2017 Cadillac Escalade Technical Service Bulletins

1,446 technical service bulletins (TSBs) are on record for the 2017 Cadillac Escalade. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10171264Jan 10, 2020Engine cooling. This Preliminary information communicates to the dealer additional information on checking for the engne crankcase being overfull on oil causing an engine vibration concern. The technician is advised to inspect for contaminnants and adjust the engine oil level as needed.
• 10171259Jan 7, 2020Transmission and drivetrain, Engine. This Preliminary Information communication provides information to the technician on the steps need to diagnose and repair vehicles that may have stalling shudder and/or hard shifting into 1st gear or reverse vibration on launch (with excessive crankshaft end play). Technician will test to determine if the crank shaft end play is within specification 0.0015?0.0086 inch.
• 10171878Jan 2, 2020Fuel system, Equipment. This informational bulletin advises of a new fuel injection cleaner kit used for decarbonizing the intake valves to correct conditions of rough idle, Crank no start, extended crank or misfire, MIL with DTCs, and explains how Top Tier fuels should be used to reduce carbon build-up.
• 10170483Dec 19, 2019Other or unknown. This Preliminary Information communication provides information to the technician that a customer may request the factory Integrated Trailer Brake Control be bypassed and their aftermarket trailer brake controller be installed instead. Technician will need to gain access to the body harness. Install trailer brake controller harness General Motors part number 23184088 into Middle Bus Electrical Center (X61A).
• 10170498Dec 12, 2019Equipment. This preliminary information bulletin provides information om Service Programming System (SPS) Error Codes (E4398, E4399, E4403, M4404, M4413, M6954, M6955, E4414, E4423, E4491 or E6961).
• 10169357Nov 26, 2019Equipment. This informational bulletin provides information on key code security rules and information on GM keycode look-up applications.
• 10169355Nov 25, 2019Equipment. This informational bulletin provides information for dealers/technicians on Use of Dealer Case Management (DCM) and Being Prepared for Contacting U.S. Technical Assistance (TAC).
• 10168978Nov 22, 2019Transmission and drivetrain. This Preliminary information communicates to the dealer technician that TAC recommends the utilization of the GDS2 software to aid in diagnosing automatic transmission concerns. TAC is requesting the GDS2 session logs be sent in before the dealer contacts TAC.
• 10168975Nov 22, 2019Engine cooling. This Preliminary Information communication provides information to the technician about vehicles that have a coolant loss and/or coolant odor after driving the vehicle. Technician will need to test the cooling system looking for leaks at the outer head bolts. If coolant is found replace the head the concern is present on.
• 10169270Nov 20, 2019Brakes. This technical bulletin provides a procedure to add PET tape to the brake cables if the cause of the customers concern.
• 10169340Nov 19, 2019Equipment, Body and structure. This preliminary informational bulletin provides frame coating repair information to correct a customer concern of wax coating on frame peeling, metal shows corrosion/rusting (U.S. and Canada Only).
• 10169315Nov 18, 2019Engine. This diagnostic tip provides a procedure to aid in performing a diagnostic test to verify if the camshaft alignment pin has been sheared away.
• 10169309Nov 15, 2019Fuel system, Engine. This Bulletin provides information for rebuilding fuel injectors in the event of an underhood fuel odor and/or extended cranking condition.
• 10169298Nov 13, 2019Transmission and drivetrain. Information on Transmission Adaptive Functions and Correcting Low Mileage Harsh Shifts, Slips, or Flares.
• 10169356Nov 12, 2019Equipment, Wheels, Tires. This technical bulletin provides a procedure on how to clean and resurface aluminum wheel bead seats for vehicles that have the condition of Tire Slowly Goes Flat, Tire Air Loss, Low Tire Pressure Warning Light Illuminated, Aluminum Wheel Bead Seat Corrosion.
• 10169354Nov 12, 2019Equipment, Exterior lighting. This informational bulletin provides information for dealers/technicians on Exterior Lamp Condensation and Replacement Guidelines.
• 10168964Nov 12, 2019Equipment. This Preliminary information communicates a normal DIC message after learning keys/fobs which indicates the drivers memory position.
• 10168960Nov 12, 2019Brakes, Wheels. This Preliminary Information communication provides information to the technician about changing the tire and wheel size on vehicles. General Motors will only support a tire calibration for tires that have been sized, tested and designed for the vehicle in question and its applications. Technician should not use the information that is provided by the antilock braking system tire size selection.
• 10168959Nov 7, 2019Engine cooling. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have a buffeting vibration and/or drone type noise, exhaust tone change, and/or body pressure booming. Replace or repair any of the issue that was found in the inspection. If the vehicle is equipped with a 4.3 liter or 5.3 liter engine an updated exhaust system is now available.
• 10168958Nov 7, 2019Engine cooling. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on. Technician will find Diagnostic Trouble Codes P0340 and P0341 setting at times. Technician should use normal published Service Information diagnostics. If normal Service Information diagnostics does not isolate the concern, inspect for corrosion in connector…
• 10168956Nov 5, 2019Electrical system. This Preliminary Information communication provides information to the technician about the use of J-35616-64B terminal test probe, replacement terminals, and terminated leads. The J-35616-64B is the latest test probe released for checking tension or probing the .64 series terminals. The test probe terminal has been released in the terminal repair kit (J-38125-620H) located in Lear Tray 7 part number 963716-2.
• 10168212Oct 29, 2019Transmission and drivetrain. This informational bulletin provides information on Driveline Clunk Noise and what is acceptable and what is considered normal operations.
• 10167465Oct 28, 2019Electrical system, Visibility (wipers, defrost, mirrors). This Preliminary information communicates if the sunroof, rear sliding window, and/or wireless charging are found to be inoperative due to the F2DL and/or the F8DL fuse(s) being open. Inspect the center console harness area at the hinge pivot point for chaffed circuits.
• 10167463Oct 28, 2019Electrical system. This Preliminary information communicates that an inoperative third row folding seat back may not fold down or up. This information advises dealers on how the seat functions and also a common area where an open circuit may be found between the third row seat module and the seat position sensor.
• 10167459Oct 25, 2019Engine cooling. This Preliminary Information communication provides information to the technician on the steps needed to diagnose and repair vehicles that may have a rattle noise from the dash. Technician will need to inspect for the rear heater pipes contacting the passenger side exhaust manifold. If the rear heater pipe is found to be contacting the exhaust manifold, reposition the heater pipe so it no longer makes contact.
• 10168218Oct 24, 2019Transmission and drivetrain. This engineering information bulletin ends the need for information from the field on an Intermittent No Forward and/or No Reverse While Driving condition. If this condition is encountered, refer to SI for further diagnosis.
• 10167455Oct 22, 2019Equipment. This Preliminary information communicates the use of air leak diagnostic test tool CH-52250 in addition to the information found in the service manual.
• 10168207Oct 16, 2019Equipment. This informational bulletin provides information for dealers how to submit a product information report (PIR) (Canada Only).
• 10167442Oct 15, 2019Electrical system. This Preliminary information communicates if the liftglass will not open using keyless entry to verify Valet Mode is not enabled.
• 10168175Oct 14, 2019Transmission and drivetrain. This Bulletin provides guidelines for Dealers Not Required and for Dealers Required to Contact the PQC for engine or transmission assembly replacement and explains the PQC process, GWM Transaction submission, vehicle service record retention and proper handling of assembly returns.
• 10167437Oct 14, 2019Engine. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components. That any of the listed DTC's may set with or without poor engine performance.
• 10168185Oct 11, 2019Electrical system. This technical bulletin provides a procedure for testing the battery cables for voltage drop, Checking for a bad ground at g218, Inspecting for a short at the starter B+ to shield and testing for a faulty battery.
• 10167479Oct 11, 2019Brakes, Engine cooling. N182202780 01 - Special Coverage. Certain Vehicles may have a condition where customers may experience increased brake pedal effort, hardbrake pedal, and/or potentially increased stopping distance. The condition is more prevalent at low speed when softly applyingthe brakes. The engine mounted mechanical vacuum pump outputmay decrease over time decreasing the amount of vacuum/power brake assist. Failure to follow…
• 10167434Oct 10, 2019Electrical system. This Preliminary Information communication provides information to the technician about vibration complaints that are one of the most challenging complaints to accurately diagnose and repair. Technician will need to use Pico Oscilloscope Diagnostic Kit to effectively diagnosis vehicles. Technician should drive the vehicle will using the Pico Oscilloscope to record data. After the data is recorded it should be…
• 10168208Oct 9, 2019Equipment. This informational bulletin provides information on key code security and information on GM key code look up applications.
• 10168205Oct 9, 2019Engine cooling. This informational bulletin provides guidelines and diagnostic/repair information to technicians regarding vehicle engine oil consumption.
• 10168176Oct 8, 2019Transmission and drivetrain. This informational bulletin explains possible normal condition of a flare from 1st to 2nd, even if the trans had been repaired for the flare and its still noticed.
• 10168204Oct 2, 2019Equipment. This informational bulletin provides information on comebacks prevention information and using customer concern verification sheets (CCVS).
• 10168188Oct 2, 2019Equipment. This Warranty Administration bulletin provides information for dealers/Service advisors on when and how to submit a Pre-Repair Authorization (PRA) (US dealers only).
• 10165914Sep 30, 2019Engine cooling. This Preliminary Information communication provides information to the technician on how to diagnose and repair vehicles that may have Diagnostic Trouble Code P06DD or no or low oil pressure. Technician will replace timing chain tensioner guide. If oil pump face is damaged and or worn thru replace oil pump. Inspect bearings for damage wear due to debris from oil pump.
• 10165905Sep 26, 2019Body and structure. This Preliminary information communicates and issue with the hood ajar message being displayed when the hood is not ajar. Inspect the body ground strap to insure it is connected in the proper locations and the strap eyelets are tight and do not rotate.
• 10165904Sep 25, 2019Electrical system. This Preliminary Information communication provides information to the technician about a no start or another concern after swapping an Engine Control Module or other modules from one vehicle to another. The Global Architecture electrical system associated with these vehicles does not allow controller swaps between vehicles.
• 10166659Sep 20, 2019Engine cooling. This diagnostic tip provides additional information on how to diagnose a possible valve, lifter or camshaft issue.
• 10166638Sep 18, 2019Equipment. This warranty administration bulletin provides information regarding the field action courtesy transportation policy.
• 10166241Sep 17, 2019Equipment. 17336 05 - Special Coverage. On some vehicles, may have a condition where thermal cycling on the combination transmission fluid/oil and AC condenser cooler creates a crack that may allow refrigerant to escape. This condition consequently may deactivate the AC system which may cause potential customer annoyance.
• 10166635Sep 16, 2019Engine cooling. This diagnostic tip provides information to the tech to aid in performing a diagnostic test to verify if the camshaft alignment pin has been sheared away.
• 10166640Sep 11, 2019Engine cooling. This technical bulletin provides a procedure to measure vibration and install engine mounts to correct a Rough Idle in Drive concern.
• 10165877Sep 6, 2019Electrical system. This Preliminary Information communication provides information to the technician that General Motors Technical Assistance Center may ask for Global Diagnostic System 2 Session Log. Technician will need use Global Diagnostic System 2 to send the session logs to General Motors Technical Assistance Center for further assistance on the vehicle in question.
• 10165874Sep 5, 2019Equipment. This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts/kits. Technicians should refer to Service Information for information regarding most accessories. Technicians may also contact PARTECH and/or the Techline Customer Support Center for additional support.
• 10165872Sep 5, 2019Electrical system. This Preliminary Information communication provides information to the technician about vehicles that have "ADAPTIVE CRUISE TEMPORARILY UNAVAILABLE" message on the Driver Information Center when attempting to activate the cruise. Technician should consider environmental factors, repair, collision, aftermarket parts, and radar alignment factors.

← All problems reported for the 2017 Cadillac Escalade