2009 Audi A5 Technical Service Bulletins

678 technical service bulletins (TSBs) are on record for the 2009 Audi A5. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10216665Jul 11, 2013Fuel system. The leak can be traced to the connection of the water pump and the hose leading to the heater core (Figure 1). The seal ring is not the cause of the leak.
• 10216663Jul 11, 2013Fuel system. The leak can be traced to the connection of the water pump and the hose leading to the heater core (Figure 1). The seal ring is not the cause of the leak.
• 10124494Jul 11, 2013Engine cooling. Supersedes Technical Service Bulletin Group 19 number 13-40 dated June 17, 2013. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.
• 10053906Jul 11, 2013Engine, Engine cooling. Audi: the connection of water pump and hose, on some vehicles, leading to heater core, has a coolant leakage from engine area and seal ring is not the cause. Model 2009-2013 a4, a5, q5, a6.
• 10124574Jul 10, 2013Equipment. Supersedes Technical Service Bulletin Group 96 number 12-37 dated June 11, 2012. The customer may report that the handheld transmitter cannot be programmed to the garage door opener control module, J530. The customer's door opener system may not be compatible with J530. The battery in the handheld transmitter may be too weak for a good signal. The battery charge may be sufficient to operate the garage door opener…
• 10216702Jul 9, 2013Brakes, Steering. Under certain driving conditions, the linkage for the waste gate actuation can encounter excessive wear which leads to play at the waste gate flap. This leads to boost escaping through a loose flap, which sets DTC P029900 (Negative Pressure Deviation).
• 10124497Jul 9, 2013Engine, Engine cooling. Supersedes Technical Service Bulletin Group 21 number 13-14 dated June 7, 2013. MIL on. DTC P029900 (Negative Pressure Deviation) is stored as a static fault in the engine control module (ECM), J623 (address word 01). Turbocharger waste gate flap has play. Under certain driving conditions, the linkage for the waste gate actuation can encounter excessive wear which leads to play at the waste gate flap.
• 10066805Jul 9, 2013Engine. Summary to be provided on a future date.
• 10052519Jul 9, 2013Engine. Audi: on some vehicles the turbocharger waste gate flap is loose. Dtc p0299 is stored. *js updated 12/2/13.
• 10124505Jul 8, 2013Brakes, Electrical system. Customer may report sporadically hearing the parking brake being actuated after the vehicle has been switched off. If the customer does not identify the sound as the sound of the parking brake being actuated, he or she may simply complain of hearing noises from the rear brakes. Ignition is switched off. Steering is locked. Park is selected. Parking brake is not engaged.
• 10124522Jul 2, 2013Electrical system, Equipment. Supersedes Technical Service Bulletin Group 91 number 10-70 dated October 26, 2010. Sequence of error messages are seen on the radio display screen after a CD was loaded into or removed from the internal CD drive. "Drive defective. The error could be corrected by resetting it (see radio system owner's manual).
• 10243787Jul 1, 2013Equipment. Audi Elsa Newsletter
• 10123570Jun 27, 2013Brakes. Supersedes Technical Service Bulletin Group 46 number 13-45 dated June 12, 2013. Brakes on vehicles produced before September 3, 2012 (calendar week 36 of 2012), squeak or squeal when used with light to moderate force.
• 10228314Jun 21, 2013Fuel system. The use of contaminated gasoline or gasoline with a low content of deposit control additives may result in one or more conditions.
• 10224993Jun 21, 2013Fuel system. The use of contaminated gasoline or gasoline with a low content of deposit control additives may result in one or more conditions.
• 10221966Jun 21, 2013Fuel system. The use of contaminated gasoline or gasoline with a low content of deposit control additives may result in one or more conditions.
• 10123591Jun 21, 2013Fuel system, Electrical system. Supersedes Technical Service Bulletin Group 00 number 10-01 dated February 5, 2010. Excessive accumulation of deposits on intake valves, intake manifold, fuel injectors and combustion chambers. Engine runs rough after cold start. Excessive engine cranking time. Hesitations while driving. Rough engine idle. Reduced engine performance. Poor fuel economy.
• 10123587Jun 20, 2013Engine cooling. Supersedes Technical Service Bulletin Group 19 number 13-35 dated March 25, 2013. Discontinuation and mixing of Audi-approved engine coolants. G11, G12, and G12+ coolants have been replaced by an improved version. G12++ coolant (for service available) has been introduced in MY 2005 for all engines. G13 has been introduced in MY 2008 as factory filling and service.
• 10123558Jun 20, 2013Electrical system. Supersedes Technical Service Bulletin Group 96 number 12-32 dated April 27, 2012. The customer is able to program one or more of the Homelink buttons using their garage door remote, but after a few days or weeks, one or more of the programmed Homelink buttons no longer function. The LED on the Homelink button that is no longer functioning now flashes slowly, indicating that no programming is stored. The customer?s…
• 10243986Jun 17, 2013Equipment. Elsaweb Newsletter
• 10216661Jun 17, 2013Fuel system. The leak can be traced to the connection of the water pump and the hose leading to the heater core (Figure 1). The seal ring is not the cause of the leak.
• 10123588Jun 17, 2013Engine cooling. Supersedes Technical Service Bulletin Group 19 number 13-36 dated April 15, 2013. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.
• 10212677Jun 13, 2013Engine, Transmission and drivetrain, Electrical system. Vehicle does not start or only starts when the clutch pedal is pressed very firmly
• 10123583Jun 13, 2013Electrical system. Supersedes Technical Service Bulletin Group 30 number 11-11 dated December 9, 2011. Customer may report that the vehicle does not start or only starts when the clutch pedal is pressed very firmly. The message ?Press clutch pedal to start vehicle? may appear in the instrument cluster. There may be clutch mechanism wear.
• 10066824Jun 13, 2013Transmission and drivetrain. Summary to be provided on a future date.
• 10123571Jun 12, 2013Brakes. Supersedes Technical Service Bulletin Group 46 number 13-42 dated June 11, 2013. Brakes on vehicles produced before September 3, 2012 (calendar week 36 of 2012), squeak or squeal when used with light to moderate force.
• 10123574Jun 11, 2013Brakes. Brakes on vehicles produced before September 3, 2012 (calendar week 36 of 2012), squeak or squeal when used with light to moderate force.
• 10123561Jun 11, 2013Equipment, Electrical system. Supersedes Technical Service Bulletin Group 87 number 12-37 dated November 16, 2012. Air conditioning is inoperative. The HVAC blower functions normally. Battery discharged; however, when charged, there is no bus silence when vehicle ignition is off. The A/C pressure/temperature sensor, G395, leaks refrigerant. This causes sensor G395 to show an incorrect or implausible value when reading MVBs.
• 10243793Jun 10, 2013Equipment. Audi Elsa Newsletter
• 10216700Jun 7, 2013Engine cooling. Under certain driving conditions, the linkage for the waste gate actuation can encounter excessive wear which leads to play at the waste gate flap. This leads to boost escaping through a loose flap, which sets DTC P0299 (Negative Pressure Deviation).
• 10123586Jun 7, 2013Engine cooling. Supersedes Technical Service Bulletin Group 21 number 13-13 dated April 4, 2013. MIL on, DTC P0299 (Negative Pressure Deviation) is stored. Turbocharger waste gate flap has play. Under certain driving conditions, the linkage for the waste gate actuation can encounter excessive wear which leads to play at the waste gate flap. This leads to boost escaping through a loose flap, which sets DTC P0299 (Negative Pressure…
• 10123562Jun 4, 2013Electrical system. Supersedes Technical Service Bulletin Group 85 number 13-15 dated March 29, 2013. The trim panel at the defroster vent on the instrument panel is deformed. The trim panel is composed of a material which expands in a moist condition. The instrument panel restricts this expansion which leads to deformation of the trim.
• 10243792Jun 3, 2013Equipment. Audi Elsa Newsletter
• 10210650May 29, 2013Brakes. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who consciously or unconsciously drive with their left foot resting on the brake pedal are prone to experience this condition. With the introduction of Electronic Power Control (EPC) (no accelerator cable) to fuel injection systems, an engine RPM control feature has been incorporated into the engine…
• 10052307May 29, 2013Vehicle speed control. Audi: some vehicles may lack power or will not move after stop due to simultaneously depressing the brake and accelerator pedals.
• 10052343May 23, 2013Exterior lighting. Audi: the vehicle lights malfunction message may be displayed on the dashboard cluster. There is no failure. Also included model a4 my 2014, model a5 cabriolet my 2014, model q5 my 2014, model s7 my 2012-2014, model rs7 my 2014.
• 10212659May 22, 2013Equipment, Electrical system. Humming or metallic rattling noise from under the vehicle, heard most consistently during engine idle or slow acceleration. Initial inspection indicates that the noise is coming from the exhaust system. Relative movements in the rear mounting of the exhaust system (rear silencer).
• 10210607May 22, 2013Engine cooling. Humming or metallic rattling noise from under the vehicle, heard most consistently during engine idle or slow acceleration. Initial inspection indicates that the noise is coming from the exhaust system. Relative movements in the rear mounting of the exhaust system (rear silencer).
• 10066812May 22, 2013Engine. Summary to be provided on a future date.
• 10212658May 15, 2013Engine, Transmission and drivetrain. Humming or metallic rattling noise from under the vehicle, heard most consistently during engine idle or slow acceleration. Initial inspection indicates that the noise is coming from the exhaust system. Relative movements in the rear mounting of the exhaust system (rear silencer).
• 10210606May 15, 2013Back-over prevention (rear camera). Humming or metallic rattling noise from under the vehicle, heard most consistently during engine idle or slow acceleration. Initial inspection indicates that the noise is coming from the exhaust system. Relative movements in the rear mounting of the exhaust system (rear silencer).
• 10228289May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10224968May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10221941May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10124941May 14, 2013Engine. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10210672May 1, 2013Equipment, Electrical system, Other or unknown. The ignition key cannot be removed even though the gear shifter is in Park (P). The vehicle is mechanically in the Park position, but this is not recognized electronically. The gear shifter cannot be moved from the Park position.
• 10212674Apr 19, 2013Electrical system, Engine. Key does not stay or engage in ignition lock
• 10210622Apr 19, 2013Electrical system. It is possible that objects have been inserted into the ignition lock, which causes the slide of the ignition lock to become stuck in the rear part of the lock (S-contact position). The stuck slide is not allowed to return to the starting point (0-position).
• 10123929Apr 19, 2013Equipment. The fresh air blower is inoperative. DTCs may be stored in the heating and air conditioning electronics control module (address word 08). Malfunctions of the fresh air blower could be caused by a faulty printed circuit board in the fresh air blower control module and the carbon brushes bind in the brush holder and, as a consequence, lose contact with the motor commutator of the fresh air blower.
• 10123911Apr 19, 2013Equipment. Supersedes Technical Service Bulletin Group 28 number 12-19 dated May 1, 2012. The master key with remote control does not engage or stay in the ignition lock. On vehicles without Advanced Key, the remote keys are inoperable. Keyless unlocking/locking using the door handle and keyless opening of the trunk lid using the trunk handle are inoperable. The vehicle cannot be started with the Start/Stop button. The remote…

← All problems reported for the 2009 Audi A5