2020 Audi Q3 Fuel system Problems

“Car leased july 2020, has 1936 miles, check engine light came on 4/14/21, took to dealer , left for repair . Dealer states 'replace fuel pump module ' required . This car also had problem in march 2021 which I reported where car shut off while driving. Dealer said software update was required from recall that I had not gotten notice for .”

“I purchased my Audi 2020 Q3 in november 2019. Since the purchase, on three separate occasions, the car has failed to accelerate under very specific speed conditions. In each case, the vehicle had slowed either due to a sharp curve while entering a freeway or for a slower vehicle in front of my vehicle while entering the freeway. When time came to accelerate to match the speed of the freeway traffic, adding power was futile. …”

“I purchased my 2020 Q3 on dec 31 2019. Within 2 weeks my car stopped at the signal light with a malfunction of auto stop/start issue and would not move forward. I had taken to the dealer and they mentioned that this is a known issue with 2020 Q3 and the software to fix the auto stop/start function will not be available untill end of 1st quarter. Now I am seeing the gas consumption high and the vehicle does not drive as before.”

“We stopped at an all way stop intersection and the car's stop-start system had turned off the engine. When the engine restarted the engine hesitated, warning lights lit up on the dash, and the car went into its limp home mode. We were in the process of making a left hand turn and the car would not accelerate above a very slow speed. Luckily it was on a city street with a 25 MPH limit and traffic was light. We were able to make it through the intersection and pull to the side of the road. We turned the car off and waited a few seconds and restarted it. …”

“While driving my 2 month old Audi Q3 this morning the car completely stalled while going approximately 40 MPH. I received an error message, drive line malfunction. The car would not respond at all after applying the accelerator. I was almost hit by 2 trucks!!! I then put the car in park and it was able to start it up. I brought it to the dealer, they just called me and told me they found an error code p060c00 indicating an internal control module problem. They said that there is no known fix at this time but they said that there is a known service bulletin on this issue. …”