2017 Cadillac Escalade Technical Service Bulletins

1,446 technical service bulletins (TSBs) are on record for the 2017 Cadillac Escalade. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10164789Aug 29, 2019Engine cooling. This Preliminary Information communication provides information to the technician on how to diagnose and repair vehicles that may have Diagnostic Trouble Code P06DD or no or low oil pressure. Technician will replace timing chain tensioner guide. If oil pump face is damaged and or worn thru replace oil pump. Inspect bearings for damage wear due to debris from oil pump.
• 10165127Aug 23, 2019Electrical system. This preliminary information bulletin provides information om Service Programming System (SPS) Error Codes E4398, E4399, E4403, M4404, M4413, E4414, E4423, E4491 or E6961).
• 10165087Aug 23, 2019Equipment. This warranty administration bulletin provides policy information, proper labor operation selection and causal part identification for warranty transactions (U.S. Only).
• 10165124Aug 21, 2019Engine cooling. This bulletin provides information on identifying Non-GM Engine Calibrations for Gasoline Engines using the Tech 2 or GDS 2.
• 10165126Aug 19, 2019Equipment. This bulleting provides Wiring, Terminal and Connector Repair Information including how to determine the Service Part Number in eSI and how to locate the part(s) in the EPC.
• 10165121Aug 15, 2019Engine cooling. This informational bulletin provides information on replacing the intake manifold when the engine is replaced after severe internal engine damage.
• 10165441Aug 13, 2019Electrical system, Equipment. N192218430 - Customer Satisfaction Program. During service, certain vehicles equipped with OnStar (RPO UE1), may have received an incorrect and partially programmed/configured replacement OnStar module. This condition will disable certain OnStar features, including Remote Access (remote start, door lock/unlock, etc.), Connected Access (vehicle diagnostics, dealer maintenance notification, etc.), and Unlimited…
• 10165122Aug 13, 2019Engine cooling. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement.
• 10165123Aug 12, 2019Transmission and drivetrain. This informational bulletin provides information on Some vehicles may rock or move slightly forward or rearward while in Park at start up after cold soak. This condition may be accompanied by a clunk noise. This is a slight movement that is more often seen visually, rather than felt, when viewed from the outside and using the auto-start feature, if equipped.
• 10164757Aug 8, 2019Steering, Visibility (wipers, defrost, mirrors), Electrical system. This Preliminary Information communication provides information to the technician about vehicles that may have any of these concerns remote keyless entry, passive Entry and Start Inoperative, No Fob detect message on driver information center, service tire pressure system, no audio, touch screen Inoperative, Steering Wheel Controls Inoperative, Service Stabilitrak, rear power windows inoperative, rear wiper…
• 10164749Aug 7, 2019Visibility (wipers, defrost, mirrors). This Preliminary Information communication provides the technician with steps to resolve the issue of an oily substance that may be found on the inside windshield surface, and appears to be leaking from the rear view mirror area. Technician will remove the moisture sensor and clean the glass and mounting bracket with alcohol wipe. If the gel separates from the sensor the sensor will need to be replaced.
• 10164748Aug 7, 2019Forward collision avoidance, Lane departure, Engine, Electrical system. This Preliminary Information communication provides information to the technician for the adaptive cruise control or lane keep assist unavailable message in the driver?s information center after the vehicle has been parked in direct sunlight and high ambient temperatures. The cameras electronic control unit?s internal operating temperature range is -40 degrees Celsius to 85 degrees Celsius.
• 10165135Aug 6, 2019Transmission and drivetrain. This engineering information bulletin is requesting information from the field to validate a field fix. Before contacting engineers, remove the transmission oil pan and inspect for nickel to quarter size pieces of aluminum debris in the oil pan. The 2-3-4-6-8 and 4-5-6-7-8 reverse clutch assembly and the 1-3-5-6-7 clutch assembly may be broken in several pieces.
• 10165079Aug 5, 2019Steering. This technical bulletin provides a procedure inspecting for excess grease or Sealant on the Exterior of the steering gear due to seeing grease or sealant on certain locations on the gear.
• 10165435Aug 1, 2019Transmission and drivetrain. N192217820 - Service Update Bulletin. The current transmission fluid may cause the customer to experience a shake or shudder feeling, which may be described as driving over rumble strips or rough pavement. Dealers are to drain the old transmission fluid and refill with the new fluid.
• 10163690Jul 31, 2019Equipment. This Preliminary information communicates AFM / DFM usage Information. providing additional information on the AFM and DFM systems
• 10164113Jul 30, 2019Electrical system, Equipment. This informational bulletin provides information for dealers/technicians on Information on Head-Up Display (HUD) on Vehicles Model Year 2017 and Newer Has Rotational Feature that Allows for Adjusting of the Angle of the HUD Image.
• 10163686Jul 30, 2019Equipment. This Preliminary information communicates additional information on how a LIN bus operates and diagnostic tips when working on a LIN bus.
• 10163890Jul 29, 2019Transmission and drivetrain. This technical bulletin provides information for new transmission oil to use and a procedure for exchanging the old fluid and adding the new fluid to correct a shake/shudder during light throttle acceleration condition.
• 10163681Jul 29, 2019Equipment. This Preliminary information communicates that when a customer or technician attempts to add a new transmitter to a vehicle following the adding transmitters without Service Programming System procedure the procedure will not complete and a message "Remote Learn Pending" will be displayed on the Driver Information Center. In the past to perform the new transmitter procedure only one previously learned transmitter…
• 10163900Jul 26, 2019Equipment. This informational bulletin provides process information for the (GWM) and (WPC) parts return program.
• 10163854Jul 26, 2019Fuel system, Engine. N182198000 - Special Coverage Adjustment - Certain vehicles, equipped with a 5.3L or 6.2L engine, may have a condition which affects fuel injector function. Under certain circumstances one or more of the vehicle?s fuel injectors may deliver an improper amount of fuel to the engine. If this occurs, the Malfunction Indicator Lamp (Check Engine Light) will illuminate, the engine may idle or run rough, and the vehicle…
• 10164120Jul 25, 2019Equipment, Transmission and drivetrain. This technical bulletin provides information for new transmission oil to use, a procedure for exchanging the old fluid and adding the new fluid to a service transmission.
• 10164119Jul 24, 2019Equipment, Brakes. This technical bulletin provides a procedure to add PET tape to the brake cables if the cause of the customers concern.
• 10163665Jul 16, 2019Wheels, Vehicle speed control. This Preliminary information communicates direction and examples when diagnosing multiple DTCs, one of which includes U**** Byte 71 DTC.
• 10163664Jul 16, 2019Back-over prevention (rear camera). This Preliminary information communicates instructions dealer to inspect for a broken or damaged side objector sensor/module bracket if there is a "Side Detection System Unavailable" message displayed at startup.
• 10164115Jul 12, 2019Equipment. This technical bulletin provides repair information to correct a customer concern of Audio Muting When Listening to Some SiriusXM Channels Due to Interference in Some Geographic Locations.
• 10163659Jul 10, 2019Equipment. This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts/kits. Technicians should refer to Service Information for information regarding most accessories. Technicians may also contact Partech and/or the Techline Customer Support Center for additional support.
• 10163272Jun 26, 2019Equipment. The intent of this technical bulletin is to identify aftermarket ALDL or DLC interface devices as potential sources for causing multiple customer concerns that do not have other diagnostic methods to identify them.
• 10163268Jun 26, 2019Equipment, Electrical system. This bulletin provides information for electrical ground repairs using new General Motors replacement fasteners with conductive finish.
• 10163261Jun 26, 2019Fuel system. This bulletin provides information on the TOP TIER Detergent Gasoline Licensed Brands and the TOP TIER Diesel Fuel Licensed Brands that are recommended for use in all GM vehicles and the TOP TIER FUELS website URL.
• 10163266Jun 25, 2019Equipment, Engine. This informational bulletin provides information on identifying Non-GM Engine Calibrations for Gasoline Engines using the Tech 2 or GDS 2.
• 10163260Jun 25, 2019Equipment. This informational bulletin advises about the possible issues that may occur when using a scotch brite pad or highly abrasive disk on gasket sealing surfaces or reused parts.
• 10163193Jun 25, 2019Equipment. This bulletin provides information on Engine Concerns that could result from lack of scheduled maintenance, improper service or aftermarket calibrations.
• 10162155Jun 25, 2019Wheels. This Preliminary Information communication provides information to the technician about removing the tinnerman push nuts when installing the accessory Accessory 22" Wheels Regular Production Option Code (SES, SEU, SEY, OR SEZ) or production 22" wheels Regular Production Option Code (RPT or SMI) also during any service requiring wheel removal.
• 10162150Jun 24, 2019Equipment. This Preliminary information communicates a customer concern of IPC gauges inoperative or fluctuate, No Start, No Crank, SIR Light / Service Airbag Message, Service Suspension Message, Radio display blank, Steering Wheel Controls (SWC) not illuminated, Turn Signal no audible feedback, HVAC controls inoperative.
• 10163255Jun 21, 2019Body and structure. This technical bulletin provides a procedure to pry the upper and lower quarter rear trim panel sheet metal apart to eliminate a creak noise heard from the quarter lower rear trim panel area.
• 10163253Jun 20, 2019Brakes. This technical bulletin provides a procedure to add PET tape to the brake cables if the cause of the customers concern.
• 10163252Jun 19, 2019Transmission and drivetrain, Equipment. This technical bulletin provides a procedure to change the diff fluid if found the cause of the customers concern.
• 10162143Jun 19, 2019Engine cooling. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on. Technician will find Diagnostic Trouble Codes P0340 and P0341 setting at times. Technician should use normal published Service Information diagnostics. If normal Service Information diagnostics does not isolate the concern, inspect for corrosion in connector…
• 10162136Jun 17, 2019Fuel system. This Preliminary Information communication provides information to the technician for a vehicle setting both a P2635 and P018B diagnostic trouble codes. The following steps may help to determine if this is caused by a fuel pressure sensor not reading the low end of the pressure range. Technician is to make sure the engine is cold and install the Multiple Diagnostic Interface along with Global Diagnostic System 2.
• 10162124Jun 13, 2019Electrical system. This Preliminary Information communication provides information to the technician about a no start or another concern after swapping an Engine Control Module or other modules from one vehicle to another. The Global Architecture electrical system associated with these vehicles does not allow controller swaps between vehicles.
• 10163263Jun 11, 2019Electrical system, Equipment. This bulletin explains the labor operation numbers used for submitting warranty claims for module reprogramming and not when replacing a module.
• 10163245Jun 10, 2019Equipment. This informational bulletin provides information for dealers/technicians and customers on possible carpet color mismatch.
• 10163237Jun 10, 2019Engine cooling. This informational bulletin provides information for dealers/technicians and customers on steam/vapor coming from the front grille or radiator area.
• 10163220Jun 6, 2019Equipment. This technical bulletin provides repair information to correct a customer concern of carpet damage, seat mounting stud wear through, hole in second row (Intermediate) carpet.
• 10163215Jun 6, 2019Transmission and drivetrain. This Bulletin provides guidelines for Dealers Not Required and for Dealers Required to Contact the PQC for engine or transmission assembly replacement and explains the PQC process, GWM Transaction submission, vehicle service record retention and proper handling of assembly returns.
• 10162108Jun 4, 2019Transmission and drivetrain. This Preliminary Information communication provides information to the technician about vehicles that are equipped with 6L80 Regular Production Option Code (MYC), 6L90 Regular Production Option Code (MYD) or 8L90 Regular Production Option Code (M5U) Automatic Transmission, now have Powertrain Grade Braking. Powertrain grade braking assists when driving on a downhill grade to help maintain desired vehicle speed by…
• 10162106Jun 3, 2019Electrical system. This Preliminary Information communication provides information to the technician about the use of J-35616-64B terminal test probe, replacement terminals, and terminated leads. The J-35616-64B is the latest test probe released for checking tension or probing the .64 series terminals. The test probe terminal has been released in the terminal repair kit (J-38125-620H) located in Lear Tray 7 part number 963716-2.
• 10161926May 30, 2019Brakes. This technical bulletin provides repair information to correct a customer concern of pulsing, grinding, scraping noise from brakes, uneven front brake pad wear.

← All problems reported for the 2017 Cadillac Escalade