2013 Audi A6 Technical Service Bulletins

1,665 technical service bulletins (TSBs) are on record for the 2013 Audi A6. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10250664Jul 2, 2014Steering. Squeaking noises when steering or maneuvering
• 10122540Jul 2, 2014Suspension. Supersedes Technical Service Bulletin Group 40 number 13-34 dated September 23, 2013. Oil appears on one or several shock absorbers.
• 10122539Jul 2, 2014Steering. Supersedes Technical Service Bulletin Group 40 number 13-35 dated September 23, 2013. Squeaking noises are heard when the steering wheel is turned or maneuvered. The noises may be more prevalent in wet weather. The folds of the outer rubber boots on the front axle shafts may come in contact with each other when the steering wheel is turned, causing squeaking noises. These noises are more likely to occur when the…
• 10226533Jul 1, 2014Transmission and drivetrain. Transmission warning message in cluster.
• 10226532Jul 1, 2014Transmission and drivetrain. Harsh downshifts when braking or harsh 1-2 upshift under acceleration
• 10210683Jul 1, 2014Electrical system, Transmission and drivetrain, Other or unknown. Transmission warning may appear in instrument cluster. After ignition cycle, the warning message is no longer present. The fault occurs with ATF temperature below 60o C. Check for this temperature range in the extended environmental conditions of the diagnosis protocol. This TSB only applies if the ATF level is correct and there are no leaks.
• 10210682Jul 1, 2014Transmission and drivetrain, Electrical system, Engine. Further transmission control module (TCM), J217 (address word 02), software calibration to improve shift concerns.
• 10122534Jul 1, 2014Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 14-22 dated May 1, 2014. Transmission warning may appear in instrument cluster. After ignition cycle, the warning message is no longer present. DTC P074100 (Torque Converter Clutch Circuit Performance) or ?Stuck Off? is stored in transmission control module (TCM). The fault occurs with ATF temperature below 60o C. Check for this temperature range in the extended…
• 10122533Jul 1, 2014Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 13-96 dated March 4, 2013. Customer may report harsh downshifts while braking or harsh 1-2 upshift under acceleration. Further transmission control module (TCM), J217 (address word 02), software calibration to improve shift concerns.
• 10231130Jun 30, 2014Engine cooling. Idenifying and mixing factory fill engine coolants
• 10216685Jun 26, 2014Engine cooling. The NVLD pressure switch may erroneously detect a very small leak.
• 10122416Jun 26, 2014Engine cooling, Equipment. Supersedes Technical Service Bulletin Group 20 number 14-32 dated March 21, 2014. The MIL is on. DTC P045600 (EVAP System Leak Detected NVLD (very small leak)) is stored in the engine control module (ECM), J623 (address word 01). Drivability is not affected. The NVLD pressure switch may erroneously detect a very small leak.
• 10122415Jun 20, 2014Engine cooling. Supersedes Technical Service Bulletin Group 19 number 13-41 dated June 20, 2013. Discontinuation and mixing of Audi-approved engine coolants. G11, G12, and G12+ coolants have been replaced by an improved version. G12++ coolant (for service available) has been introduced in MY 2005 for all engines. G13 has been introduced in MY 2008 as factory filling and service.
• 10231128Jun 16, 2014Equipment. Technical bulletins and updates
• 10231127Jun 9, 2014Equipment, Electrical system. ElsaPro Software update and technical bulletins
• 10242630Jun 4, 2014Other or unknown, Air bags. Module
• 10122421Jun 2, 2014Seats, Equipment. Supersedes Technical Service Bulletin Group 74 number 14-17 dated February 21, 2014. Customer may complain that the seat pneumatics (side bolsters and lumbar support) actuate without any input from the customer. This condition can occur when the vehicle is driven at high altitudes or when the outside temperature fluctuates.
• 10066351Jun 2, 2014Seats, Electrical system. Summary to be provided on a future date.
• 10212703May 29, 2014Transmission and drivetrain. Vehicle lacks power or will not move after stop due to simultaneous depressing of the brake and accelerator pedals
• 10122480May 29, 2014Exterior lighting. Supersedes Technical Service Bulletin Group 94 number 13-25 dated July 24, 2013. Customer complains about heavy condensation is present in the headlight, lower headlight lens cracking, and upper headlight housing cracking (at transition from lens to black surround). Workshop found no visible external force marks (from accident or debris impact) are present, one or both sides may be affected, and the vehicle is not…
• 10122455May 29, 2014Electrical system. Supersedes Technical Service Bulletin Group 01 number 13-42 dated November 21, 2013. DTC P164D00 is stored in the engine control module. Red oil pressure warning light may be on. An oil filter that is too short is installed. The oil filter must be 155 (+/-1) mm long. If the oil filter is too short, the drain flap in the oil filter housing will not be completely closed and oil pressure will be reduced.
• 10066432May 29, 2014Exterior lighting. Summary to be provided on a future date.
• 10065431May 29, 2014Fuel system. Summary to be provided on a future date.
• 10228295May 28, 2014Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10226529May 28, 2014Transmission and drivetrain. Vehicle lacks power or will not move after stop due to simultaneous depressing of the brake and accelerator pedals
• 10224974May 28, 2014Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10221947May 28, 2014Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10210679May 28, 2014Electronic stability control, Transmission and drivetrain. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who drive with their left foot resting on the brake pedal are prone to experience this condition. With the introduction of Electronic Power Control (EPC) (no accelerator cable) to fuel injection systems, an engine RPM control feature has been incorporated into the engine electronic control system…
• 10122465May 28, 2014Transmission and drivetrain. Supersedes Technical Service Bulletin Group 37 number 13-07 dated May 29, 2013. Customer states that the engine returns to idle speed of approximately 1,400 RPM although the accelerator is depressed, and/or the vehicle hesitates (lacks power on take-off). No DTCs are stored. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who drive with their left…
• 10122452May 28, 2014Engine, Equipment. Supersedes Technical Service Bulletin Group 00 number 13-49 dated May 14, 2013. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating…
• 10231139May 26, 2014Equipment. Technical bulletins and updates
• 10226528May 22, 2014Transmission and drivetrain. Transmission warning message in cluster.
• 10210678May 22, 2014Engine cooling, Electrical system, Transmission and drivetrain. Customer may report transmission warning light is illuminated. In some cases, the vehicle will not move after being started and placed into gear. After key cycle, the vehicle drives without restriction. The DTCs are stored due to an issue with the transmission control module software.
• 10122464May 22, 2014Electrical system. Supersedes Technical Service Bulletin Group 37 number 13-17 dated September 11, 2013. Customer may report transmission warning light is illuminated. In some cases, the vehicle will not move after being started and placed into gear. After key cycle, the vehicle drives without restriction. DTCs are stored in the transmission control module (TCM). If DFCCs do not match exactly, this TSB does not apply. The DTCs are…
• 10065997May 22, 2014Electrical system. Summary to be provided on a future date.
• 10216614May 21, 2014Back-over prevention (rear camera). The remote key being used is transmitting incomplete immobilizer information to the vehicle, resulting in the condition. Improved software for the comfort system central control module, J393 (address word 46) in production. Service software update will follow at a later date (to be determined).
• 10122454May 21, 2014Electrical system. Supersedes Technical Service Bulletin Group 01 number 14-51 dated January 3, 2014. The customer complains that the vehicle sporadically cannot be started. The yellow gearbox warning light may be illuminated. DTCs may be present. The remote key being used is transmitting incomplete immobilizer information to the vehicle, resulting in the condition.
• 10065429May 21, 2014Electrical system. Summary to be provided on a future date.
• 10250971May 14, 2014Steering. Steering wheel shimmy, vibration, and/or oscillation
• 10122467May 14, 2014Suspension, Steering. Supersedes Technical Service Bulletin Group 44 number 14-49 dated April 17, 2014. Customer feels vibration in the seat, vehicle floor, footwell, pedals, or steering wheel. This condition does not lead to any handling concerns or loss of vehicle control. The customer feels the vibration while driving at highway speeds from 55 ? 80 mph (88 ? 128 km/h). This bulletin is not applicable if this vehicle has a Repair…
• 10249085May 13, 2014Other or unknown. Google Maps Street View (NVLW))
• 10122515May 13, 2014Body and structure, Electrical system. Due to a process fault, the gearbox was filled with ATF fluid containing sulphur on Audi vehicles with multritronic manufactured within a specific period. As a result, a copper sulphide layer may form on the conductor tracks of the gearbox control unit and cause electrical faults. This Update is in effect until removed. Procedure is valid only for vehicles that show the 37H5 code in the Elsa Campaign/Action…
• 10067787May 13, 2014Electrical system. Summary to be provided on a future date.
• 10249079May 12, 2014Other or unknown, Transmission and drivetrain. Multitronic
• 10122487May 12, 2014Electrical system. Due to a process fault, the gearbox was filled with ATF fluid containing sulphur on Audi vehicles with multritronic manufactured within a specific period. As a result, a copper sulphide layer may form on the conductor tracks of the gearbox control unit and cause electrical faults. Drain and flush the gearbox and replace the multitronic unit.
• 10067663May 12, 2014Electrical system. Summary to be provided on a future date.
• 10122472May 2, 2014Electrical system. Supersedes Technical Service Bulletin Group 64 number 12-22 dated July 5, 2012. After one or both of the front door control units (J386/J387) is replaced, one or both of the rear door control units (J3888/J389) cannot be coded or parameterized via an SVM specified vs. actual comparison (spec/actual). The parameter data in the software coding container has changed for the front and rear door control units.
• 10226523May 1, 2014Transmission and drivetrain. Jerky accelerator response in reverse gear
• 10226521May 1, 2014Transmission and drivetrain, Electrical system, Lane departure. Transmission warning message in cluster (P074100 stored in TCM)
• 10210673May 1, 2014Transmission and drivetrain, Electrical system. A jerky accelerator response is felt when the vehicle is pulled away from a stop in reverse. Incorrect calibration of clutch program. New software in the transmission control module (TCM), J217 (address word 02) addressed the condition.

← All problems reported for the 2013 Audi A6