2007 GMC Yukon Denali Technical Service Bulletins

1,035 technical service bulletins (TSBs) are on record for the 2007 GMC Yukon Denali. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10133152Jan 28, 2013Equipment. This informational bulletin provides information on the replacement process for the product quality center.
• 10133151Jan 28, 2013Transmission and drivetrain. This informational bulletin provides information for service agents not required to contact product quality center for CNG, LPG or gasoline engine, transmission and/or transfer case.
• 10133149Jan 28, 2013Electrical system. This technical bulletin provides a procedure on suspected tampering due to aftermarket ALDL or DLC interface devices causing multiple issues.
• 10133148Jan 28, 2013Engine. This technical bulletin provides a procedure to install AFM oil deflector, rocker arm cover-left bank and clean carbon from cylinder due to engine oil consumption on aluminum block/iron block engines.
• 10133147Jan 28, 2013Tires. This informational bulletin provides information on tire radial force variation.
• 10133146Jan 28, 2013Visibility (wipers, defrost, mirrors). This technical bulletin provides a procedure for adding double sided tape on the right and left windshield side reveal moldings to remove tapping, clicking or ticking type noise.
• 10133143Jan 25, 2013Electrical system. This informational bulletin provides information on suspected tampering on vehicles modifications for identifying non GM ECM calibrations.
• 10112740Jan 25, 2013Transmission and drivetrain. This Preliminary Information communication provides information to the technician about vehicles that may have a service 4WD message displayed in the Driver Information Center. Technician may find Diagnostic Trouble Code C0379. Technician will need to inspect the front axle actuator connector for signs of moisture intrusion. If there is corrosion on the terminals at either location replace the actuator and harness.
• 10112737Jan 23, 2013Electrical system. This Preliminary Information communication provides information to the technician about vehicles that the speedometer needle appears to be inaccurate. Dealer should advise the customer the specification for speedometer needle accuracy is +/- 2 miles per hour at any given speed when looking straight at the needle.
• 10133130Jan 16, 2013Body and structure. This informational bulletin provides information pre-painting/cleaning process for TPO plastic fascias.
• 10112725Jan 16, 2013Engine. This Preliminary Information communication provides information to the technician about vehicles that have misfires on cylinders 1, 4, 6 and 7. Technician should inspect the camshaft part numbers. Technician should ensure to use part number for the application by using the numbers stamped on the cam.
• 10133125Jan 14, 2013Equipment. This informational bulletin provides information on a update for the Electronic Component Exchange Program (U.S. and Canada Only)
• 10112702Jan 8, 2013Engine. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on, engine misfire, and/or engine noise. Technician may find Diagnostic Trouble Codes P0300-P0308.
• 10133117Jan 3, 2013Engine. This technical bulletin provides a procedure to install the updated valve cover for models built with the prior date listed to correct oil consumption of vehicles with higher mileage.
• 10247747Jan 1, 2013Electrical system. Speedometer Needle Accuracy Information
• 10247092Jan 1, 2013Electrical system. Speedometer Needle Accuracy Information
• 10112697Dec 27, 2012Equipment, Transmission and drivetrain. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on, engine misfire, and/or engine noise. Technician may find Diagnostic Trouble Codes P0300-P0308.
• 10138538Dec 20, 2012Engine cooling. This informational bulletin provides information on the proper oils to use on GM vehicles including information regarding the differences of the Dexos oils.
• 10113849Dec 20, 2012Engine cooling. This informational bulletin provides information on the proper oils to use on GM vehicles including information regarding the differences of the Dexos oils.
• 10138554Dec 19, 2012Equipment. This preliminary informational bulletins provides information regarding the release of a new designed HVAC blower motor assembley. The bulletin provides information on how to correctly install the parts to function as intended.
• 10113847Dec 19, 2012Equipment. This preliminary informational bulletins provides information regarding the release of a new designed HVAC blower motor assembley. The bulletin provides information on how to correctly install the parts to function as intended.
• 10113843Dec 17, 2012Equipment. This warranty administration bulletin provides information on the Clarification of Use for Dealer Empowerment Labor Operations and Customer Enthusiasm
• 10112681Dec 17, 2012Transmission and drivetrain. This Preliminary Information communication provides information to the technician about vehicles that may have a planetary gear whine noise in first and second gear. Technician should compare the noise to a like vehicle. Technician will need to check the build date of the transmission, if it was built after 09/01/2003 and it is determined that a vehicle has an abnormal amount of noise, perform the rear unit end…
• 10138565Dec 13, 2012Transmission and drivetrain. This preliminary informational bulletin provides information on replacing the transmission fluid level indicator if a customers comments regarding one being broken.
• 10113842Dec 13, 2012Transmission and drivetrain. This preliminary informational bulletin provides information on replacing the transmission fluid level indicator if a customers comments regarding one being broken.
• 10112668Dec 13, 2012Exterior lighting. This Preliminary Information communication provides information to the technician about the puddle light operation. Technician should be advised that the puddle lamps to operate, "Approach Lighting" must be turned on using the Drivers Information Center buttons.
• 10112655Dec 12, 2012Wheels, Tires. This Preliminary Information communication provides information to the technician about changing the tire and wheel size on vehicles. General Motors will only support a tire calibration for tires that have been sized, tested and designed for the vehicle in question and its applications. Technician should not use the information that is provided by the antilock braking system tire size selection.
• 10112641Dec 12, 2012Engine cooling. This Preliminary Information communication provides information to the technician that fluid contamination may be directed to one of the following testing centers according to the type of fluid needing testing. Dealer should send the correct fluid to the proper testing center.
• 10138544Dec 7, 2012Tires. This informational bulletin provides the proper information used to determine the road force variences within new tires being installed and the proper forms used to send the tires back if the road force is not within spec.
• 10113838Dec 7, 2012Tires. This informational bulletin provides the proper information used to determine the road force variences within new tires being installed and the proper forms used to send the tires back if the road force is not within spec.
• 10113837Dec 7, 2012Equipment. This informational bulletin provides a list off all the issues revolving around new vehicles for a one stop place to find growing concerns around them.
• 10253585Dec 1, 2012Body and structure, Equipment. Liftgate Paint Damage Evident at Lower Outer Edge of Applique.
• 10245772Dec 1, 2012Wheels, Tires, Suspension, Other or unknown. Diagnostic Tips for Difficult to Resolve Tire/Wheel Vibration Concerns
• 10245770Dec 1, 2012Tires, Wheels, Other or unknown. Proper Wheel Installation and Wheel Torque Techniques
• 10062548Dec 1, 2012Body and structure. Summary to be provided on a future date.
• 10043510Dec 1, 2012Equipment. Cadillac/chevrolet/gmc: original style blower motor assembly is no longer available. A revised hvac blower motor assembly for full size trucks is required, with modifications, to function properly. *pe updated 2/25/13.
• 10138220Nov 30, 2012Electrical system, Equipment. This informational bulletin provides information regarding the aftermarket device interference with onstar diagnostic service.
• 10137478Nov 30, 2012Equipment. This informational bulletin provides information regarding the aftermarket device interference with onstar diagnostic service.
• 10126163Nov 30, 2012Electrical system. This informational bulletin provides information regarding the aftermarket device interference with onstar diagnostic service.
• 10138218Nov 29, 2012Equipment, Electrical system. This informational bulletin provides information regarding the inappropriate warranty claims submitted for damaged radios and instrument panel clusters, provides exampls on whats an acceptable for warranty and whats not
• 10137476Nov 29, 2012Equipment, Electrical system. This informational bulletin provides information regarding the inappropriate warranty claims submitted for damaged radios and instrument panel clusters, provides exampls on whats an acceptable for warranty and whats not
• 10112614Nov 29, 2012Equipment. This Preliminary Information communication provides information to the technician about customers may inquire about the availability of the passenger compartment air filter. Dealer should advise the customer starting in 2003 the passenger compartment air filter is no longer available as a factory option.
• 10112613Nov 29, 2012Tires. This Preliminary Information communication provides information to the technician about vehicles with tire sidewall irregularities. This is a visual condition that will not affect durability, reliability or performance of the tires. Dealer should communicate to the customer that slight sidewall indentations are a common characteristic of radial tire construction.
• 10126171Nov 28, 2012Equipment. This informational bulletin provides a step by step procedure on how to properly use the GM chemicals to eliminate unwanted odors in vehicles and which products to use for each application.
• 10112608Nov 28, 2012Equipment. This Preliminary Information communication provides information to the technician on how to diagnose and repair vehicles that may have an OnStar Turn-By-Turn Navigation the system that is inoperative. Technician verifies there are no Diagnostic Trouble Codes are present in the Antilock Braking System and Vehicle Communication Interface Module of the vehicle. If no Diagnostic Trouble Codes found call OnStar using…
• 10112607Nov 28, 2012Equipment. This Preliminary Information communication provides information to the technician about vehicle that may have an OnStar system that has progression tones when pressing the blue or red button. Technician will need to call General Motors Technical Assistance Center with the scan tool data from the OnStar system.
• 10112603Nov 27, 2012Transmission and drivetrain. This Preliminary Information communication provides information to the technician about vehicles that have a rattle, buzz, tick, or vibration type noise that appears to be coming from the center of the dash. Technician will adjust the transmission dipstick tube away from the front of cowl to provide additional clearance.
• 10126191Nov 26, 2012Transmission and drivetrain. This informational bulletin provides a description of the proper wheel installation and proper wheel torque techniques used to install wheels onto vehicles
• 10126164Nov 26, 2012Body and structure. This preliminary information bulletin provides a procedure for replacement of the liftgate applique for concerns regarding the applique being deformed or dimpled or paint damage at the lower edge of the applique
• 10112600Nov 26, 2012Transmission and drivetrain. This Preliminary Information communication provides information to the technician with the axel setup information from American Axle Manufacturing. Technician should be advised that the maximum pinion shim to be used or stacked behind the pinion is 0.050?, and the minimum pinion shim is 0.020? for an 8.6 axle. The range for available pinion depth shims for the 10.5? axle is 0.006? to 0.024?. When setting the…

← All problems reported for the 2007 GMC Yukon Denali