2012 Chevrolet Captiva Technical Service Bulletins

1,025 technical service bulletins (TSBs) are on record for the 2012 Chevrolet Captiva. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10147348Oct 3, 2018Fuel system. This Preliminary information communicates that when removing the fuel line jumper hose care should be taken to be sure the line is reinstalled correctly to avoid a no/low fuel pressure situation.
• 10144476Aug 28, 2018Equipment. This Preliminary Information communication provides information to the technician that General Motors Technical Assistance Center may ask for Global Diagnostic System 2 Session Log. Technician will need use Global Diagnostic System 2 to send the session logs to General Motors Technical Assistance Center for further assistance on the vehicle in question.
• 10144451Aug 8, 2018Engine. This Preliminary Information communication provides information to the technician about engine block of possible cylinder bore damage, scoring or out of round as the possible cause of engine oil consumption, misfire, cylinder leakage or blow by. Technician will need to inspect the engine for Cylinder damage or scoring, An out of round cylinder bore, Dirt intrusion, and Catalytic Converter failure.
• 10143752Jul 3, 2018Visibility (wipers, defrost, mirrors). This Preliminary Information communication advises the technician the steps on diagnosing the concern. Customer's sunroof operation intermittent, bind, noise, auto-reverse, and/or water leaks.
• 10143449Jun 20, 2018Equipment. This Preliminary Information communication provides information to the technician about vehicles that the Heater-Vent-Air Conditioning blows warm air. Before calling General Motors Technical Assistance Center technician will need to have high and low pressures, outside temperature, humidity, and vent temperature.
• 10143445Jun 15, 2018Equipment, Engine, Engine cooling. This Preliminary Information communication provides information to the technician about vehicles that have a loud tick or rattle noise under the hood at all operating conditions. Technician will need to check the lower and oil pressure to the upper end oil pressure. Technician will need to inspect the oil feed orifice in the cylinder head. Technician will clean out and debris found in the orifice.
• 10143443Jun 14, 2018Equipment. This Preliminary Information communication provides information to the technician about vehicles that may have an issue when using Bluetooth voice recognition with an iPhone. Technician should work with the customer to insure the phone contacts to not have any Emojis loaded to any contact.
• 10141371May 23, 2018Equipment, Electrical system. This Preliminary Information communication provides information to the technician about connectivity concerns when connecting an Apple device via USB cord. Technician should insure the customer is using an original equipment manufacturer Apple USB cable.
• 10137562Apr 13, 2018Visibility (wipers, defrost, mirrors). This PI bulletin provides information on Rear and Side Tempered Glass Spots (Quench Marks) and they are normal characteristic.
• 10137551Apr 13, 2018Engine cooling. This Bulletin provides inspection/diagnosis/correction information on a cold start misfire and/or rough idle and DTC P0300 that may also be set.
• 10137383Mar 28, 2018Transmission and drivetrain, Engine. This informational bulletin provides information on OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification.
• 10137375Feb 28, 2018Electrical system. This technical bulletin provides a procedure to properly reprogram an onstar module to correct a condition of Red LED, No WiFi Operation, and/or Limited OnStar® Module Functionality After OnStar Module Replacement for Another Condition.
• 10139282Jan 29, 2018Electrical system. This informational bulletin provides information to diagnose batteries that have set for a long period of time and/or cold weather climates and testing those batteries.
• 10129097Jan 25, 2018Engine. This Preliminary Information communication provides information to the technician about finding needle bearings during an oil change. Technician will gain access to the roller rockers to inspect them. Only replace the roller rocker that is missing needle bearings. Be sure to clean the oil drains to retrieve the needle bearings. Each roller rocker has 66 bearings.
• 10129089Jan 23, 2018Wheels. This Preliminary Information communication provides information to the technician about changing the tire and wheel size on vehicles. General Motors will only support a tire calibration for tires that have been sized, tested and designed for the vehicle in question and its applications. Technician should not use the information that is provided by the antilock braking system tire size selection.
• 10129073Jan 18, 2018Engine. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components. That any of the listed DTC's may set with or without poor engine performance.
• 10139284Jan 12, 2018Engine cooling. This preliminary informational bulletin provides information on Damaged, Disassembled or Improperly Packaged Turbochargers Returned to Warranty Part Center.
• 10139277Jan 12, 2018Equipment. This information bulletin provides a procedure on how to remove the paint stain that may present itself under the shipping film.
• 10129051Jan 4, 2018Equipment. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components.
• 10126983Dec 19, 2017Engine cooling. This Preliminary Information communication informs dealer technicians of a potential whining noise that can occur after servicing the water pump, water pump chain or cylinder head without use of the water pump sprocket holding tool. Dealers are advised this condition is the result of a water pump chain tensioner ratcheting out. The dealer is directed to follow service information to reset the water pump chain…
• 10126972Dec 18, 2017Electrical system. This Preliminary Information communication provides information to the technician about vehicles that have an OnStar system that will not power up. Technician should turn off the ignition and cancel retained accessory power. After the vehicle has powered down remove power to the OnStar module for five minutes. After the power has been removed for five minutes, if the OnStar system is working release the vehicle.
• 10139185Dec 7, 2017Electrical system. This informational bulletin provides information to diagnose batteries that have set for a long period of time and/or cold weather climates and testing those batteries.
• 10139118Nov 17, 2017Equipment. This informational bulletin provides a listing of the parts availability for coax repair procedures and what is needed to complete some repairs.
• 10125106Nov 7, 2017Electrical system. This Preliminary Information communication provides information to the technician about vehicle's odometer appears to be inaccurate relative to a known distance traveled. Technician should obtain a hand-held GPS unit to test the odometer. If a hand held GPS unit is not available, the only other option is to verify the miles traveled using a surveyor's wheel or a dynamometer.
• 10134569Oct 9, 2017Engine. Low Audible Whine Noise has been found to be transmitting from the balance shaft drive chain.
• 10123227Oct 5, 2017Electrical system. This Preliminary Information communication provides information to the technician about vehicles that have a Diagnostic Trouble Code B101D-37 history in the Vehicle Communication Interface Module or telematics communication interface control module. Engineering has determined that this code will only display in history on the scan tool and will not cause issues with OnStar system operation.
• 10123222Oct 3, 2017Equipment, Electrical system. This Preliminary Information communication provides information to the technician about what XM offerings are available for vehicles. A dealer or customer can access the website listed below for vehicle specific XM offerings and availability.
• 10123211Oct 2, 2017Body and structure. This Preliminary Information communication provides information to the technician about vehicles that have a loud tick or rattle noise under the hood at all operating conditions. Technician will need to check the lower and oil pressure to the upper end oil pressure. Technician will need to inspect the oil feed orifice in the cylinder head. Technician will clean out and debris found in the orifice.
• 10190338Oct 1, 2017Equipment. Essential Tools that Include Consumable Parts (U.S. Only)
• 10190337Oct 1, 2017Suspension. Information Regarding the Differences Between Fluid Leakage and Seepage This bulletin is intended to help identify the differences between what is considered a fluid leak and what is considered seepage. Improper diagnosis may lead to unnecessary component replacement. Use the following information to determine if the condition is normal acceptable seepage or a defective component
• 10190320Oct 1, 2017Electrical system, Equipment. IPC Odometer Programming Method Quick Reference Guide
• 10190230Oct 1, 2017Engine, Equipment. Low audible whine noise from engine
• 10157041Sep 28, 2017Electrical system. This Preliminary Information communication provides information to the technician about vehicles that have a Diagnostic Trouble Code B101D stored in Telematics Communication Interface Control Module. Technician will use Global Diagnostic System 2 to review the Firmware Over-the-Air version. If the Firmware Over-the-Air version on the scan tool equals 6708 the technician will need to contact General Motors Technical…
• 10157020Sep 20, 2017Equipment, Electrical system. This Preliminary Information communication provides information to the technician about the use of J-35616-64B terminal test probe, replacement terminals, and terminated leads. The J-35616-64B is the latest test probe released for checking tension or probing the .64 series terminals. The test probe terminal has been released in the terminal repair kit (J-38125-620H) located in Lear Tray 7 part number 963716-2.
• 10157018Sep 20, 2017Fuel system, Tires, Equipment, Electrical system. This Preliminary Information communicates to the dealer the process for downloading or updating operating software for the Tire Pressure Monitor, Active Fuel Injector tester, multi media tester, PICO Scope, GR8 starting/charging tester and Vehicle Data Recorder tools, giving website address and step by step instructions to complete the update.
• 10157015Sep 19, 2017Equipment. This Preliminary Information communication informs dealer technicians of a potential whining noise that can occur after servicing the water pump, water pump chain or cylinder head without use of the water pump sprocket holding tool. Dealers are advised this condition is the result of a water pump chain tensioner ratcheting out. The dealer is directed to follow service information to reset the water pump chain…
• 10156999Sep 11, 2017Equipment. This Preliminary Information communication provides information to the technician about vehicle that may have an OnStar system that has progression tones when pressing the blue or red button. Technician will need to call General Motors Technical Assistance Center with the scan tool data from the OnStar system.
• 10156990Sep 6, 2017Equipment. This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts/kits. Technicians should refer to Service Information for information regarding most accessories. Technicians may also contact Partech and/or the Techline Customer Support Center for additional support.
• 10159574Sep 5, 2017Engine. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement.
• 10140293Aug 31, 2017Engine cooling. This informational bulletin provides information on Intake Manifold Inspection/Replacement After Severe Internal Engine Damage.
• 10140406Aug 23, 2017Body and structure, Equipment. Thins informational bulletin provides information on Paint-less Dent Repair Process.
• 10137727Aug 21, 2017Engine. This Preliminary Information communication provides information to the technician about engine block of possible cylinder bore damage, scoring or out of round as the possible cause of engine oil consumption, misfire, cylinder leakage or blow by. Technician will need to inspect the engine for Cylinder damage or scoring, An out of round cylinder bore, Dirt intrusion, and Catalytic Converter failure.
• 10137705Aug 9, 2017Equipment. This Preliminary Information communication provides information to the technician about customers that may complain of various concerns when using Bluetooth components. Technician should use the Preliminary Information to gather information from the customer on their Bluetooth device and the concern they are having before calling General Motors Technical Assistance Center.
• 10126081Jul 31, 2017Equipment. This informational bulletin explains the Road Force balancers and what they can do for customer concerns.
• 10126113Jul 25, 2017Electrical system. This informational bulletin provides information on Information on How to Prevent Inadvertent Vehicle Starting from Key Fob or OnStar Mobile Application and where to locate the information for future use.
• 10108645Jul 19, 2017Tires. This informational bulletin provides information on the temporary tire flat spotting condition.
• 10108627Jul 18, 2017Engine, Equipment. This informational bulletin provides warranty policy information on revised wiring repair labor operations and required additional information.
• 10108626Jul 18, 2017Electrical system. This informational bulletin provides warranty policy information on revised wiring repair labor operations and required additional information.
• 10108625Jul 18, 2017Engine, Equipment. This informational bulletin provides warranty policy information on revised wiring repair labor operations and required additional information.
• 10114072Jul 13, 2017Back-over prevention (rear camera), Equipment. This Preliminary Information communication provides information to the technician about the rear view camera options on the vehicles equipped with rear view camera. The rear view camera brightness can be adjusted on some models while the transmission is in reverse and using the Menu or Select button. To turn off or on the guidelines in the rear view camera, use the radio display Config icon then Display, then the…

← All problems reported for the 2012 Chevrolet Captiva