-2014.
• 10228371May 13, 2013Electrical system, Engine cooling. Engine shakes. Some of the Bosch ignition coils installed in the affected vehicles may fail prematurely.
• 10225050May 13, 2013Electrical system. Engine shakes. Some of the Bosch ignition coils installed in the affected vehicles may fail prematurely.
• 10222023May 13, 2013Electrical system, Engine cooling. Engine shakes. Some of the Bosch ignition coils installed in the affected vehicles may fail prematurely.
• 10124955May 13, 2013Electrical system. Faults are stored in the engine control module (ECM). Engine shakes. Some of the Bosch ignition coils installed in the affected vehicles may fail prematurely.
• 10052288May 13, 2013Electrical system. Audi: some vehicles may have a defect with the bosch ignition coils. The may prematurely fail.
• 10243992May 6, 2013Other or unknown. Elsaweb Newsletter
• 10210672May 1, 2013Equipment, Electrical system, Other or unknown. The ignition key cannot be removed even though the gear shifter is in Park (P). The vehicle is mechanically in the Park position, but this is not recognized electronically. The gear shifter cannot be moved from the Park position.
• 10210671May 1, 2013Transmission and drivetrain, Other or unknown, Electrical system. The fault occurs with ATF temperature below 60° C. Check for this temperature range in the extended environmental conditions of the diagnosis protocol. This TSB only applies if the ATF level is correct and there are no leaks.
• 10243786Apr 29, 2013Equipment. Audi Elsa Newsletter
• 10212698Apr 26, 2013Lane departure. Transmission warning message in cluster.
• 10123915Apr 26, 2013Transmission and drivetrain, Electrical system. Supersedes Technical Service Bulletin Group 37 number 13-99 dated April 1, 2013. Customer may report transmission warning light is illuminated. In some cases, the vehicle will not move after being started and placed into gear. After key cycle, the vehicle drives without restriction. DTCs are stored in the transmission control module (TCM), J217 (02). If DFCCs do not match exactly, this TSB does not apply. The DTCs…
• 10212697Apr 24, 2013Transmission and drivetrain. Transmission warning message in cluster
• 10210644Apr 24, 2013Electrical system, Transmission and drivetrain. The fault occurs with ATF temperature below 60o C. Check for this temperature range in the extended environmental conditions of the diagnosis protocol. This TSB only applies if the ATF level is correct and there are no leaks.
• 10123914Apr 24, 2013Electrical system, Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 13-97 dated March 4, 2013. Customer may report transmission warning lamp illuminated in instrument cluster. After ignition cycle, the warning message is no longer present. DTC P074100 (Torque Converter Clutch Circuit Performance) or "Stuck Off" is stored in transmission control module (TCM), J217 (address word 03). The fault occurs with ATF temperature below 60o…
• 10212674Apr 19, 2013Electrical system, Engine. Key does not stay or engage in ignition lock
• 10210622Apr 19, 2013Electrical system. It is possible that objects have been inserted into the ignition lock, which causes the slide of the ignition lock to become stuck in the rear part of the lock (S-contact position). The stuck slide is not allowed to return to the starting point (0-position).
• 10123929Apr 19, 2013Equipment. The fresh air blower is inoperative. DTCs may be stored in the heating and air conditioning electronics control module (address word 08). Malfunctions of the fresh air blower could be caused by a faulty printed circuit board in the fresh air blower control module and the carbon brushes bind in the brush holder and, as a consequence, lose contact with the motor commutator of the fresh air blower.
• 10123911Apr 19, 2013Equipment. Supersedes Technical Service Bulletin Group 28 number 12-19 dated May 1, 2012. The master key with remote control does not engage or stay in the ignition lock. On vehicles without Advanced Key, the remote keys are inoperable. Keyless unlocking/locking using the door handle and keyless opening of the trunk lid using the trunk handle are inoperable. The vehicle cannot be started with the Start/Stop button. The remote…
• 10228363Apr 15, 2013Electrical system. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10225042Apr 15, 2013Electrical system. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10222015Apr 15, 2013Electrical system. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10216657Apr 15, 2013Fuel system, Engine cooling. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core (Figure 1). The seal ring is not the cause of the leak.
• 10123905Apr 15, 2013Engine cooling. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.
• 10123904Apr 15, 2013Equipment, Engine. MIL on. Rough idle. DTCs are stored in the Engine Control Module (ECM), J623 (address word 01). Engine may have reduced performance without significant loss of power or stalling. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are…
• 10212696Apr 9, 2013Transmission and drivetrain. Hesitation concerns, Harsh downshifts when braking or harsh 1-2 upshifts.
• 10210643Apr 9, 2013Electrical system, Transmission and drivetrain. Further transmission control module (TCM), J217, software calibration needed to improve shift concerns. Further engine control module (ECM), J623, software calibration needed to improve hesitation.
• 10123913Apr 9, 2013Transmission and drivetrain, Electrical system. Supersedes Technical Service Bulletin Group 37 number 13-83 dated January 31, 2013. Hesitation concerns, harsh downshifts when braking, or harsh 1-2 upshifts. Further transmission control module (TCM), J217, software calibration needed to improve shift concerns. Further engine control module (ECM), J623, software calibration needed to improve hesitation.
• 10051750Apr 9, 2013Electrical system, Transmission and drivetrain. Audi: when braking, would have harsh downshifts and hesitation concerns and also upshifts 1-2 are harsh. Calibration of software to improve shift concerns and hesitation. Models 2011-12 a4, a4 avant, a5, a5 cabriolet, q5. *pe updated 7/1/13.
• 10216699Apr 4, 2013Engine cooling. Under certain driving conditions, the linkage for the waste gate actuation can encounter excessive wear which leads to play at the waste gate flap. This leads to boost escaping through a loose flap, which sets DTC P0299 (Negative Pressure Deviation).
• 10123907Apr 4, 2013Engine cooling. Supersedes Technical Service Bulletin Group 21 number 13-12 dated April 1, 2013. MIL on, DTC P0299 (Negative Pressure Deviation) is stored. Turbocharger waste gate flap has play. Under certain driving conditions, the linkage for the waste gate actuation can encounter excessive wear which leads to play at the waste gate flap. This leads to boost escaping through a loose flap, which sets DTC P0299 (Negative Pressure…
• 10226518Apr 1, 2013Transmission and drivetrain, Lane departure. Transmission warning message in cluster.
• 10216698Apr 1, 2013Engine cooling. Under certain driving conditions, the linkage for the waste gate actuation can encounter excessive wear which leads to play at the waste gate flap. This leads to boost escaping through a loose flap, which sets DTC P0299 (Negative Pressure Deviation).
• 10210668Apr 1, 2013Electrical system, Transmission and drivetrain. The DTCs are stored due to an issue with the transmission control module software. Specific DFCCs are stored as a result of the following situations: - DTC P060A00 with DFCC 8692 can be logged when a driving mode (Drive or Reverse) is selected within one second of selecting Neutral, while the vehicle rolls at a speed less than 2 mph (such as when the vehicle is being maneuvered in or out of a parking spot).
• 10123919Apr 1, 2013Transmission and drivetrain, Electrical system. Supersedes Technical Service Bulletin Group 37 number 12-77 dated December 19, 2012. Customer may report transmission warning light is illuminated. In some cases, the vehicle will not move after being started and placed into gear. After key cycle, the vehicle drives without restriction. DTCs are stored in the transmission control module, J217 (02). If DFCCs do not match exactly, this TSB does not apply.
• 10123906Apr 1, 2013Engine cooling. Supersedes Technical Service Bulletin Group 21 number 13-11 dated March 6, 2013. MIL on, DTC P0299 (Negative Pressure Deviation) is stored. Turbocharger waste gate flap has play. Under certain driving conditions, the linkage for the waste gate actuation can encounter excessive wear which leads to play at the waste gate flap. This leads to boost escaping through a loose flap, which sets DTC P0299 (Negative Pressure…
• 10123901Apr 1, 2013Equipment. Supersedes Technical Service Bulletin Group 00 number 11-19 dated April 8, 2011. This TSB contains information on technician preparation when calling the Audi Technical Assistance Center
• 10123858Mar 29, 2013Equipment. The trim panel at the defroster vent on the instrument panel is deformed. The trim panel is composed of a material which expands in a moist condition. The instrument panel restricts this expansion which leads to deformation of the trim.
• 10123849Mar 29, 2013Exterior lighting. Supersedes Technical Service Bulletin Group 94 number 09-23 dated August 12, 2009. Headlight switch knob is pressed in. The switch functions correctly. The headlight switch knob was designed with a normal position and a pushed-in position. This is a deliberate design feature designed to avoid injuries in the event of a collision.
• 10123854Mar 28, 2013Equipment. Supersedes Technical Service Bulletin Group 91 number 13-73 dated January 25, 2013. Customer complains of a "popping" noise from the radio followed by 10-15 seconds of no audio. The concern can happen in any audio source. Vehicle is equipped with MMI 3G or MMI 3G+ infotainment systems. Vehicle is not equipped with Bose or Bang & Olufsen sound systems.
• 10226464Mar 27, 2013Air bags, Lane departure. ABS warning light on - wire harness damage
• 10216640Mar 27, 2013Transmission and drivetrain. Engine oil service - filter cartridge replacement. When changing the oil filter and installing the new filter seal(s) in the oil filter housing, special attention is required.

← All problems reported for the 2011 Audi A5 Cabriolet