2013 Chevrolet Camaro Technical Service Bulletins

2,041 technical service bulletins (TSBs) are on record for the 2013 Chevrolet Camaro. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10114263Nov 19, 2014Transmission and drivetrain. This preliminary bulletin provides a procedure to perform a transmission inspection and adjustment before having to replace the parking pawl actuator if the inspection found no problem.
• 10114262Nov 18, 2014Brakes. This informational bulletin explains a normal condition for what and how the drive line can clunk.
• 10114260Nov 18, 2014Forward collision avoidance. This information bulletin explains the use of drilling high strength steel in a collision repair and the GM recommended CryoCobalt Drill bit.
• 10114729Nov 13, 2014Electrical system, Equipment. This Preliminary Information communication provides information to the technician to diagnose a concern of the blower motor speed display frozen on the radio display. The actual blower speed will change with the blower speed knob however the number on the radio display will not change. The technician is to monitor the electronic Climate Control module data display using Global Diagnostic System 2 the requested fan…
• 10114725Nov 13, 2014Equipment, Engine. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp, rough running, and/or lack of power. Technician may find Diagnostic Trouble Codes P0101, P0171, P0172, P0174, and/or P0175 set. Technician will need to inspect the hydrocarbon absorber pad that is on the inside of the air cleaner lid to ensure that it is…
• 10114721Nov 12, 2014Equipment. This Preliminary Information communication provides information to the technician about customer?s questions regarding the hood graphic on the 1LE Camaro. Dealer should advise the customer to maintain the appearance of the graphic, hand washing or a touch-less car wash is recommended. Customer should not polish or wax the graphic.
• 10114254Nov 12, 2014Engine cooling. This technical bulletin provides a procedure to correct the customers concern to replace the left side valve cover and active fuel management oil deflector to reduce oil consumption.
• 10114245Nov 7, 2014Electrical system. This informational bulletin was created to help technician identify non GM calibrations for the gasoline engines and the damages that may be caused by aftermarket calibrations
• 10114241Nov 5, 2014Electrical system. This informational bulletin was created to help technician identify non GM calibrations for the gasoline engines and the damages that may be caused by aftermarket calibrations
• 10114705Nov 4, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicles that are travelling from Canada to the United States. While in the United States they are unable to receive Turn-by-Turn directions. Due to the existing cellular provider not having roaming agreements in areas outside of Canada to support transmitting of the packet data required for Turn-By-Turn feature to operate. The…
• 10114701Nov 3, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicles that may have an oil pressure gauge is indicating that the engine appears to be operating with very high oil pressure. Under various engine operating conditions up to 110 pressure per square inch of oil pressure may be displayed on the oil pressure gauge. This should be considered as normal operation during a cold…
• 10114240Nov 3, 2014Equipment. This informational bulletin helps the technician quick reference repairs to bulletins as opposed to replacing parts that may be un necessary.
• 10114239Nov 3, 2014Equipment. This warranty bulletin clarifies the use of dealer empowerment to satisfy the customer.
• 10254218Nov 1, 2014Wheels. Thin Finish in Lug Nut Recesses on Optional Gloss Black Wheels.
• 10253143Nov 1, 2014Engine cooling. SES Light Rough Running And/Or Lack Of Power.
• 10252163Nov 1, 2014Equipment. XM Audio Traffic And Travel Link Availability And Operation.
• 10250082Nov 1, 2014Transmission and drivetrain. Information on Driveline Clunk Noise
• 10247063Nov 1, 2014Visibility (wipers, defrost, mirrors). A/C Blows Warm Or Poor Performance.
• 10246569Nov 1, 2014Transmission and drivetrain. Information on Driveline Clunk Noise
• 10245951Nov 1, 2014Equipment. Canadian Customers Unable To Place Calls And Turn By Turn Inoperative In The United States.
• 10073363Nov 1, 2014Equipment. Summary to be provided on a future date.
• 10073361Nov 1, 2014Equipment. Summary to be provided on a future date.
• 10069955Nov 1, 2014Engine. Summary to be provided on a future date.
• 10069951Nov 1, 2014Engine. Summary to be provided on a future date.
• 10069284Nov 1, 2014Wheels. Summary to be provided on a future date.
• 10057595Nov 1, 2014Electrical system. General motors 2010-2013 chevrolet camaro ss corvette with a v8 engine: bulletin information regarding lack of power, ses light comes on, rough running and need to inspect hydrocarbon absorber.
• 10135356Oct 30, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicles that the Heater-Vent-Air Conditioning blows warm air. Before calling General Motors Technical Assistance Center technician will need to have high and low pressures, outside temperature, humidity, and vent temperature.
• 10114329Oct 30, 2014Wheels. This preliminary bulletin provides a procedure to paint the lug nut recess if the customer states that the paint looks thin.
• 10114328Oct 30, 2014Equipment. This information for Warranty administration - Changes the Service Policy and Procedures Section 1.6.2.11 and now is refered to Article 3.2.9 of the 1st addition manual for details of Technician Identification and Accounting of Labor Time
• 10114326Oct 29, 2014Electrical system. This preliminary bulletin provides a procedure to test for the customers concern of an exhaust rattle noise from the valve actuators on cold start up and update the either the chassis control or fuel pump module.
• 10114320Oct 28, 2014Electrical system. This preliminary bulletin provides a procedure to remove and inspect the clutch select solenoid valve for damage, located in the valve body to correct the customers concern of reduced acceleration at low speeds and trans slip at lauch.
• 10114318Oct 28, 2014Fuel system. This informational bulletin was provides information for the technician of cold start ticking noises in the engine compartment and may be caused by the fuel pump and/or the fuel injectors and no repairs are needed for a normal condition.
• 10114316Oct 27, 2014Equipment. This preliminary bulletin provides information to reset the phone and factory reset of the radio to correct the customers concern of the iphone connection concerns.
• 10114309Oct 23, 2014Visibility (wipers, defrost, mirrors). This informational bulletin explains how to care for wiper blades.
• 10135342Oct 20, 2014Engine cooling. This Preliminary Information communication provides information to the technician about gasoline powered cars, mid-size trucks, light duty trucks, and heavy duty trucks with premature catalytic converter failures. It is recommended to inspect for a poor crimp on the grounds ring terminal at the engine block for the bank with the concern and repair the wire.
• 10135337Oct 17, 2014Electrical system. This Preliminary Information communication provides information to the technician about vehicles that are travelling from Canada to the United States. While in the United States they are unable to receive Turn-by-Turn directions. Due to the existing cellular provider not having roaming agreements in areas outside of Canada to support transmitting of the packet data required for Turn-By-Turn feature to operate. The…
• 10114299Oct 17, 2014Equipment. This informational bulletin provides a quick guide to updating which model vehicle after replacing the IPC.
• 10114298Oct 17, 2014Transmission and drivetrain. This preliminary bulletin provides a procedure to replace the clutch pedal assembly due to thermal contraction of the clutch fluid and to correct the customers concern of the pedal feels low or doesn?t return.
• 10114296Oct 16, 2014Equipment. This warranty administration bulletin provide policy information of the JOB CARD, for a repair on vehicles and what is acceptable - customer authorization; Service manager approvals and transaction authorization; Details of concern, cause and correction; Labor Time; Technician ID and acoutablity of labor time; Proper documentation and retension of warranty parts; Accurate sublet charges and receipts; Add on…
• 10114292Oct 13, 2014Electrical system. This preliminary bulletin provides a procedure on how to cold crank test a battery in a vehicle.
• 10135322Oct 10, 2014Engine cooling. This Preliminary Information communication provides information to the technician about gasoline powered cars, mid-size trucks, light duty trucks, and heavy duty trucks with premature catalytic converter failures. It is recommended to inspect for a poor crimp on the grounds ring terminal at the engine block for the bank with the concern and repair the wire.
• 10135321Oct 10, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicles that show an error message when a media disc is installed. Technician will need to check the Regular Production Option Code list to verify if the disc is compatible.
• 10135315Oct 7, 2014Transmission and drivetrain, Back-over prevention (rear camera). This Preliminary Information communication provides information to the technician about the rear view camera options on the vehicles equipped with rear view camera. The rear view camera brightness can be adjusted on some models while the transmission is in reverse and using the Menu or Select button. To turn off or on the guidelines in the rear view camera, use the radio display Config icon then Display, then the…
• 10114281Oct 6, 2014Fuel system. This informational bulletin states that it no longer valid and refers to a new bulletin.
• 10114280Oct 6, 2014Equipment. This informational bulletin provides information on Inappropriate Warranty Claims Submitted for Damaged Radios and IPCs
• 10114278Oct 2, 2014Transmission and drivetrain. This preliminary bulletin provides a procedure to inspect and repair the parking pawl spring in the transmission if the customer states that theres a grind or rattle noise during a left turn or bump.
• 10056993Oct 1, 2014Transmission and drivetrain. Chevrolet: see document search button for owner letter. Due to rebuilt transmission 2-6 clutch pack, on some vehicles, a rattling noise and/or reduced transmission torque capacity may occur. Model 2013 camaro.
• 10112251Sep 24, 2014Engine cooling. This Preliminary Information communication provides information to the technician about finding needle bearings during an oil change. Technician will gain access to the roller rockers to inspect them. Only replace the roller rocker that is missing needle bearings. Be sure to clean the oil drains to retrieve the needle bearings. Each roller rocker has 66 bearings.
• 10150637Sep 23, 2014Equipment. This informational bulletin provides information on how to use floor mats.
• 10142226Sep 23, 2014Equipment. This informational bulletin provides information on how to use floor mats.

← All problems reported for the 2013 Chevrolet Camaro