2016 Chevrolet Camaro Technical Service Bulletins

1,711 technical service bulletins (TSBs) are on record for the 2016 Chevrolet Camaro. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10130675Oct 21, 2016Fuel system. 16029 - Service Update. The high pressure fuel pump or fuel rail fastener(s) may have been improperly tightened during manufacturing. Fuel could leak from the fuel pump or fuel rail causing the vehicle to go into reduced power mode. If this occurs DTC P228C, P228D or P00C6 will set, causing the Check Engine Light to be illuminated.
• 10119050Oct 19, 2016Electrical system. This Preliminary Information communication provides information to the technician about vehicles voice recognition inoperative for calling Bluetooth phone contacts. Technician will need to Clear All Private Data and repair any phones that were deleted.
• 10135284Oct 18, 2016Body and structure. This technical bulletin provides a procedure to apply BRS tape to the door trim panel that is causing a comment of a rattle or buzz noise due to the speaker vibration from high bass.
• 10135267Oct 15, 2016Equipment. This informational bulletin provides information on the proper ways to remove or replace the key cylinder covers due to somevehicleshavingthe key cylinders hidden during the time of delivery.
• 10135248Oct 13, 2016Back-over prevention (rear camera), Engine cooling. This technical bulletin provides a procedure to repair the valve lifter oil manifold and/or lifters to correct the customers concern of engine misfire, ticking noise and/or MIL on.
• 10135239Oct 13, 2016Equipment. This warranty administration bulletin provide policy information on required operating procedures.
• 10135237Oct 13, 2016Equipment. Battery Testing and Warranty Replacement Requirements (North America ONLY)
• 10135236Oct 13, 2016Electrical system. This warranty administration bulletin provides policy information on the requirements for battery testing and warranty replacements.
• 10119034Oct 13, 2016Equipment. This Preliminary Information communication provides information to the technician about vehicles that have a noise coming from the front end of the vehicle while hitting bumps in the road. If diagnostics determine the front struts should be replaced, record the bottom line of numbers on the part number tag. Also write this information on the Repair Order and attach a copy to the warranty claim.
• 10135262Oct 12, 2016Exterior lighting. This technical bulletin provides a procedure to update the ECM to the latest software and calibration available to correct a customer concern that the Malfunction Indicator Lamp is illuminated and/or the remote start will not start the vehicle due to a voltage spike in the ECM, above the threshold value which will set the code P0132 or P223E.
• 10135242Oct 12, 2016Electronic stability control. This informational bulletin provides information on Some vehicles may rock or move slightly forward or rearward while in Park at start up after cold soak. This condition may be accompanied by a clunk noise. This is a slight movement that is more often seen visually, rather than felt, when viewed from the outside and using the auto-start feature, if equipped.
• 10135276Oct 10, 2016Electrical system. This technical bulletin provides multiple fixes for a condition of a waiting for update screen appearing on the display, due to either a reprogramming of the hmi module or due to a fuse that needs to be pulled and restarting of the module.
• 10130606Oct 10, 2016Equipment. 33110 - Service Update - 8-Speed Transmission Turbine Shaft Failure. Reinstate programming. When a commanded shift occurs outside of the expected transmission turbine speed window limits, the commanded shift monitor requests a driver defaulted 8th gear state. The torque associated with the default action results in a broken turbine shaft.
• 10135241Oct 9, 2016Fuel system. This informational bulletin provides information on the top tier fuels that are recommended in GM vehicles.
• 10135274Oct 7, 2016Transmission and drivetrain. This Bulletin provides guidelines for Dealers to determine whether or not they need to contact the PQC for an engine, transmission or transfer case assembly replacement and information explaining the PQC process, Global Warranty Management Transaction submission, vehicle repair record retention and proper handling of assembly returns.
• 10135243Oct 7, 2016Equipment. This informational bulletin advises the dealers to maintain the vehicle stock on hand by doing a full inspection on the vehicles before sold (prepping) to the customer.
• 10135244Oct 5, 2016Equipment. This Informational Bulletin provides information for customers to report Missing or Inaccurate navigation Radio Map Disc information.
• 10119015Oct 4, 2016Equipment. This Preliminary Information communication provides information to the technician about vehicles that the radio will turn on unwanted after a key cycle when the radio was shut off before the key was turned off. Dealer should communicate to the customer that we apologize for this inconvenience and that General Motors is working on a solution for this concern.
• 10135270Oct 3, 2016Visibility (wipers, defrost, mirrors). This technical bulletin provides a procedure to reposition a front corner of the folding top front weatherstrip to correct a condition of a water leak at the windshield header/A-pillar area.
• 10135261Oct 3, 2016Latches, locks and linkages. This technical bulletin provides a procedure to balance the folding top front latching mechanism and actuator motor to correct a condition of a "Top Not Secure" message being displayed on the DIC.
• 10118917Sep 30, 2016Equipment. This Warranty Admin bulletin provides retail and wholesale service personnel with the policies/procedures and the warranty transaction submission procedures that support the Personal Property Damage process.
• 10118916Sep 30, 2016Equipment. This warranty administration bulletin provide policy information on warranty and policy exchange program for electronic products for U.S. and Canada dealers only.
• 10118913Sep 30, 2016Equipment. This warranty administration bulletin provide policy information for courtesy transportation and roadside assistance programs.
• 10118912Sep 30, 2016Equipment. This informational bulletin provides information on return or reimbursement of customer owned CDs, DVDs or Navigation Discs .
• 10118907Sep 30, 2016Tires. This warranty administration bulletin provides information on The tires supplied with a new vehicle are covered by General Motors against defects in material or workmanship under the Bumper-to-Bumper New Vehicle Limited Warranty.
• 10099878Sep 30, 2016Engine. This preliminary information communication provides information to the technician about vehicles that may have a service engine soon malfunction indicator lamp on. Technician may find diagnostic trouble codes p0106 and p0506. Technician will inspect for a broken valve spring and replace as needed.
• 10099532Sep 30, 2016Engine. This preliminary information communication advises the technician about the calculation and operation of the engine oil life monitor. The monitor calculates the percent of oil life remaining, based on 3 pathways. The first pathway for oil life calculation is engine revolutions. The second pathway for oil life calculation is the mileage form the last rest for all general motors powertrains except the volt. The third…
• 10099236Sep 30, 2016Equipment. This preliminary information communication provides information to the technician about vehicle that will have no xm audio or no signal. Dealer should communicate to the customer that we apologize for this inconvenience and that general motors is working on a solution for this concern.
• 10092367Sep 30, 2016Equipment. This warranty administration bulletin provides information on the tires supplied with a new vehicle are covered by general motors against defects in material or workmanship under the bumper-to-bumper new vehicle limited warranty.
• 10099148Sep 28, 2016Equipment. This preliminary information communication provides information to the technician about vehicles that may have a blank radio display. Dealer should advise the customer general motors is working on a solution to the concern.
• 10118919Sep 27, 2016Equipment. This warranty administration bulletin provides information on Goodwill Tools, Customer Enthusiasm, and Policy Guidelines.
• 10118918Sep 27, 2016Equipment. This warranty nonadministrative bulletin provides information on the proper use of the labor op 0600014.
• 10099150Sep 27, 2016Back-over prevention (rear camera). This preliminary information communication provides information to the technician about vehicles with an intermittent loss of gridlines in the rear camera display screen and a "service rear vision system" message that both happen at the same time. Technician should check for diagnostic trouble codes and follow published service information diagnostics for the diagnostic trouble codes.
• 10118972Sep 26, 2016Electrical system. This technical bulletin provides a procedure to reprogram the radio controls and pull a fuse for the display module to correct a condition of the display not responding to touch screen actions or that no user input will work, due to a internal software concern.
• 10097102Sep 26, 2016Equipment. This preliminary information communication provides information to the technician that general motors and general motors of canada company do not support cross border sales. The general motors of canada customer care centre is the sole authorized provider of a certification confirmation letter which helps our customers identify if their vehicles meets the required usa regulatory standards necessary for importation…
• 10118936Sep 23, 2016Seats. This technical bulletin provides a procedure for securing the seat back material around the front seat easy entry handle to correct a customer concern of the material pulling loose and exposing edges/holes.
• 10099466Sep 23, 2016Engine. This preliminary information communication provides information to the technician about vehicles that may have a service engine soon malfunction indicator lamp on and diagnostic trouble code p0300 - p0308 may set. Technician will inspect for lose sparkplug wire. If a spark plug wire is found lose check for a missing “c” clip on the wire end for the ignition coil. If the clip is missing replace the wire.
• 10118985Sep 22, 2016Equipment. This engineering informational bulletin is requesting information from the field of vehicles with the condition of a SES light on with one or more DTC's set.
• 10118963Sep 22, 2016Brakes. This informational bulletin provides information on the proper ways to remove or replace the key cylinder covers due to some vehicles having the key cylinders hidden during the time of delivery.
• 10118915Sep 22, 2016Equipment. This informational bulletin provides information on Inappropriate Warranty Claims Submitted for Damaged Radios and IPCs
• 10118910Sep 22, 2016Equipment. This informational bulletin provides information on new tools used for the Hem Flanges and how to repair and seal the flanges when the repairs are done.
• 10119006Sep 20, 2016Equipment. 33110 - Service Update. Message to Suspend - Message only, to temporarially suspend program events. When a commanded shift occurs outside of the expected transmission turbine speed window limits, the commanded shift monitor requests a driver defaulted 8th gear state. The torque associated with the default action results in broken turbine shaft.
• 10118956Sep 19, 2016Equipment. This technical bulletin provides repair information to correct a customer concern for a rattle noise at the radio control/display/ICS (Integrated Center Stack), or coming from the center dash area.
• 10118908Sep 19, 2016Equipment. This informational bulletin provides information on comebacks prevention information and using customer concern verification sheets (CCVS).
• 10119005Sep 16, 2016Transmission and drivetrain. 33110 - Service Update. When a commanded shift occurs outside of the expected transmission turbine speed window limits, the commanded shift monitor requests a driver defaulted 8th gear state. The torque associated with the default action results in broken turbine shaft. The calibration window (based on output speed) for the safety monitor (P16F3) is smaller than the calibration window for the driver initiated TAP…
• 10118914Sep 16, 2016Electrical system. This informational bulletin explains the programming method quick reference guide for the IPC Odometer.
• 10098467Sep 16, 2016Equipment. This preliminary information communication provides information to the technician about vehicles that the radio will not save xm favorites. Technician will need to replace the radio to address the concern.
• 10098466Sep 16, 2016Equipment. This preliminary information communication provides the technician with information on vehicles with navigation radio regular production option code io6 or uy4 that defaults to west virginia instead of virginia on a manual entry. General motors engineering is currently working on a solution for this concern.
• 10118950Sep 15, 2016Equipment. This technical bulletin provides a procedure to pull on the metal infront of the HVAC recirc door to correcct a condition of a thump noise when switching the HVAC modes due to the recirc door coming into contact with the metal infront of it.
• 10118983Sep 14, 2016Suspension. This preliminary informational bulletin provides a procedure to replace both the front suspension mounts and cups to correct a condition of a popping noise from the fron of the vehicle when traveling over bumps due to the front strut mount being torn due to high underbody/underhood temps in addition to traveling over speed bumps.

← All problems reported for the 2016 Chevrolet Camaro