2014 Audi Allroad Technical Service Bulletins

496 technical service bulletins (TSBs) are on record for the 2014 Audi Allroad. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10122295Mar 31, 2014Air bags. Supersedes Technical Service Bulletin Group 69 number 13-26 dated October 21, 2013. After the airbag control module (J234) has been replaced, the control unit cannot be coded via SVM spec/actual. An SVM code is required to code and parameterize the new service replacement airbag control module. Each model's SVM code is provided in a parts bulletin (GP bulletin), which should have been referenced through ETKA when…
• 10250991Mar 25, 2014Brakes. Brake noise analysis and handling
• 10122292Mar 25, 2014Brakes. Supersedes Technical Service Bulletin Group 46 number 14-68 dated February 3, 2014. The customer may report hearing brake noise from front or rear brakes. The customer may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking.
• 10122302Mar 19, 2014Equipment. Supersedes Technical Service Bulletin Group 91 number 12-50 dated August 1, 2012. Echo effects, caller on either end cannot hear conversation, sound distortion or feedback, and the sound is distorted, hisses, or scrapes occur during a phone call. This bulletin provides guidelines for analyzing the call quality of the Bluetooth system in the vehicle, and is not applicable to any Audi warranty.
• 10231133Mar 17, 2014Equipment. Technical bulletins and updates
• 10125561Feb 27, 2014Equipment. Supersedes Technical Service Bulletin Group 87 number 12-27 dated April 24, 2012. There is an unpleasant, musty odor coming from the heating and ventilation system. The odor usually occurs when the vehicle has been sitting unused for five hours or more. The odor usually occurs within 20 to 60 seconds after the vehicle is started. Condensation, which is a normal condition in all A/C systems, can cause a musty odor.
• 10228292Feb 20, 2014Engine cooling. When oil is drained through the drain plug, the oil might spill on components around the oil pan area. If it is not properly cleaned up, this spilled oil could drip after the procedure is complete, causing unnecessary customer complaints.
• 10224971Feb 20, 2014Engine cooling. When oil is drained through the drain plug, the oil might spill on components around the oil pan area. If it is not properly cleaned up, this spilled oil could drip after the procedure is complete, causing unnecessary customer complaints.
• 10221944Feb 20, 2014Engine cooling. When oil is drained through the drain plug, the oil might spill on components around the oil pan area. If it is not properly cleaned up, this spilled oil could drip after the procedure is complete, causing unnecessary customer complaints.
• 10125536Feb 20, 2014Electrical system. Supersedes Technical Service Bulletin Group 00 number 12-34 dated June 6, 2012. The process of draining oil through the drain plug is not always tidy. When oil is drained through the drain plug, the oil might spill on components around the oil pan area. If it is not properly cleaned up, this spilled oil could drip after the procedure is complete, causing unnecessary customer complaints.
• 10231119Feb 17, 2014Equipment. Technical bulletins and updates
• 10231118Feb 11, 2014Equipment. Windows XP- End of Support (EOS) and new VAS diagnostic services
• 10250993Feb 3, 2014Brakes. Brake noise analysis and handling
• 10231117Feb 3, 2014Equipment. Technical bulletins and updates
• 10125548Feb 3, 2014Brakes. Supersedes Technical Service Bulletin Group 46 number 14-67 dated January 21, 2014. Customer may report hearing brake noise from front or rear brakes. Customers may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking. Before proceeding with any of the following steps, check for any applicable TSBs for brake noise. This TSB should not be used if another brake noise TSB is available…
• 10228393Jan 31, 2014Electrical system. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10225072Jan 31, 2014Electrical system. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10222045Jan 31, 2014Electrical system, Engine cooling. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
• 10122184Jan 31, 2014Electrical system, Engine. Supersedes Technical Service Bulletin Group 01 number 13-86 dated April 15, 2013. The MIL is on. There is a rough idle. DTCs are stored in the ECM. Engine may have reduced performance without significant loss of power or stalling. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis…
• 10054979Jan 31, 2014Engine. Audi: the engine would have a rough idle, different misfire faults or reduced performance without loss of power or stalling, that causes the malfunction indicator lamp (mil) on. Model 2008-2015 a3, a4, allroad, tt, a5, a5 cabriolet, q5, a6.
• 10251028Jan 21, 2014Steering. Alignment - Repair Authorization
• 10122193Jan 21, 2014Brakes. Supersedes Technical Service Bulletin Group 46 number 14-64 dated January 2, 2014. Customer may report hearing brake noise from front or rear brakes. Customers may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking. Before proceeding with any of the following steps, check for any applicable TSBs for brake noise. Also refer to the Audi Brake Systems brochure for helpful information.
• 10122189Jan 21, 2014Wheels, Steering. Supersedes Technical Service Bulletin Group 44 number 13-39 dated July 12, 2013. Vehicle pulls (left or right). Steering wheel is not level or is off-center. These conditions may be noticed during PDI. If the condition is due to outside influence (such as an accident), this TSB does not apply. In an effort to gain information on this condition, Audi of America is asking you to contact the Audi Technical Assistance…
• 10231122Jan 20, 2014Equipment. Technical bulletins and updates
• 10249096Jan 10, 2014Engine cooling. ECM Software Update (FED_EMS)
• 10122169Jan 10, 2014Electrical system. Under certain conditions, permanent mode $0A DTC codes concerning the fuel pump power stage module may remain visible after the vehicle?s OBD system has run the proper monitors successfully to allow the DTC to be erased by the system, after a proper repair. This software malfunction may cause vehicle to not pass IM inspection programs. This software update eliminates specific permanent DTC codes stored in mode $0A…
• 10122192Jan 9, 2014Brakes, Steering, Wheels. Supersedes Technical Service Bulletin Group 46 number 12-23 dated June 18, 2012. Customer may report that the steering wheel vibrates or pulsates when the brakes are applied. Document contains the brake pulsation diagnostic guidelines.
• 10122199Jan 3, 2014Electrical system. Supersedes Technical Service Bulletin Group 91 number 11-16 dated October 5, 2011. During a Bluetooth call, the sound is difficult to hear for the other party. Voice recognition accuracy is poor. This TSB provides guidelines for testing microphones in a vehicle.
• 10122190Jan 2, 2014Brakes. Customer may report hearing brake noise from front or rear brakes. Customers may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking. Before proceeding with any of the following steps, check for any applicable TSBs for brake noise. Also refer to the Audi Brake Systems brochure for helpful information.
• 10216606Jan 1, 2014Brakes. Tire Pressure Table.
• 10216605Jan 1, 2014Brakes. Tire Pressure Table.
• 10216600Jan 1, 2014Equipment. Maintenance.
• 10121453Dec 17, 2013Equipment. This document contains the Audi vehicle condition checklist. This document is in Spanish.
• 10243767Dec 16, 2013Equipment. Audi Elsa Newsletter
• 10121460Dec 12, 2013Tires, Equipment. This document contains the Audi normal load condition tire pressure table. This document is in Spanish.
• 10121442Dec 12, 2013Equipment. This document contains the Audi technician report checklist. All items must be completed prior to customer delivery by an Audi technician. Refer to the Special functions tab of ODIS Diagnosis using GFF for the PDI function tests. Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection. This document is in Spanish.
• 10121441Dec 12, 2013Equipment. This document contains the Audi delivery report checklist. This document is in Spanish.
• 10251027Dec 9, 2013Wheels. Tightening wheel bolts
• 10121408Dec 9, 2013Wheels. Supersedes Technical Service Bulletin Group 44 number 12-32 dated August 2, 2012. Wheel bolt requires torque adjustment. Torque sticks, torque extension bars, and impact guns/wrenches are not approved by Audi of America, Inc., and should not be used to apply torque to wheel bolts. Always use a calibrated torque wrench to attain the correct wheel bolt torque and follow the proper wheel tightening procedure as…
• 10054859Dec 9, 2013Equipment. Audi: on certain vehicles, use calibrated torque wrench and not torque sticks, torque extension bars and impact guns/wrenches not approved for usage on wheel bolts by manufacturer, that can cause damage to brake, steering wheel, hub. Model 1995-2014 all.
• 10226450Dec 6, 2013Lane departure. False warning by lane change assistant (Audi Side Assist)
• 10121423Dec 6, 2013Lane departure. Supersedes Technical Service Bulletin Group 96 number 13-75 dated September 23, 2013. Customer complains that Audi Side Assist is providing false warnings (no vehicle is present in the blind spot). The concern may or may not be duplicated. No DTCs are present in the Audi Side Assist system. The mounting brackets for the control units may be loose or broken. Incorrect hardware from the supplier. The mounting bracket…
• 10226448Dec 5, 2013Lane departure. Lane Change Assistant "Sensors Blocked" warning in DIS (DTC C1114F3 and C1115F5)
• 10121421Dec 5, 2013Lane departure. Supersedes Technical Service Bulletin Group 96 number 13-77 dated September 23, 2013. Audi Lane Change Assistant deactivates or is sporadically inoperative when the vehicle is driven in slow-moving stop-and-go traffic, especially on roads with multiple lanes.The message "Audi side assist unavailable: Sensors blocked" appears in the driver information system. The system is able to be activated approximately ten…
• 10121409Dec 5, 2013Brakes. Customer may report hearing brake noise from front or rear brakes. Customers may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking.
• 10068752Dec 5, 2013Lane departure. Summary to be provided on a future date.
• 10204498Nov 26, 2013Body and structure. Components on the doors or the parcel shelf vibrate while heavy bass audio is played.
• 10121506Nov 26, 2013Body and structure, Equipment. Supersedes Technical Service Bulletin Group 57 number 12-70 dated September 5, 2012. Vibration noises from the doors or the rear parcel shelf are heard, particularly when heavy bass audio is playing. Components on the doors or the parcel shelf vibrate while heavy bass audio is played.
• 10251025Nov 21, 2013Steering. Steering wheel shimmy, vibration and/or oscillation
• 10204489Nov 21, 2013Suspension, Steering, Tires, Wheels. Customer feels vibration in the seat, vehicle floor, footwell, pedals, or steering wheel.

← All problems reported for the 2014 Audi Allroad