2011 Mazda MAZDA2 Technical Service Bulletins

218 technical service bulletins (TSBs) are on record for the 2011 Mazda MAZDA2. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10097348Mar 11, 2013Transmission and drivetrain. Always be sure to use the correct automatic transmission fluid when replacing atf. Using the wrong atf may cause shift quality complaints or may even damage the transmission.note:•atf m-v (type m5) is not the same fluid as mercon®v or mercon®lv atf.•atf m-v (type m5) has a greater viscosity than mercon®v and mercon®lv atf in low temperatures.
• 10097343Mar 11, 2013Equipment. This service bulletin provides information regarding the proper use of the driver’s floor mat to avoid any poten-tial interference with the foot pedals. The following are possible causes of floor mat interference, which can be avoided with proper usage.•floor mat moves forward due to improper installation.•inappropriate floor mat (such as aftermarket, non-factory-equipped, or non-genuine) is used.•floor mat is…
• 10052155Mar 11, 2013Equipment. Mazda: on some vehicles, to avoid potential interference of foot placed on pedals, information is provided regarding proper use, and placement, of driver's floor mat. Various models and model years.
• 10097369Mar 4, 2013Equipment. When dealing with customer complaints of excessive condensation and/or water within the headlamp unit, first determine if all the bulb sockets are present and correctly installed. In most cases you will find that the bulb seal no. 1 (a) or hid bulb seal no. 1 (b) and bulb seal no.
• 10097367Mar 4, 2013Transmission and drivetrain. Always be sure to use the correct automatic transmission fluid when replacing atf. Using the wrong atf may cause shift quality complaints or may even damage the transmission.note:•atf m-v (type m5) is not the same fluid as mercon®v or mercon®lv atf.•atf m-v (type m5) has a greater viscosity than mercon®v and mercon®lv atf in low temperatures. •atf m-v (type m5) has a greater anti-judder specification than mercon®v…
• 10052160Mar 4, 2013Exterior lighting. Mazda: on various model years and model vehicles, the headlamp assembly would have excessive condensation or water within and should be checked and replaced, if necessary for correct installation.
• 10097320Feb 19, 2013Steering. Some customers may complain that the steering wheel is off center more than 3° even when driving straight on a flat road.
• 10097295Jan 15, 2013Equipment. Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner’s manual. Services performed outside of mazda’s factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers.
• 10097300Jan 14, 2013Equipment. Some customers may complain of signs of oil on the struts or shock absorbers. In most cases the oil that is present is normal, and a result of the oil that remains on the shaft during the normal sweeping process of the shaft seal. Follow the inspection guidelines to determine if the condition is a result of the normal sweeping process or a failure of the shaft seal.
• 10097941Dec 21, 2012Exterior lighting. Some customers may complain of condensation/fog inside the front or rear combination lights. The recent new models have been fitted with a clear lens which can cause the symptom to be more noticeable, however, it does not affect the performance of the light. This condensation/fog is a natural henomenon that occurs when there is a fairly large temperature difference between the inside and the outside of the light…
• 10097942Dec 19, 2012Equipment. Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner’s manual. Services performed outside of mazda’s factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers.
• 10097842Nov 16, 2012Seats. Some customer’s may complain about a rattle noise in the driver’s seat (a) when stopping or starting the vehicle. This rattle noise is caused by a gap between the seat frame and the link bracket. To correct the problem, a bracket and seat spring are attached to the inner and outer seat frames.
• 10060862Nov 16, 2012Seats. Summary to be provided on a future date.
• 10044563May 11, 2012Body and structure. Mazda: while driving, the passenger side floor would make rattling noise when on rough roads.
• 10037512Mar 25, 2011Electrical system. Mazda: passenger air bag deactivation light illumination concerns.
• 10037949Feb 7, 2011Exterior lighting. Mazda: there is possible excessive condensation or water inside the headlamp unit on many mazda models.
• 10037655Dec 23, 2010Exterior lighting. Mazda: there is condensation and fog in the front and rear combination lights.
• 10037415Nov 23, 2010Latches, locks and linkages, Body and structure. Mazda: liftgate does not open properly or close properly. When using the electronic opener, the liftgate will open partially and lock.

← All problems reported for the 2011 Mazda MAZDA2