1994 Chevrolet Beretta Recalls

NHTSA lists 2 recall campaigns for the 1994 Chevrolet Beretta. A recall applies only to vehicles built within the affected range, so check your own VIN at nhtsa.gov/recalls. Repairs for recalls are free at a franchised dealer.

• 94V176000Sep 20, 19941,604 vehicles potentially affected
  Structure › Body › Door
  Covers: Chevrolet Beretta 1994–1995

  Reported issue: The reinforcement panel that serves as a liftpoint for the frame was omitted from the right side rocker assembly of the frame the vehicles do not conform to the requirements of fmvss no. 208, "occupant crash protection."

  Possible consequence: Consequence of non-compliance: the missing reinforcement panel reduces the protection of the vehicle occupants in the event of a side impact collision.

  Remedy: Dealers will inspect the vehicles for the presence of the right side rocker reinforcement panel. If the reinforcement panel is not present, dealers will contact chevrolet for further instructions.

  Full campaign details →

• 93V157000Sep 24, 199339 vehicles potentially affected
  Suspension › Front
  Covers: Chevrolet Beretta 1994, Corsica 1994

  Reported issue: The suspension support assemblies do not meet general motors corporation's specification for weld integrity and the affected weld can fail causing the front of the control arm to separate from the suspension support assembly.

  Possible consequence: If this occurs, the affected tire/wheel assembly can movesubstantially from its designed position and steering control can be severelyimpaired which may result in an accident.

  Remedy: Install revised suspension supports with adequate weld integrity.

  Full campaign details →

← All problems reported for the 1994 Chevrolet Beretta