2010 Can-AM Spyder RT Recalls
NHTSA lists 4 recall campaigns for the 2010 Can-AM Spyder RT. A recall applies only to vehicles built within the affected range, so check your own VIN at nhtsa.gov/recalls. Repairs for recalls are free at a franchised dealer.
- Fuel system, gasoline › Storage › Tank assembly › Filler pipe and capCovers: Can-AM Spyder RT 2010–2012, Spyder RS 2009–2012, Spyder GS 2008–2009
Reported issue: Bombardier Recreational Products Inc. (BRP) is recalling certain model year 2008-2012 Can-Am Spyder GS, RS, and RT series vehicles. The fuel cap may not fit onto the fuel tank filler neck, preventing it from sealing properly.
Possible consequence: If the fuel cap does not seal properly, it may leak fuel vapors. Fuel vapors in the presence of an ignition source could result in a fire and personal injury.
Remedy: BRP will notify owners and send them a replacement fuel cap, free of charge. The safety recall is expected to begin in mid-January 2013. Owners may contact BRP AT 1-888-638-5397.
- Service brakes, air › Controls › Foot control/valveCovers: Can-AM Spyder RT 2010
Reported issue: Bombardier recreational products inc. (brp) is recalling certain model year 2010 spyder rt roadsters. A pin securing the brake pedal connecting rod could disengage and fall off.
Possible consequence: If this occurs, a total loss of main brake function could result without prior warning. There is an increased risk of a crash possibly resulting in injury or death.
Remedy: Brp will notify owners, and dealers will replace the brake pedal connecting rod pins free of charge. The safety recall began on april 18, 2012. Owners may contact brp at 1-888-638-5397.
- Power train › Clutch assemblyCovers: Can-AM Spyder RT 2010, Spyder RS 2010
Reported issue: Brp is recalling certain model year 2010 spyder rs se5 2nd series and rt se5 roadsters. When bringing a vehicle equipped with the se5 semi-automatic transmission to a full stop, the clutch may remain engaged stalling the engine. Once the engine is stalled, it could be impossible to re-start and the rear wheel could be blocked.
Possible consequence: If this happens, the vehicle may not be able to be pushed off the roadway increasing the risk of a crash.
Remedy: Brp will notify owners and dealers will repair the vehicles free of charge. The safety recall began on june 7, 2010. Owners may contact brp at 1-888-638-5397.
- Engine and engine coolingCovers: Can-AM Spyder RT 2010
Reported issue: Bombardier recreational products, inc. (brp) is recalling model year 2010 roadster spyder rt sm5 and se5 motorcycles manufactured between october 13 and october 30, 2009. The connector on the key switch harness may not be locked and the ignition switch harness may be routed too tight. In some situations, the connector may unplug.
Possible consequence: If this occurs, the vehicle may stall without warning and could potentially cause a crash.
Remedy: Brp will notify owners and authorized dealers will inspect to ensure that the connector is locked and that the ignition switch harness is not routed too tight and correct the harness if needed free of charge. The safety recall began on december 18, 2009. Owners may contact brp at 1-888-638-5397 or 1-819-566-3366.
← All problems reported for the 2010 Can-AM Spyder RT
About this data. Data from NHTSA (ODI) complaints, recalls, TSBs and investigations, updated Oct 31, 2026. Complaints are unverified consumer reports and may be duplicated or inaccurate.