2013 Audi A5 Technical Service Bulletins

1,378 technical service bulletins (TSBs) are on record for the 2013 Audi A5. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10124609Aug 14, 2013Engine cooling. This communication is to inform you of a revision to Update 24Z6. The revision is in regards to the manifold actuator.
• 10124640Aug 13, 2013Equipment. Supersedes Technical Service Bulletin Group 91 number 13-81 dated March 29, 2013. Customer concern is that there is no sound (from all audio sources) when vehicle is operated above 6 to 10 mph. When the ignition is cycled and the vehicle is stationary, the audio will work until the vehicle is driven again. Only vehicles with Concert Radio (PR 8UQ) and standard sound system (PR 9VD) are affected.
• 10124616Aug 13, 2013Engine cooling. Audi has determined that, under certain driving conditions, carbon buildup can occur in the engine cylinder head secondary air ports. Due to the presence of specific fault codes caused by this carbon buildup, the Malfunction Indicator Lamp (MIL) on the instrument cluster may illuminate. The MIL is part of your on-board diagnostic system. Please refer to your owner's manual for additional information about the MIL.
• 10124649Aug 9, 2013Equipment. Supersedes Technical Service Bulletin Group 00 number 11-23 dated June 3, 2011. Instructions for vehicle inspection, protection removal, and detailing.
• 10124643Aug 9, 2013Electrical system, Equipment. Supersedes Technical Service Bulletin Group 80 number 13-03 dated May 13, 2013. Malfunction Indicator Lamp is on. Climate system heating performance is insufficient. Coolant level warning is on. Engine temperature is elevated. "Limp Home" mode is active. Faults are stored in the transmission control module. Coolant loss is found from one or more control valves: N82, N509, or N488. Coolant may have migrated into the…
• 10053889Aug 9, 2013Engine cooling. Audi: presence of coolant loss inside electrical connector, causes engine warning light to illuminate and temperature of engine to elevate and failure of climate system heating performance. Model 2010-2012 a6, a7, a8, q7, a5 cabriolet, tt, a4, q5.
• 10124593Aug 6, 2013Engine cooling. On Audi vehicles with a 3.0L TFSI engine produced during a certain period, it is possible that the membrane on the vacuum actuator for the intake manifold flaps may tear. As a result, the intake manifold flaps do not function and the engine indicator light turns on. This Update is in effect until removed. Procedure is valid only for vehicles that show the 24Z6 code in the ElsaWeb Campaign/Action Information screen…
• 10124691Aug 5, 2013Body and structure, Visibility (wipers, defrost, mirrors). This document contains information on analyzing squeaking windows on frameless doors.
• 10124690Aug 5, 2013Equipment. This document contains information on the Audi side assist update.
• 10124687Aug 5, 2013Equipment, Brakes. This document contains information on the Audi braking guard.
• 10124636Aug 5, 2013Equipment. Supersedes Technical Service Bulletin Group 91 number 12-65 dated October 25, 2012. MMI 3G+ Sound system "popping" and various other technical Issues (K0715 Update). Only apply this bulletin to vehicles if the customer complaint is in the correct group. Applying the update to vehicles outside of the appropriate group can cause repeat repairs and the warranty claim may be denied. This bulletin only applies to…
• 10124614Aug 5, 2013Engine cooling. This communication is to inform you of upcoming Update 24Z6. On Audi vehicles with a 3.0L TFSI engine produced during a certain period, it is possible that the membrane on the vacuum actuator for the intake manifold flaps may tear. As a result, the intake manifold flaps do not function and the engine indicator light turns on. Install new manifold actuators.
• 10124648Aug 1, 2013Latches, locks and linkages. Supersedes Technical Service Bulletin Group 57 number 11-49 dated August 8, 2011. The customer inquires about the operation of the vehicle locking, and may suggest that the vehicle "locked itself". The lock command history is stored in the convenience system control module (J393).
• 10066845Jul 31, 2013Steering. Summary to be provided on a future date.
• 10124581Jul 30, 2013Equipment. Supersedes Technical Service Bulletin Group 91 number 12-38 dated March 2, 2012. When a phonebook with a large number of contacts is being downloaded, the MMI screen freezes in one of the following scenarios: * After the initial Bluetooth connection (shortly after the phone is bonded to the vehicle), the screen freezes briefly. * After the ignition is switched on (shortly after the phone automatically reconnects…
• 10124515Jul 30, 2013Latches, locks and linkages, Electrical system. Supersedes Technical Service Bulletin Group 55 number 13-30 dated May 28, 2013. "Low Oil Level" message is on in the DIS or MMI. The hood must be open for at least 30 seconds for a reset of this message to be performed. The message is not reset in the DIS/MMI because the hood has not been recognized as being opened due to an inoperative hood contact switch.
• 10124509Jul 30, 2013Brakes. Supersedes Technical Service Bulletin Group 46 number 13-46 dated June 27, 2013. Brakes on vehicles produced before September 3, 2012 (calendar week 36 of 2012), squeak or squeal when used with light to moderate force.
• 10243791Jul 29, 2013Equipment. Audi Elsa Newsletter
• 10243790Jul 22, 2013Equipment. Audi Elsa Newsletter
• 10226468Jul 22, 2013Equipment. Radio station or Media track information does not show in cluster DIS - Gen 3 Concert Radio
• 10124570Jul 22, 2013Equipment. The customer complains that after the vehicle is started, the name of the current radio station or media track is not shown in the driver information system (DIS). After the music input is changed to a different source and then changed back (i.e., media to radio to media or radio to media to radio), the radio station or media track information is shown in the DIS.
• 10068747Jul 22, 2013Electrical system. Summary to be provided on a future date.
• 10226502Jul 19, 2013Vehicle speed control. Rough gear changes both when accelerating and slowing down
• 10210652Jul 19, 2013Transmission and drivetrain, Electrical system. After a mechatronics, torque converter, or complete gearbox replacement, the clutches must be adapted to the new component. This requires a gradual move of the clutch linings toward the optimal operating points in the most diverse load conditions. As a result, sporadic driving power disruptions lasting for less than a second or reduced shift comfort are possible over the first 500 miles. This is normal, and these…
• 10124499Jul 19, 2013Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 12-40 dated February 28, 2012. Rough gear changes, both when accelerating and when slowing down. There is a rough driving power disruption that occurs sporadically and lasts for less than a second. After a mechatronics, torque converter, or complete gearbox replacement, the clutches must be adapted to the new component. This requires a gradual move of the clutch…
• 10053883Jul 19, 2013Steering. Audi: in some vehicles, the clutches, after having torque converter, complete gearbox replacement or mechatronics, must adapt to new components with gradual moving of clutch linings in most diverse load conditions. Models 2004-14, a3, tt, q7, a4, a5, a6, a7, a8, q5, s4, s5, s6, s7, rs5.
• 10124506Jul 18, 2013Brakes, Electrical system. Supersedes Technical Service Bulletin Group 53 number 13-02 dated July 11, 2013. Customer may report that the vehicle does not start due to a discharged battery. DTC U101100 (supply voltage too low) is stored in the gateway, J533 (address word 19), and/or the electronic parking brake (EPB) control module, J540 (address word 53). According to the test plan "19-Read Data Bus Keep-Awake Manager", the EPB control…
• 10124496Jul 18, 2013Engine cooling. Supersedes Technical Service Bulletin Group 19 number 13-42 dated July 11, 2013. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.
• 10124525Jul 16, 2013Equipment, Electrical system. Supersedes Technical Service Bulletin Group 91 number 12-61 dated September 25, 2012. The customer complains that when he or she is trying to place a phone call from the vehicle while using a Bluetooth®-connected phone, the phone call disconnects before it begins and an error shows on the MMI display. The message may be "Function not supported" or "Network error". The customer is using a phone with the Android…
• 10251020Jul 12, 2013Suspension. Alignment - Repair Authorization
• 10124573Jul 12, 2013Equipment. Supersedes Technical Service Bulletin Group 96 number 13-64 dated June 20, 2013. The customer is able to program one or more of the Homelink buttons using their garage door remote, but after a few days or weeks, one or more of the programmed Homelink buttons no longer functions. The LED on the Homelink button that is no longer functioning now flashes slowly, indicating that no programming is stored. The customer's…
• 10124520Jul 12, 2013Equipment. Supersedes Technical Service Bulletin Group 87 number 13-42 dated June 11, 2013. Air conditioning is inoperative. The HVAC blower functions normally. Battery discharged; however, when charged, there is no bus silence when vehicle ignition is off. The A/C pressure/temperature sensor, G395, leaks refrigerant. This causes sensor G395 to show an incorrect or implausible value when reading MVBs.
• 10124504Jul 12, 2013Steering. Supersedes Technical Service Bulletin Group 44 number 13-37 dated February 25, 2013. Vehicle pulls - left or right. Steering wheel not leveled or off-center. In some cases both concerns may be reported. the alignment concern is due to outside influence (e.g. accident), this TSB does not apply.
• 10216665Jul 11, 2013Fuel system. The leak can be traced to the connection of the water pump and the hose leading to the heater core (Figure 1). The seal ring is not the cause of the leak.
• 10216663Jul 11, 2013Fuel system. The leak can be traced to the connection of the water pump and the hose leading to the heater core (Figure 1). The seal ring is not the cause of the leak.
• 10124513Jul 11, 2013Electrical system, Brakes. Customer may report that the vehicle does not start due to a discharged battery. DTC U101100 (supply voltage too low) is stored in the gateway, J533 (address word 19), and/or the electronic parking brake (EPB) control module, J540 (address word 53). According to the test plan "19-Read Data Bus Keep-Awake Manager", the EPB control module kept the data bus active for prolonged periods of time.
• 10124503Jul 11, 2013Tires. Customer reports seeing the messages "TPMS" and "Tire pressure: System malfunction!" in the instrument cluster. The "TPMS" message is not related to a loss of tire pressure. The message only indicates that tire pressure monitoring system (TPMS) is not active.
• 10124494Jul 11, 2013Engine cooling. Supersedes Technical Service Bulletin Group 19 number 13-40 dated June 17, 2013. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.
• 10053906Jul 11, 2013Engine, Engine cooling. Audi: the connection of water pump and hose, on some vehicles, leading to heater core, has a coolant leakage from engine area and seal ring is not the cause. Model 2009-2013 a4, a5, q5, a6.
• 10124574Jul 10, 2013Equipment. Supersedes Technical Service Bulletin Group 96 number 12-37 dated June 11, 2012. The customer may report that the handheld transmitter cannot be programmed to the garage door opener control module, J530. The customer's door opener system may not be compatible with J530. The battery in the handheld transmitter may be too weak for a good signal. The battery charge may be sufficient to operate the garage door opener…
• 10124511Jul 10, 2013Steering. Customer may report hearing creaking or squeaking noise from the steering column when steering slowly (the noise can be duplicated while the vehicle is stationary if the steering wheel is turned slowly). The noise may get louder at higher temperatures or when the vehicle is driven for a longer period of time. The noise comes from the sealing sleeve/steering column opening on the bulkhead. Listen to the attached…
• 10124505Jul 8, 2013Brakes, Electrical system. Customer may report sporadically hearing the parking brake being actuated after the vehicle has been switched off. If the customer does not identify the sound as the sound of the parking brake being actuated, he or she may simply complain of hearing noises from the rear brakes. Ignition is switched off. Steering is locked. Park is selected. Parking brake is not engaged.
• 10072549Jul 5, 2013Equipment. Summary to be provided on a future date.
• 10072539Jul 5, 2013Equipment. Summary to be provided on a future date.
• 10072537Jul 5, 2013Equipment. Summary to be provided on a future date.
• 10250208Jul 2, 2013Equipment. Lineamientos de entrega de Audi
• 10250207Jul 2, 2013Equipment. Lineamientos de entrega de Audi
• 10124547Jul 2, 2013Equipment. This document contains the Audi delivery guidelines checklist. This document is in Spanish.
• 10124522Jul 2, 2013Electrical system, Equipment. Supersedes Technical Service Bulletin Group 91 number 10-70 dated October 26, 2010. Sequence of error messages are seen on the radio display screen after a CD was loaded into or removed from the internal CD drive. "Drive defective. The error could be corrected by resetting it (see radio system owner's manual).
• 10243787Jul 1, 2013Equipment. Audi Elsa Newsletter

← All problems reported for the 2013 Audi A5