2019 Hyundai Veloster Technical Service Bulletins

140 technical service bulletins (TSBs) are on record for the 2019 Hyundai Veloster. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10211669Apr 15, 2022Engine cooling. Applicable vehicles with 2.0L T-GDI and 2.4L GDI engines may experience the Check Engine warning lamp illuminated with DTC P1326 and/or engine may exhibit Abnormal Noise or No Crank/No Start condition. Follow the procedure to inspect the vehicle and replace the engine or update the engine ECU software based on the inspection results.
• 10211665Apr 15, 2022Engine cooling. Certain vehicles with 2.0L T-GDI and 2.4L GDI engines may experience the Check Engine warning lamp illuminated with DTC P1326 and/or engine may exhibit abnormal noise or no crank/no start condition related to connecting rod bearing wear or damage. This Dealer Best Practice outlines the service procedure to inspect the vehicle and replace the engine or update the engine ECU software based on the inspection results…
• 10207813Jan 31, 2022Engine cooling, Equipment. This bulletin provides additional service diagnostic information and repair procedures related to Electric Waste Gate Actuator (EWGA) equipped vehicles listed below. Refer to the applicable Engine Control / Fuel System sections in the Shop Manual, and then follow the procedures outlined in this bulletin whenever a vehicle with the following symptom(s) are being diagnosed: ➢ Check Engine Light illumination with…
• 10207812Jan 19, 2022Engine cooling, Equipment. The warranty coverage for engine long block repair or replacement regarding engine damage or malfunction from connecting rod bearing wear has been extended to 10 years or 120,000 miles from the date of original retail delivery or date of first use, whichever occurs first. Warranty coverage is valid for original and subsequent owners
• 10207800Jan 19, 2022Equipment, Engine cooling. The warranty coverage for certain Theta II engine long block repair or replacement regarding engine damage or malfunction from connecting rod bearing wear has been extended to 10 years or 120,000 miles from the date of original retail delivery or date of first use, whichever occurs first. Warranty coverage is valid for original and subsequent owners.
• 10204252Nov 3, 2021Engine cooling. Hyundai has launched a Service Campaign for applicable vehicles with 2.0L Turbo and 2.4L GDI engines that may experience the Check Engine warning lamp illuminated with DTC P1326.
• 10204248Nov 3, 2021Engine cooling. Applicable vehicles with 2.0L T-GDI and 2.4L GDI engines may experience the Check Engine warning lamp illuminated with DTC P1326 and/or engine may exhibit Abnormal Noise or No Crank/No Start condition. Follow the procedure to inspect the vehicle and replace the engine or update the engine ECU software based on the inspection results.
• 10200077Jul 26, 2021Engine cooling. This bulletin provides additional service diagnostic information and repair procedures related to Electric Waste Gate Actuator (EWGA) equipped vehicles listed below. Refer to the applicable Engine Control / Fuel System sections in the Shop Manual, and then follow the procedures outlined in this bulletin whenever a vehicle with the following symptom(s) are being diagnosed: ➢ Check Engine Light illumination with…
• 10199107Jun 8, 2021Engine cooling. This bulletin provides additional service diagnostic information and repair procedures related to Variable Charge Motion Controllers (VCM) equipped in the applicable vehicles listed below. This bulletin also provides information on the use of the Service Kit for 2.4L equipped engines, which enables replacing the VCM Lever Arm without replacing the complete Intake Manifold Assembly.
• 10190044Mar 30, 2021Equipment, Engine cooling. This bulletin provides the service procedure for engine connecting rod bearing clearance testing. Perform the procedure outlined in this bulletin to fulfill the Bearing Clearance Test inspection requirements to determine next required steps.
• 10190038Mar 23, 2021Brakes, Equipment. This bulletin provides best practice recommendations when performing brake service procedures.
• 10189989Mar 10, 2021Equipment, Engine cooling. This bulletin provides the inspection procedure and repair guidelines for certain vehicles listed below.
• 10186825Jan 28, 2021Steering. The rack-mounted dual pinion Motor Driven Power Steering (MDPS) system components can be replaced separately from the complete assembly. This bulletin provides information on the separate components and the replacement procedure of these components.
• 10186818Jan 12, 2021Engine cooling. The warranty coverage for the engine long block for engine repairs or replacement related to connecting rod bearing damage as described in Campaign T3G (Seized and/or BCT No Pass Result Only) has been extended to 10 years or 120,000 miles from the date of original retail delivery or date of first use, whichever occurs first, and is valid for original and subsequent owners. Please refer to TSB # 20-01-024H-2 (or…
• 10185445Dec 21, 2020Electrical system, Equipment, Engine cooling. Applicable vehicles with 2.0L Turbo and 2.4L GDI engines may experience the Check Engine warning lamp illuminated with DTC P1326. Follow the procedure to inspect the vehicle and replace the engine or update the engine ECU software based on the inspection results. Consult the Hyundai Warranty Policy & Procedures and the below chart to determine New or Reman engine usage.
• 10185438Dec 21, 2020Engine cooling. Applicable vehicles with 2.0L Turbo and 2.4L GDI engines may experience the Check Engine warning lamp illuminated with DTC P1326. Follow the procedure to inspect the vehicle and replace the engine or update the engine ECU software based on the inspection results.
• 10183963Nov 30, 2020Brakes. This bulletin describes the procedure to inspect and identify fluid which may appear around the brake caliper area.
• 10183960Nov 19, 2020Tires, Wheels. This bulletin provides tire vibration service procedures, including how to optimize vehicle vibration performance. For all wheel/tire balance claims, the “Tire Balance Data Sheet” must be fully completed including imbalance and Road Force Variation (RFV) data. The Data Sheet can be found at the end of this bulletin.
• 10183958Nov 12, 2020Engine cooling. Applicable vehicles with 2.0L Turbo and 2.4L GDI engines may experience the Check Engine warning lamp illuminated with DTC P1326. Follow the procedure to inspect the vehicle and replace the engine or update the engine ECU software based on the inspection results. Consult the Hyundai Warranty Policy & Procedures and the below chart to determine New or Reman engine usage.
• 10183957Nov 12, 2020Equipment, Electrical system, Engine cooling. Applicable vehicles with 2.0L Turbo and 2.4L GDI engines may experience the Check Engine warning lamp illuminated with DTC P1326. Follow the procedure to inspect the vehicle and replace the engine or update the engine ECU software based on the inspection results.
• 10182304Oct 9, 2020Equipment, Electrical system. This bulletin provides information and procedures for collecting OBD “In Use Monitor Performance Ratio” (IUMPR) data on certain 2019-2021MY vehicles at California dealers. This reporting is mandated by CARB (California Air Resources Board).
• 10181009Sep 17, 2020Engine cooling. The warranty coverage for the engine long block has been extended to 10 years or 120,000 miles from the date of original retail delivery or date of first use, whichever occurs first, and is valid for original and subsequent owners.
• 10180981Sep 9, 2020Equipment, Steering. This bulletin provides information regarding replacement of the column-mounted Motor Driven Power Steering (MDPS) system as separate components.
• 10181000Sep 2, 2020Engine cooling. This bulletin provides information related to an ECM (Engine Control Module) software update for DTC P0128: Coolant Thermostat (Coolant Temp below Thermostat Regulating Temperature) logic revision. There are no drivability symptoms associated with DTC P0128.
• 10179244Aug 10, 2020Steering, Electrical system. This bulletin provides information regarding replacement of the column-mounted Motor Driven Power Steering (MDPS) system as separate components.
• 10178183Jul 31, 2020Body and structure, Latches, locks and linkages. This bulletin describes the procedure to replace the latch and channel of a driver side door that has difficulty opening.
• 10178182Jul 23, 2020Electrical system, Engine cooling. This bulletin provides information related to the Engine Control Module (ECM) software logic update for DTC P0300-P0304 Misfire. This update addresses the intermittent misfire that may only occur at cold engine warmup.
• 10178175Jul 14, 2020Exterior lighting, Equipment. This bulletin provides information regarding condensation related to moisture accumulation in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. The TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes, or…
• 10177129Jun 9, 2020Electrical system, Engine cooling. This bulletin provides information related to the Engine Control Module (ECM) software logic update for DTC P0300-P0304 Misfire. This update addresses an incident of intermittent misfire that may only occur at cold engine warmup.
• 10177127Jun 3, 2020Engine, Equipment. Applicable vehicles with 2.0L Turbo and 2.4L GDI engines may experience the Check Engine warning lamp illuminated with DTC P1326. Follow the procedures on TSB #20-01-004H-1 (supersedes TSB #20-01-004H) to inspect the vehicle and replace the engine or update the engine ECU software based on the inspection results.
• 10177126Jun 3, 2020Engine, Electrical system. Applicable vehicles with 2.0L Turbo and 2.4L GDI engines may experience the Check Engine warning lamp illuminated with DTC P1326. Follow the procedure to inspect the vehicle and replace the engine or update the engine ECU software based on the inspection results.
• 10177125Jun 3, 2020Electrical system, Engine. Applicable vehicles with 2.0L Turbo and 2.4L GDI engines may experience the Check Engine warning lamp illuminated with DTC P1326. Follow the procedure to inspect the vehicle and replace the engine or update the engine ECU software based on the inspection results. Consult the Hyundai Warranty Policy & Procedures and the below chart to determine New or Reman engine usage.
• 10176195May 21, 2020Transmission and drivetrain. If you are servicing an applicable vehicle with the following symptoms and DTC, follow the Service Procedure on Page 3.  Check Engine light on  DTC P0880/P088000 - TCM Power signal error open/short  Transmission stuck in 4th gear fail-safe  Harsh shift into Drive and Reverse
• 10176182May 6, 2020Tires, Wheels. This bulletin provides information on tire maintenance best practices and procedures for dealers and customers to maximize tire life and performance.
• 10176178May 1, 2020Equipment. This bulletin describes the general guidelines to help disinfect and protect vehicle exterior/interior surfaces using recommended safe chemical products.
• 10174808Apr 23, 2020Electrical system, Equipment. This bulletin provides information on identifying dealer stock vehicles with either: • A Battery SOC alert - low Battery State of Charge (SOC) at or below 50%. • A 30 Day alert - vehicle has not started and reported an SOC in 30 days.
• 10174807Apr 17, 2020Equipment, Transmission and drivetrain. The automatic transmission warranty repair policy authorizes in-dealership repairs of the following components for both OEM (new) and remanufactured automatic transmissions:
• 10174800Apr 9, 2020Equipment, Transmission and drivetrain. If you are servicing an applicable vehicle with a “Check Engine” light on and one or more of the DTC listed below, follow the repair procedure and replace the oil pressure harness.
• 10173549Mar 25, 2020Brakes. If you are servicing an applicable vehicle with a (Check Engine Light on) and one or more of the DTC listed below, follow the repair procedure and replace the input/output speed sensor and oil pressure harness.
• 10173546Mar 23, 2020Equipment. This bulletin describes the general guidelines to disinfect and protect vehicle interior surfaces using certain safe chemical products.
• 10173545Mar 18, 2020Electrical system. This bulletin describes the mandatory procedure to submit battery test data electronically for battery warranty claims by running the GDS Battery Claim App. The App must be run right after an incident battery is removed from the vehicle or after a battery charge is completed which qualifies for a warranty. It must be run at any time between RO open and close dates.
• 10173543Mar 17, 2020Latches, locks and linkages. This bulletin describes the procedure to apply grease to the coupling lever of a door latch that has difficulty opening.
• 10173542Mar 17, 2020Latches, locks and linkages. This bulletin describes the procedure to apply grease to the coupling lever of a door latch that has difficulty opening.
• 10172228Feb 27, 2020Equipment, Engine cooling. Applicable vehicles with 2.0L Turbo and 2.4L GDI engines may experience the Check Engine warning lamp illuminated with DTC P1326. Follow the procedures on TSB #20-01-004H (supersedes TSB #19-01-006H-4) rotate the crankshaft, perform the bearing inspection (if crankshaft does rotate) and/or replace the engine based on the crankshaft/bearing inspection results.
• 10172225Feb 20, 2020Equipment, Electrical system, Transmission and drivetrain. If you are servicing an applicable vehicle with a “Check Engine” light on and one or more of the DTC listed below, follow the repair procedure and replace the related solenoid and oil pressure harness.
• 10172224Feb 18, 2020Equipment, Engine cooling, Electrical system. Applicable vehicles with 2.0L Turbo and 2.4L GDI engines may experience the Check Engine warning lamp illuminated with DTC P1326. Follow the procedure to inspect the vehicle and replace the engine or update the engine ECU software based on the inspection results.
• 10172223Feb 18, 2020Equipment, Engine cooling, Electrical system. Hyundai is conducting a product improvement campaign to enhance the knock sensor software to detect abnormal engine bearing noise before potentially severe engine damage occurs. If abnormal engine bearing noise is detected, the Malfunction Indicator Lamp (MIL) will blink continuously, a chime will sound on certain vehicles, and the vehicle will be placed in Engine Protection Mode allowing the customer to drive to…
• 10172220Feb 18, 2020Equipment, Engine cooling, Electrical system. Hyundai has developed a new engine monitoring technology called a Knock Sensor Detection System (KSDS). The technology uses software innovations and leverages existing engine sensors to continuously monitor for symptoms that may precede an engine failure. Watch this video to learn more. The KSDS software continuously monitors engine vibrations for unusual patterns that develop as an engine connecting rod bearing…
• 10172142Feb 5, 2020Suspension. This bulletin describes the requirements for all wheel alignment and/or vehicle tracking claims and best practices when diagnosing and conducting alignment-related repairs for all models and model years.
• 10170883Jan 16, 2020Electrical system. This bulletin provides guidelines to inspect the USB, head unit, and multi-box for common connection conditions. 2. This bulletin presents guidelines to inspect for common Android Auto and Apple CarPlay connection conditions. 3. This bulletin provides physical differences between the USB 2.0 port and USB 3.0 port.

← All problems reported for the 2019 Hyundai Veloster