1995 Ford F700 Recalls

NHTSA lists 4 recall campaigns for the 1995 Ford F700. A recall applies only to vehicles built within the affected range, so check your own VIN at nhtsa.gov/recalls. Repairs for recalls are free at a franchised dealer.

• 97V111000Jul 14, 19973,300 vehicles potentially affected
  Electrical system › Wiring › Front underhood
  Covers: Ford F700 1994–1997

  Reported issue: Vehicle description: medium duty trucks equipped with 7.0l liquefied petroleum gas (lpg) engine or 7.0l efi (gasoline) engine with the optional cab floor pan reinforcement. The engine wiring harness or battery cable can be pinched between the optional cab reinforcement and the frame causing an abrasion which could result in an electrical short circuit.

  Possible consequence: A short circuit can cause overheating and arcing.

  Remedy: Dealers will modify the reinforcement(s) and, if necessary, reposition the engine wiring harness (including installation of the revised engine wire harness retention bracket) and battery cable.

  Full campaign details →

• 95V143000Aug 2, 199529,000 vehicles potentially affected
  Vehicle speed control
  Covers: Ford F700 1993–1995, LN8000 1993–1995, F800 1993–1995 +3 more

  Reported issue: The hand throttle cable can wear the brass swivel block on the governor lever through which it passes.

  Possible consequence: This wear can result in the governor jamming in thedamaged swivel and could prevent the governor lever from returning to the idle position.

  Remedy: Dealers will install a revised governor lever with a stainless steel swivel. Also letters will be sent to vehicle owners that have the same vehicles but do not have a ford installed hand throttle advising them that they may require service if they have had an after market hand throttle installed.

  Full campaign details →

• 95V092000May 9, 199513,000 vehicles potentially affected
  Electrical system › Wiring
  Covers: Ford F700 1994–1995, F800 1994–1995, F600 1994–1995 +3 more

  Reported issue: A connector in the wiring where the tilt hood mounted lamps attach to the vehicle wiring harness was built without sealing plugs. Moisture, road salt or other contaminants can enter the connection resulting in crossed circuits, shorts or corrosion of the wiring of the connector.

  Possible consequence: The headlamps or other front-end lighting systems can malfunction as a result of this condition increasing the potential for a vehicle accident.

  Remedy: Dealers will inspect the connector and install sealing plugs in the open cavities. If the inspection reveals corrosion, a new connector will be installed.

  Full campaign details →

• 94V244000Dec 12, 1994560 vehicles potentially affected
  Steering › Linkages › Drag › Link › Connection
  Covers: Ford F700 1995, F800 1995

  Reported issue: The drag link installed can contact the front axle I-beam under certain extreme conditions. This drag link was not intended to be installed on "low profile" vehicles.

  Possible consequence: This can result in loss of steering control.

  Remedy: Dealers will install the correct drag link on the vehicles.

  Full campaign details →

← All problems reported for the 1995 Ford F700