2010 GMC Yukon Denali Technical Service Bulletins

1,374 technical service bulletins (TSBs) are on record for the 2010 GMC Yukon Denali. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10138637Feb 21, 2014Wheels, Equipment, Tires. This informational bulletin provides technicians with ways to decrease the tire slipping on the rim and reduce to possible chances of the customers concerns over tire vibration are repair.
• 10138631Feb 18, 2014Tires, Wheels. This technical bulletin provides a procedure on cleaning a leaking rim, to correct a customers concern of having a slow tire leak and low tire psi message on.
• 10138630Feb 18, 2014Equipment, Tires. This informational bulletin explains the use of Nitrogen in GM tires.
• 10138629Feb 18, 2014Tires. This bulletin provides information regarding the normal tire wear condition of slight or mild tire feathering and recommended practices.
• 10138621Feb 17, 2014Equipment. This informational bulletin helps the technician quick reference repairs to bulletins as opposed to replacing parts that may be un necessary.
• 10111934Feb 17, 2014Equipment, Engine cooling. This Preliminary Information communication advises the technician that the Drive Motor Generator Control Module, also known as PIM) for the 2-Mode Hybrid Utilities and Trucks are being placed on restriction through the General Motors Technical Assistance Center. Dealer will need to contact General Motors Technical Assistance Center for further assistance.
• 10111927Feb 12, 2014Brakes, Fuel system, Equipment. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp. Technician may find Diagnostic Trouble Code P0442. Technician will need to review Techlink article from May 2013 titled "Using the Evaporative Emissions System Tester" Technician will need to follow these steps to help diagnose the issue. First after the P0442…
• 10138609Feb 10, 2014Equipment. The informational bulletin provides a procedure to remove and repair rust from a Hem Flange.
• 10138606Feb 10, 2014Visibility (wipers, defrost, mirrors), Equipment. This warranty administration bulletion provides the dealer technician information and guidelines for claiming a windshield.
• 10138605Feb 10, 2014Equipment. This technical bulletin provides a procedure to correct the customers concern of odor coming from the Air conditioning.
• 10111911Feb 7, 2014Equipment. This Preliminary Information communication provides information to the technician that First Responder Guides for General Motors vehicles can be accessed via the web at http://www.gmstc.com.
• 10111894Feb 4, 2014Equipment. This Preliminary Information communication provides information to the technician that General Motors and General Motors of Canada Company do not support cross border sales. The General Motors of Canada Customer Care Centre is the sole authorized provider of a certification confirmation letter which helps our customers identify if their vehicles meets the required USA regulatory standards necessary for importation…
• 10245771Feb 1, 2014Wheels, Other or unknown, Tires. Proper Wheel Installation and Wheel Torque Techniques
• 10245768Feb 1, 2014Wheels, Suspension, Tires. Vibration Shortly After Tires are Mounted/Preventing Vibration from Wheel Slip
• 10190932Feb 1, 2014Equipment, Wheels. Refinishing Aluminum Wheels This bulletin updates General Motor's position on refinishing aluminum wheels. GM does not endorse any repairs that involve welding, bending, straightening o re-machining. Only cosmetic refinishing of the wheel's coatings, using recommended procedures, is allowed. Evaluating Damage In evaluating damage, it is the GM Dealer's responsibility to inspect the wheel for corrosion, scrapes…
• 10190931Feb 1, 2014Equipment, Wheels. Refinishing Aluminum Wheels This bulletin updates General Motor's position on refinishing aluminum wheels. GM does not endorse any repairs that involve welding, bending, straightening o re-machining. Only cosmetic refinishing of the wheel's coatings, using recommended procedures, is allowed. Evaluating Damage In evaluating damage, it is the GM Dealer's responsibility to inspect the wheel for corrosion, scrapes…
• 10137784Jan 31, 2014Equipment. This informational bulletin provides information for the dealer technician to gather as much information to help aid Engineers by completely filling out requested reports.
• 10112045Jan 31, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicles that has no XM audio on certain channels but XM channel info is displayed. Technician will need to contact XM and deactivate and activate the module.
• 10112043Jan 30, 2014Engine cooling, Fuel system. This Preliminary Information communication provides information to the technician about vehicles that have a an extended crank on cold start, brief rough running on cold start, black exhaust color, and/or Service Engine Soon Malfunction Indicator Lamp on. Technician may find a Diagnostic Trouble Code P0172 and or P0175.
• 10112033Jan 28, 2014Electrical system, Equipment. This Preliminary Information communication provides information to the technician about vehicles that have navigation or radio screen is blank or flashes on and off, no sound from speakers, and rear DVD screen inoperative. Technician will find Diagnostic Trouble Codes B1265, B1288, or B1289. Technician will need to repair circuit 7066.
• 10112032Jan 28, 2014Electrical system, Back-over prevention (rear camera). This Preliminary Information communication provides information to the technician about vehicles that have a rear camera display being inoperative when shifting into reverse. Technician should check for a loose or disconnected X421/X322 connector behind the right side "C" pillar trim. Technician should also check for pinched, Open or shorted wires on camera circuits 7641, 7642, and 6799.
• 10112024Jan 24, 2014Body and structure, Interior lighting. This Preliminary Information communication provides information to the technician about vehicles that have Diagnostic Trouble Code B2555 may be found in a Driver and/or Passenger Door Module. Technician should ignore the Diagnostic Trouble Code if set in a DDM and/or PDM on a vehicles not equipped with front door panel courtesy lights.
• 10137781Jan 23, 2014Equipment. This informational bulletin was created to inform that any accessories that are install from the GM factory will be covered under the standard vehicle warranty and dealer installed accessories will be cover for a full year (12months).
• 10112023Jan 23, 2014Fuel system. This Preliminary Information communication provides information to the technician about vehicles that after refueling the fuel gauge will show empty. Technician may find Diagnostic Trouble Code P2636 has set. Technician should be advised that the vehicle is being refueled with the engine running or ignition on.
• 10112018Jan 22, 2014Engine cooling. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have a no crank concern. Technician will need to check the valve train for movement when the engine is cranked. If the valve train is not moving while the crankshaft is moving the front cover will need to be removed to inspect for a sheared cam sprocket locator pin. If the cam…
• 10112013Jan 22, 2014Equipment. This Preliminary Information communication provides information to the technician about vehicles that may have an issue when using Bluetooth voice recognition with an iPhone. Technician should work with the customer to insure the phone contacts to not have any Emojis loaded to any contact.
• 10112010Jan 21, 2014Seats. This Preliminary Information communication provides information to the technician about vehicles that after installing the GM Accessory Heated Seat Kit, one or more of the following issues may be present the heated seat back and/or bottom turns off after approximately 30 seconds and after turning on the heated seat switch, the indicators remain on, but the seat is not heating. Technician may find Diagnostic Trouble…
• 10112009Jan 21, 2014Electrical system. This Preliminary Information communication provides information to the technician about vehicles that the speedometer needle appears to be inaccurate. Dealer should advise the customer the specification for speedometer needle accuracy is +/- 2 MPH at any given speed when looking straight at the needle.
• 10112006Jan 21, 2014Brakes. This Preliminary Information communication provides information to the technician about vehicles that a driveline noise or vibration at various speeds and operating conditions. Technician should be advised that the vehicle should always be restored to a factory configuration when diagnosing noise and vibration concerns.
• 10112005Jan 21, 2014Electrical system, Engine cooling. This Preliminary Information communication provides information to the technician about vehicles that have a Diagnostic Trouble Code C0569 that will not clear. Technician should be advised if there are any issues with the rotational position sensor, incremental position sensor, encoder motor, motor A or B circuits, rotational position sensor or incremental position sensor circuits when the transfer case control…
• 10112001Jan 17, 2014Brakes, Suspension. This Preliminary Information communication provides information to the technician about vehicles that have a Service Suspension System message on the Driver Information Center and the rear suspension ride height is incorrect. Technician will find Diagnostic Trouble Code C0696 or C0711 set in Electronic Suspension Control. Technician will need to inspect air compressor assembly for wire damage and repair any damage…
• 10112000Jan 17, 2014Transmission and drivetrain. This Preliminary Information communication provides information to the technician of a complaint of a sag or hesitation when accelerating. The concern is present when coasting at low speeds of less than 15 miles per hour and then aggressively applying the throttle, or after making a hard stop followed by an aggressive throttle.
• 10111997Jan 16, 2014Equipment. This Preliminary Information communication advises the technician that a noise or a vibration in the vehicle that seems to be abnormal may not have been there when the vehicle was purchased. Technician should look for Non - General Motors aftermarket accessories installed on the vehicle that can cause these issues.
• 10137777Jan 14, 2014Equipment, Electrical system. This Informational bulletin explains the warranty and policy exchange program for electronic devices and products, what can be approved by TAC and where the electronic parts can be returned to.
• 10137776Jan 14, 2014Transmission and drivetrain. This information was created to inform the technician that the 2-3 upshift and the 3-2 downshift clunk is caused by the releasing of the 2-4 band and application of the 3-4 clutch assembly during an upshift. Also during a 3-2 downshift, the releasing of the 3-4 clutch during the application of the 2-4 band, can cause torque reversal down the output shaft creating a clunk. This is a normal condition.
• 10111986Jan 14, 2014Engine cooling. This Preliminary Information communication provides information to the technician that some vehicles may have a Service Engine Soon lamp, engine misfire on cylinder 1, 4, 6, or 7 and/or tick noise. Technician will follow service information diagnosis first. If service information diagnosis does not isolate the cause of this concern perform a cylinder deactivation active fuel management system compression test in…
• 10137775Jan 8, 2014Equipment. This warranty administration bulletin provide policy information of the JOB CARD, for a repair on vehicles and what is acceptable - customer authorization; Service manager approvals and transaction authorization; Details of concern, cause and correction; Labor Time; Technician ID and acoutablity of labor time; Proper documentation and retension of warranty parts; Accurate sublet charges and receipts; Add on…
• 10111978Jan 7, 2014Electrical system. This Preliminary Information communication provides information to the technician about vehicles that have an aftermarket, add-on back up alarm will sound when unlocking the doors with the Remote Keyless Entry remote. Technician can correct this concern by turning off the perimeter lighting feature on vehicles with Driver Information Center controls or install an isolation relay in-line to the backup alarm.
• 10111977Jan 7, 2014Engine. This Preliminary Information communication provides information to the technician about vehicles that are setting Diagnostic Trouble Code P0300 after engine repairs. Technician will need to ensure that injector connectors for cylinder 5-7 and 6-8 are not crossed.
• 10111976Jan 6, 2014Engine. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have a no crank concern. Technician will need to check the valve train for movement when the engine is cranked. If the valve train is not moving while the crankshaft is moving the front cover will need to be removed to inspect for a sheared cam sprocket locator pin. If the cam…
• 10137773Jan 2, 2014Equipment. This warranty administration bulletin provides information on GM?s policy for comprehensive courtesy transportation to its customers.
• 10137772Jan 2, 2014Equipment. This warranty administration bulletin provide policy information of the JOB CARD, for a repair on vehicles and what is acceptable - customer authorization; Service manager approvals and transaction authorization; Details of concern, cause and correction; Labor Time; Technician ID and acoutablity of labor time; Proper documentation and retension of warranty parts; Accurate sublet charges and receipts; Add on…
• 10190934Jan 1, 2014Equipment, Body and structure. Underbody Component Corrosion The following information may be helpful when addressing underbody component corrosion with customers. Some customers may comment that one or more of their vehicle's underbody components are showing some form of corrosion. This corrosion may be red in appearance (rust) if the component is steel, forged iron or cast iron. This corrosion may also be grey or white in color if the…
• 10190933Jan 1, 2014Body and structure, Equipment. Underbody Component Corrosion The following information may be helpful when addressing underbody component corrosion with customers. Some customers may comment that one or more of their vehicle's underbody components are showing some form of corrosion. This corrosion may be red in appearance (rust) if the component is steel, forged iron or cast iron. This corrosion may also be grey or white in color if the…
• 10133103Dec 16, 2013Back-over prevention (rear camera). This informational bulletin provides directions on submitting different PIRs
• 10133098Dec 13, 2013Equipment. This preliminary information bulletin provides a revision of 13-00-89-004D to include updated information.
• 10133097Dec 13, 2013Equipment. This preliminary bulletin explains physical damage to radios and IPCs must be reviewed and validated if covered under GM warranty or not.
• 10133096Dec 13, 2013Equipment. This informational bulletin is a revision of 10-06-01-008I to add the 2010-2012 Chevrolet Colorado and GMC Canyon, RPO LH9 and update the Labor Operation to the Global Labor Code (GLC).
• 10133087Dec 5, 2013Visibility (wipers, defrost, mirrors). This preliminary bulletin explains the marks in the glass are normal when wearing polarized sunglasses and do not replace any glass for this reason.
• 10133086Dec 4, 2013Fuel system, Other or unknown. This informational bulletin provides information on how to save fuel and proper maintenance without using fuel or oil additives.

← All problems reported for the 2010 GMC Yukon Denali