2014 Audi S6 Technical Service Bulletins

777 technical service bulletins (TSBs) are on record for the 2014 Audi S6. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10243792Jun 3, 2013Equipment. Audi Elsa Newsletter
• 10249666Jun 1, 2013Equipment. Audi delivery guidelines
• 10210650May 29, 2013Brakes. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who consciously or unconsciously drive with their left foot resting on the brake pedal are prone to experience this condition. With the introduction of Electronic Power Control (EPC) (no accelerator cable) to fuel injection systems, an engine RPM control feature has been incorporated into the engine…
• 10228289May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10221941May 14, 2013Engine cooling. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
• 10124941May 14, 2013Engine. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
• 10123901Apr 1, 2013Equipment. Supersedes Technical Service Bulletin Group 00 number 11-19 dated April 8, 2011. This TSB contains information on technician preparation when calling the Audi Technical Assistance Center
• 10123882Mar 25, 2013Engine cooling. Supersedes Technical Service Bulletin Group 19 number 11-19 dated February 10, 2011. Discontinuation and mixing of Audi-approved engine coolants. G11, G12, and G12+ coolants have been replaced by an improved version. G12++ coolant (for service available) has been introduced in MY 2005 for all engines. G13 has been introduced in MY 2008 as factory filling and service.
• 10123997Feb 28, 2013Equipment, Latches, locks and linkages. Supersedes Technical Service Bulletin Group 57 number 12-72 dated September 24, 2012. Keyless entry is inoperative. Remote range is poor. Audi Advanced key is inoperative. High early warranty information related to inoperative remote keys necessitates this repair authorization. Through our combined efforts and cooperation, we will be able to raise the level of Audi quality and overall customer satisfaction.
• 10251023Feb 18, 2013Suspension. Steering wheel shimmy, vibration and/or oscillation
• 10250475Feb 18, 2013Steering. Steering wheel shimmy, vibration and/or oscillation
• 10123987Feb 18, 2013Suspension. Supersedes Technical Service Bulletin Group 44 number 13-35 dated January 18, 2013. Customer feels vibration from 55 - 80 mph (88 - 128 km/h) in the seat, vehicle floor, footwell, pedals, or steering wheel. This condition does not result in any handling concerns or loss of vehicle control.
• 10250423Feb 14, 2013Engine cooling. Idle speed characteristic during cold start
• 10124007Feb 14, 2013Exterior lighting, Electrical system. Supersedes Technical Service Bulletin Group 94 number 12-79 dated June 6, 2012. Light bulb warning light and the message Vehicle lights: malfunction is displayed in the instrument cluster display. DTC 03280 (Light switch position implausible signal) is stored in the vehicle electrical system control module, J519 (09). Exterior lights are functioning properly.
• 10123969Feb 14, 2013Engine cooling. Supersedes Technical Service Bulletin Group 01 number 12-57 dated October 29, 2012. Noises/inconsistent engine operation after cold start during the catalyst heating phase. The customer may interpret this engine roughness as misfiring. To comply with the legal requirements on exhaust gas emissions according to the LEV-1 and LEV-2 standards, a high exhaust gas quality must be ensured. The necessary catalyst only…
• 10124000Feb 5, 2013Back-over prevention (rear camera). Supersedes Technical Service Bulletin Group 91 number 12-61 dated October 1, 2012. Parking aid sporadically warns of obstacles when none exist. Parking aid is inoperative or provides constant warning. Various parking aid sensor fitting issues. Environmental conditions.
• 10251018Jan 18, 2013Steering. Steering wheel shimmy, vibration and/or oscillation
• 10243887Jan 10, 2013Equipment. Informe del técnico de Audi
• 10243886Jan 10, 2013Equipment. Informe del técnico de Audi
• 10216682Jan 9, 2013Engine cooling. Engine oils that meet Audi Oil Quality Standards.
• 10244038Jan 3, 2013Equipment. 2014 Scheduled Maintenance Intervals
• 10253418Jan 1, 2013Equipment. Audi Delivery Guidelines.
• 10253417Jan 1, 2013Equipment. Audi Delivery Guidelines.
• 10121550Dec 12, 2012Equipment. This document contains the scheduled maintence intervals.
• 10122674Dec 7, 2012Equipment, Electrical system. The customer may state that the outside ambient temperature display is incorrect. To achieve a smoothening effect of the displayed outside ambient temperature, the value shown does not instantaneously follow the temperature sensor measurement. The display will not change faster than 4° F (2° C) per minute. This concept applies to both falling and rising temperatures.
• 10250415Oct 29, 2012Engine cooling. Idle speed characteristic during cold start
• 10122803Oct 29, 2012Engine cooling. Supersedes Technical Service Bulletin Group 01 number 12-51 dated July 18, 2012. Noises/inconsistent engine operation after cold start during the catalyst heating phase. The customer may interpret this engine roughness as misfiring. To comply with the legal requirements on exhaust gas emissions according to the LEV-1 and LEV-2 standards, a high exhaust gas quality must be ensured. The necessary catalyst only…

← All problems reported for the 2014 Audi S6