2014 Buick Enclave Technical Service Bulletins

1,567 technical service bulletins (TSBs) are on record for the 2014 Buick Enclave. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10140340Nov 28, 2017Equipment. This preliminary information bulletin provides a procedure on how to check for the customer concern of a blank radio with/without audio, by checking the the wiring harness, ECU and reprograming the HMI software update, if the wiring or ECU are not the cause.
• 10139095Nov 22, 2017Equipment. This bulletin describes the Dealer special tool loan program process.
• 10139089Nov 22, 2017Equipment, Transmission and drivetrain, Engine. This informational bulletin provides information to dealership personnel on automatic transmission shift and engine drivability concerns and/or MIL ON due to aftermarket oil bath air filter use.
• 10125126Nov 20, 2017Electrical system. This Preliminary Information communication a diagnostic tip if the high speed lan bus is shorted to ground, which can cause the BCM to appear off line.
• 10139118Nov 17, 2017Equipment. This informational bulletin provides a listing of the parts availability for coax repair procedures and what is needed to complete some repairs.
• 10139108Nov 17, 2017Visibility (wipers, defrost, mirrors). This informational bulletin provides information for assisting the customer in setting the position for the memory mirror and the reverse tilt
• 10139090Nov 17, 2017Engine, Electrical system. This technical bulletin provides repair information for repairing the IP to body harness connector to correct a customer concern for intermittent Malfunction Indicator Lamp (MIL) illuminated with Reduced Engine Power displayed and DTC P2138 set.
• 10125106Nov 7, 2017Electrical system. This Preliminary Information communication provides information to the technician about vehicle's odometer appears to be inaccurate relative to a known distance traveled. Technician should obtain a hand-held GPS unit to test the odometer. If a hand held GPS unit is not available, the only other option is to verify the miles traveled using a surveyor's wheel or a dynamometer.
• 10134633Oct 31, 2017Fuel system. This engineering informational bulletin is requesting information from the field on vehicles that have the condition of Engineering Information ? Malfunction Indicator Lamp (MIL) On DTCs P0171 Fuel Trim System Lean Bank 1 and/or P0174 Fuel Trim System Lean Bank 2.
• 10134594Oct 25, 2017Equipment, Engine. This warranty administration bulletin provides dealership personnel with policy and procedure requirements for essential tools that include consumable parts (U.S. Only).
• 10134621Oct 24, 2017Equipment. This informational bulletin provides information for the IPC odometer programming method quick reference guide.
• 10134592Oct 23, 2017Electrical system. The information in this bulletin details the proper configurations for the ignition key, fob, key tags, key rings, key ring sizes and applying a QR code sticker or barcode sticker to a key fob.
• 10134613Oct 18, 2017Suspension. This informational bulletin provides information to inspect the strut/spring assembly and front lower control arm bushing including the front lower control arm rear bushing for damage/wear causing a clunk type noise heard over bumps.
• 10123252Oct 13, 2017Equipment, Electrical system. This Preliminary Information communication provides information to the technician about vehicles that have an intermittent no crank, no start, or start stall concern with the security light coming on. Technician may find Diagnostic Trouble Codes B3055, B3060, and/or B3935. Technician should not replace any parts for this concern. If unable to duplicate the concern ask if the customer uses any Radio Frequency…
• 10134593Oct 11, 2017Equipment. This informational bulletin provides technicians with updated information to help identify the differences between what is considered a fluid leak, and what is considered seepage.
• 10134578Oct 11, 2017Engine cooling. This informational bulletin explains a normal small exhaust leak and residual build up on the EGR housing.
• 10123232Oct 10, 2017Engine. This Preliminary information communicates the identification process for High Feature V6 camshafts in re-manufactured engines.
• 10134581Oct 6, 2017Wheels. This bulletin provides a procedure to clean the back side of the rims and rotors and to correct the customers concern of wheel clicking.
• 10123227Oct 5, 2017Electrical system. This Preliminary Information communication provides information to the technician about vehicles that have a Diagnostic Trouble Code B101D-37 history in the Vehicle Communication Interface Module or telematics communication interface control module. Engineering has determined that this code will only display in history on the scan tool and will not cause issues with OnStar system operation.
• 10123222Oct 3, 2017Equipment, Electrical system. This Preliminary Information communication provides information to the technician about what XM offerings are available for vehicles. A dealer or customer can access the website listed below for vehicle specific XM offerings and availability.
• 10190376Oct 1, 2017Fuel system, Other or unknown, Equipment. Engineering Information – Malfunction Indicator Lamp (MIL) On, DTCs P0171 Fuel Trim System Lean Bank 1 and/or P0174 Fuel Trim System Lean Bank 2
• 10190338Oct 1, 2017Equipment. Essential Tools that Include Consumable Parts (U.S. Only)
• 10190337Oct 1, 2017Suspension. Information Regarding the Differences Between Fluid Leakage and Seepage This bulletin is intended to help identify the differences between what is considered a fluid leak and what is considered seepage. Improper diagnosis may lead to unnecessary component replacement. Use the following information to determine if the condition is normal acceptable seepage or a defective component
• 10190336Oct 1, 2017Equipment. Information for Fleet Vehicles – Ignition Key, Fob and Key Rings Configuration Some Customers are bundling multiple keys, fobs, and key tags together on a single crimped loop or a cable. This practice may result in unintended key rotation, and should be discontinued immediately. The information in this bulletin details the proper configurations for the ignition key, fob, key rings and key tags and applying a QR…
• 10190321Oct 1, 2017Equipment. Information for Fleet Vehicles – Ignition Key, Fob and Key Rings Configuration Some Customers are bundling multiple keys, fobs, and key tags together on a single crimped loop or a cable. This practice may result in unintended key rotation, and should be discontinued immediately. The information in this bulletin details the proper configurations for the ignition key, fob, key rings and key tags and applying a QR…
• 10190320Oct 1, 2017Electrical system, Equipment. IPC Odometer Programming Method Quick Reference Guide
• 10190272Oct 1, 2017Wheels, Equipment. Clicking Noise from Front Wheels While Turning at Slow Speeds Condition Some customers may comment on a clicking noise emanating from the front wheels location. This condition may be more predominant at low speeds (10-20 mph or 16-32 km/h) during full wheel lock turns on dry clean pavement. Cause - his may be caused by interaction between the wheel mounting face and the wheel mounting surfaces on the brake rotor…
• 10157041Sep 28, 2017Electrical system. This Preliminary Information communication provides information to the technician about vehicles that have a Diagnostic Trouble Code B101D stored in Telematics Communication Interface Control Module. Technician will use Global Diagnostic System 2 to review the Firmware Over-the-Air version. If the Firmware Over-the-Air version on the scan tool equals 6708 the technician will need to contact General Motors Technical…
• 10159634Sep 26, 2017Fuel system, Electrical system. This engineering informational bulletin is requesting information from the field on vehicles that have the condition of Engineering Information ? Malfunction Indicator Lamp (MIL) On DTCs P0171 Fuel Trim System Lean Bank 1 and/or P0174 Fuel Trim System Lean Bank 2.
• 10159623Sep 26, 2017Engine cooling. This informational bulletin provides information of a possible misfire that may happen from incorrect camshafts being installed in the reman engines.
• 10159570Sep 20, 2017Electrical system. This warranty administration bulletin provides policy information on the requirements for battery testing and warranty replacements.
• 10157020Sep 20, 2017Equipment, Electrical system. This Preliminary Information communication provides information to the technician about the use of J-35616-64B terminal test probe, replacement terminals, and terminated leads. The J-35616-64B is the latest test probe released for checking tension or probing the .64 series terminals. The test probe terminal has been released in the terminal repair kit (J-38125-620H) located in Lear Tray 7 part number 963716-2.
• 10157018Sep 20, 2017Fuel system, Tires, Equipment, Electrical system. This Preliminary Information communicates to the dealer the process for downloading or updating operating software for the Tire Pressure Monitor, Active Fuel Injector tester, multi media tester, PICO Scope, GR8 starting/charging tester and Vehicle Data Recorder tools, giving website address and step by step instructions to complete the update.
• 10159575Sep 14, 2017Electrical system. This warranty admin bulletin explains to the technician additional information may be needed when submitting transactions when doing wiring repairs.
• 10159572Sep 14, 2017Equipment. This informational bulletin explains the importance of maintaining the vehicle.
• 10159569Sep 12, 2017Engine cooling, Equipment. This informational bulletin advises the possible issues that may occur using a scotch brite pad or highly abrasive disk on gasket sealing surfaces or reused parts.
• 10156999Sep 11, 2017Equipment. This Preliminary Information communication provides information to the technician about vehicle that may have an OnStar system that has progression tones when pressing the blue or red button. Technician will need to call General Motors Technical Assistance Center with the scan tool data from the OnStar system.
• 10156990Sep 6, 2017Equipment. This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts/kits. Technicians should refer to Service Information for information regarding most accessories. Technicians may also contact Partech and/or the Techline Customer Support Center for additional support.
• 10159574Sep 5, 2017Engine. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement.
• 10140293Aug 31, 2017Engine cooling. This informational bulletin provides information on Intake Manifold Inspection/Replacement After Severe Internal Engine Damage.
• 10140298Aug 30, 2017Equipment. The intent of this technical bulletin is to identify aftermarket ALDL or DLC interface devices as potential sources for causing multiple customer concerns that do not have other diagnostic methods to identify them.
• 10140406Aug 23, 2017Body and structure, Equipment. Thins informational bulletin provides information on Paint-less Dent Repair Process.
• 10140396Aug 23, 2017Wheels. This bulletin provides a procedure to clean the back side of the rims and rotors and to correct the customers concern of wheel clicking.
• 10137735Aug 23, 2017Engine cooling. This Preliminary Information communication provides information to the technician with information regarding high misfire rates always on #1 cylinder. A customer may complain of misfires or roughness on cold start up with a P0300 diagnostic trouble code. Technician is to add coolant dye to the system and run the engine through warm up to circulate the dye. Pressurize the cooling system after a cold soak and inspect…
• 10137734Aug 23, 2017Engine. This Preliminary Information communication provides information to the technician that Diagnostic Trouble Codes P0016, P0017, P0018, P0019, P0008 or P0009 may be set. Technician will need to inspect for loose timing chains or tensioners. If after following Service Information diagnostics the root cause is not found inspect the reluctor for the crankshaft sensor. If the reluctor has moved then replace crankshaft.
• 10140294Aug 22, 2017Electrical system. This informational bulletin communicates part restriction and ordering process information for OnStar Vehicle Communication Interface Modules (VCIM) (GMNA Only).
• 10137727Aug 21, 2017Engine. This Preliminary Information communication provides information to the technician about engine block of possible cylinder bore damage, scoring or out of round as the possible cause of engine oil consumption, misfire, cylinder leakage or blow by. Technician will need to inspect the engine for Cylinder damage or scoring, An out of round cylinder bore, Dirt intrusion, and Catalytic Converter failure.
• 10137705Aug 9, 2017Equipment. This Preliminary Information communication provides information to the technician about customers that may complain of various concerns when using Bluetooth components. Technician should use the Preliminary Information to gather information from the customer on their Bluetooth device and the concern they are having before calling General Motors Technical Assistance Center.
• 10140296Aug 7, 2017Equipment. This warranty administration bulletin provide policy information on required operating procedures.
• 10140297Aug 2, 2017Equipment. This warranty administration bulletin provide policy information on warranty and policy exchange program for electronic products for U.S. and Canada dealers only.

← All problems reported for the 2014 Buick Enclave