2019 Chevrolet Corvette Technical Service Bulletins

790 technical service bulletins (TSBs) are on record for the 2019 Chevrolet Corvette. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10165902Sep 24, 2019Engine cooling. This Preliminary information communicates A vehicle may have a tick noise from the engine cold, initial start in the morning. A lifter may not have sufficient amount of oil during cold start operation (not pumped up). As information comes in the Pi will be updated and when the final repair is out this this PI will be changed to a Bulletin
• 10166638Sep 18, 2019Equipment. This warranty administration bulletin provides information regarding the field action courtesy transportation policy.
• 10165120Aug 30, 2019Equipment. This technical bulletin provides repair information to correct a customer concern of Phone Charging Cycles On and Off When Connected to the Single Port USB Hub.
• 10164789Aug 29, 2019Engine cooling. This Preliminary Information communication provides information to the technician on how to diagnose and repair vehicles that may have Diagnostic Trouble Code P06DD or no or low oil pressure. Technician will replace timing chain tensioner guide. If oil pump face is damaged and or worn thru replace oil pump. Inspect bearings for damage wear due to debris from oil pump.
• 10165127Aug 23, 2019Electrical system. This preliminary information bulletin provides information om Service Programming System (SPS) Error Codes E4398, E4399, E4403, M4404, M4413, E4414, E4423, E4491 or E6961).
• 10165087Aug 23, 2019Equipment. This warranty administration bulletin provides policy information, proper labor operation selection and causal part identification for warranty transactions (U.S. Only).
• 10165083Aug 23, 2019Wheels. This bulletin provides a procedure to clean the back side of the rims and rotors and to correct the customers concern of wheel clicking.
• 10165124Aug 21, 2019Engine cooling. This bulletin provides information on identifying Non-GM Engine Calibrations for Gasoline Engines using the Tech 2 or GDS 2.
• 10165126Aug 19, 2019Equipment. This bulleting provides Wiring, Terminal and Connector Repair Information including how to determine the Service Part Number in eSI and how to locate the part(s) in the EPC.
• 10165121Aug 15, 2019Engine cooling. This informational bulletin provides information on replacing the intake manifold when the engine is replaced after severe internal engine damage.
• 10165441Aug 13, 2019Electrical system, Equipment. N192218430 - Customer Satisfaction Program. During service, certain vehicles equipped with OnStar (RPO UE1), may have received an incorrect and partially programmed/configured replacement OnStar module. This condition will disable certain OnStar features, including Remote Access (remote start, door lock/unlock, etc.), Connected Access (vehicle diagnostics, dealer maintenance notification, etc.), and Unlimited…
• 10165122Aug 13, 2019Engine cooling. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement.
• 10165123Aug 12, 2019Transmission and drivetrain. This informational bulletin provides information on Some vehicles may rock or move slightly forward or rearward while in Park at start up after cold soak. This condition may be accompanied by a clunk noise. This is a slight movement that is more often seen visually, rather than felt, when viewed from the outside and using the auto-start feature, if equipped.
• 10165135Aug 6, 2019Transmission and drivetrain. This engineering information bulletin is requesting information from the field to validate a field fix. Before contacting engineers, remove the transmission oil pan and inspect for nickel to quarter size pieces of aluminum debris in the oil pan. The 2-3-4-6-8 and 4-5-6-7-8 reverse clutch assembly and the 1-3-5-6-7 clutch assembly may be broken in several pieces.
• 10165079Aug 5, 2019Steering. This technical bulletin provides a procedure inspecting for excess grease or Sealant on the Exterior of the steering gear due to seeing grease or sealant on certain locations on the gear.
• 10163690Jul 31, 2019Equipment. This Preliminary information communicates AFM / DFM usage Information. providing additional information on the AFM and DFM systems
• 10164113Jul 30, 2019Electrical system, Equipment. This informational bulletin provides information for dealers/technicians on Information on Head-Up Display (HUD) on Vehicles Model Year 2017 and Newer Has Rotational Feature that Allows for Adjusting of the Angle of the HUD Image.
• 10163890Jul 29, 2019Transmission and drivetrain. This technical bulletin provides information for new transmission oil to use and a procedure for exchanging the old fluid and adding the new fluid to correct a shake/shudder during light throttle acceleration condition.
• 10163900Jul 26, 2019Equipment. This informational bulletin provides process information for the (GWM) and (WPC) parts return program.
• 10164120Jul 25, 2019Equipment, Transmission and drivetrain. This technical bulletin provides information for new transmission oil to use, a procedure for exchanging the old fluid and adding the new fluid to a service transmission.
• 10163674Jul 23, 2019Engine cooling. This Preliminary information communicates A vehicle may have a tick noise from the engine cold, initial start in the morning. A lifter may not have sufficient amount of oil during cold start operation (not pumped up). As information comes in the Pi will be updated and when the final repair is out this this PI will be changed to a Bulletin
• 10162172Jun 28, 2019Equipment. This Preliminary Information communication provides information to the technician about vehicles that do not recognize the SD card when it is used in the Performance Data Recorder (PDR) system. The SD card needs to be formatted to FAT32 and also have a class 10 designation in order to be compatible with the system.
• 10163272Jun 26, 2019Equipment. The intent of this technical bulletin is to identify aftermarket ALDL or DLC interface devices as potential sources for causing multiple customer concerns that do not have other diagnostic methods to identify them.
• 10163268Jun 26, 2019Equipment, Electrical system. This bulletin provides information for electrical ground repairs using new General Motors replacement fasteners with conductive finish.
• 10163261Jun 26, 2019Fuel system. This bulletin provides information on the TOP TIER Detergent Gasoline Licensed Brands and the TOP TIER Diesel Fuel Licensed Brands that are recommended for use in all GM vehicles and the TOP TIER FUELS website URL.
• 10163266Jun 25, 2019Equipment, Engine. This informational bulletin provides information on identifying Non-GM Engine Calibrations for Gasoline Engines using the Tech 2 or GDS 2.
• 10163260Jun 25, 2019Equipment. This informational bulletin advises about the possible issues that may occur when using a scotch brite pad or highly abrasive disk on gasket sealing surfaces or reused parts.
• 10163221Jun 25, 2019Body and structure. This technical bulletin provides repair information to correct a customer concern of the paint peeling on a front and/or rear fascia.
• 10163193Jun 25, 2019Equipment. This bulletin provides information on Engine Concerns that could result from lack of scheduled maintenance, improper service or aftermarket calibrations.
• 10163229Jun 19, 2019Transmission and drivetrain. This technical bulletin provides a procedure to correct a condition of a rattle noise heard from the front of the vehicle when the engine is running at slower speeds.
• 10163256Jun 18, 2019Engine, Equipment. This informational bulletin provides information to the tech to replace only the prop shaft and not the complete driveline support assembly (DSA) if a rattle noise is confirmed to be coming from the prop shaft.
• 10162124Jun 13, 2019Electrical system. This Preliminary Information communication provides information to the technician about a no start or another concern after swapping an Engine Control Module or other modules from one vehicle to another. The Global Architecture electrical system associated with these vehicles does not allow controller swaps between vehicles.
• 10163263Jun 11, 2019Electrical system, Equipment. This bulletin explains the labor operation numbers used for submitting warranty claims for module reprogramming and not when replacing a module.
• 10163237Jun 10, 2019Engine cooling. This informational bulletin provides information for dealers/technicians and customers on steam/vapor coming from the front grille or radiator area.
• 10163215Jun 6, 2019Transmission and drivetrain. This Bulletin provides guidelines for Dealers Not Required and for Dealers Required to Contact the PQC for engine or transmission assembly replacement and explains the PQC process, GWM Transaction submission, vehicle service record retention and proper handling of assembly returns.
• 10161932May 21, 2019Engine cooling. This informational bulletin advises of a new fuel injection kit used for decarbonizing the intake valves, and explains how toptier fuels should be used to reduce carbon build up.
• 10161881May 21, 2019Transmission and drivetrain. This technical bulletin provides information for new transmission oil to use and a procedure for exchanging the old fluid and adding the new fluid to correct a shake/shudder during light throttle acceleration condition.
• 10161968May 20, 2019Transmission and drivetrain. This bulletin provides information on the harmful effects of water or ethylene glycol in transmission fluid.
• 10161937May 16, 2019Engine cooling. This technical bulletin provides a procedure to modify the right rear exhaust control valve actuator to correct a rattle noise heard from the rear of the vehicle.
• 10161906May 9, 2019Tires. This informational bulletin provides information for dealers/technicians on Tire Radial Force Variation (RFV).
• 10161929May 8, 2019Equipment. This warranty administration bulletin provide policy information to cover GM's policy on performing GM covered vehicle services and maintenance on vehicles originating/sold in Canada.
• 10160989May 7, 2019Engine cooling. This Preliminary information communicates A vehicle may have a concern of DTC P050D setting along with a P0300 after a cold start up. White smoke and/or coolant odor may come from exhaust for an extended period of time at cold start as well. Cause Coolant getting into the cylinders, and provides direction for the repair.
• 10161879May 6, 2019Engine, Transmission and drivetrain. This technical bulletin provides a procedure to correct a condition of a rattle noise heard from the front of the vehicle when the engine is running at slower speeds.
• 10160985May 6, 2019Equipment, Body and structure. This Preliminary Information communicates information on installing the rear spoiler on a ZR1 during PDI.
• 10160979May 3, 2019Body and structure, Equipment. This Preliminary Information communicates information to dealership technicians on how to adjust a rear spoiler so that it is level.
• 10161971May 2, 2019Equipment, Electrical system. This engineering information PI ends the need for information from the field if a customer has received error message 220_7 when trying to remote start their vehicle with mobile app.
• 10161907May 2, 2019Equipment. This informational bulletin provides information for dealers/technicians on Use of Dealer Case Management (DCM) and Being Prepared for Contacting U.S. Technical Assistance (TAC).
• 10160134Apr 30, 2019Engine. This informational bulletin explains the normal noises an engine may make when the ambient temperature outside is cold or the vehicle has sat for a few hours.
• 10160690Apr 24, 2019Fuel system, Engine. This Preliminary information communicates to the dealer an issue where the vehicle's engine may crank over unprompted and not start afterward. This is the result of hooking up the Active Fuel Injector Tool incorrectly on vehicles equipped with a direct fuel injection system. This Preliminary information instructs the dealer of a repair kit they received that will prevent this issue when installed correctly.
• 10160427Apr 24, 2019Equipment, Engine cooling, Body and structure. This technical bulletin provides a procedure to reposition the coolant surge hose clamp away from the hood blanket to avoid hood closing interference.

← All problems reported for the 2019 Chevrolet Corvette