2014 Mazda MAZDA6 Technical Service Bulletins

757 technical service bulletins (TSBs) are on record for the 2014 Mazda MAZDA6. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10213399Feb 26, 2016Body and structure, Equipment. Brake noise, judder and dragging diagnosis and servicing
• 10213391Feb 26, 2016Electrical system, Tires. Tire pressure monitoring system (TPMS) warning Light IlluminationMisure prevention logic
• 10213326Feb 26, 2016Equipment. Mazda guidelines for factory scheduled maintenance
• 10105891Feb 26, 2016Brakes. Some vehicles exhibit brake related concerns such as brake noise, brake judder or brake dragging. If you encounter a customer complaint for any one of these symptoms, refer to the following information to understand why symptoms may occur, and to better assist the customer in resolving their specific brake concern.
• 10076632Feb 26, 2016Electrical system. Summary to be provided on a future date.
• 10213466Feb 23, 2016Latches, locks and linkages. Corrosion around spot welds in trunk opening.
• 10213398Feb 23, 2016Equipment. Clunk/bang/buzz noise during first forward movement after sitting
• 10213390Feb 23, 2016Suspension. Creaking Noise from front lower control arm bushings
• 10076679Feb 23, 2016Equipment, Body and structure. Corrosion around spot welds in trunk opening. Some vehicles may exhibit corrosion around the spot welds in trunk opening under the rear window. This is caused by insufficient paint thickness at the spot welds. To correct the problem, the paint thickness has been improved.
• 10076647Feb 23, 2016Suspension. Summary to be provided on a future date.
• 10213428Feb 17, 2016Body and structure. Stains found on kpaint during PDI
• 10213427Feb 17, 2016Electrical system. HandsFree bluetooth module and/or text messaging troubleshooting procedure
• 10213425Feb 17, 2016Electrical system. Speedometer replacement procedure
• 10213388Feb 17, 2016Suspension. Front/Rear stabilizer noise prevention
• 10076678Feb 17, 2016Body and structure. Stains found on paint during pdi some vehicles may experience stains appearing on the hood, roof and/or trunk of vehicle. This concern is most likely to be found in cold weather areas just after the rapgard is removed at pdi. This may be caused by moisture which has been trapped and condensed betwen paint and the rapgard. These types of stains can be removed with heat gun or an infrared drier.
• 10076677Feb 17, 2016Equipment. Hands-free bluetooth module and/or text messaging troubleshooting procedure. Some vehicles may exhibit bluetooth hands-free and/or text messaging related concerns. To improve thehandling of bluetooth hands-free and/or text messaging customer concerns, mazda created a special service and parts exchange program as of february 2010. Customers experiencing related concerns should have their vehicle and/or device…
• 10213387Feb 15, 2016Equipment, Suspension. Shock absorber replacement guidelines
• 10213333Feb 15, 2016Equipment, Electrical system. Battery test procedure requirements using the GR81291
• 10213332Feb 15, 2016Equipment, Electrical system. Battery Maintenance
• 10213331Feb 15, 2016Engine cooling, Equipment. Sulfur smell from exhaust system.
• 10213417Feb 5, 2016Exterior lighting, Air bags. Passenger fAirbag deactivation (PAD) indicator light illumination
• 10213330Feb 5, 2016Equipment, Engine cooling. PreMixed long life "FL22" Engine Coolant
• 10213329Feb 5, 2016Electrical system, Engine cooling. Engine Start /Stop Procedure with room fuse removed
• 10213424Feb 3, 2016Seats, Transmission and drivetrain. Front power seats do not slide back and forth
• 10076674Feb 3, 2016Seats. Front power seats do not slide back and forth. Some customers may complain that the front power (driver and/or passenger) seats do not slide back and forth properly or that they may be completely inoperative. This concern may be caused by a foreign object getting stuck under the power slide unit (below) while in operation. This can cause motor mounting bracket (a) deformation, resulting in motor cable (b) breakage.
• 10213423Feb 2, 2016Equipment. Siriusxm satellite radio registration transfer after unit replacement
• 10213422Feb 2, 2016Equipment. Proper usage of driver's floor mat.
• 10213401Feb 1, 2016Equipment. Mazda Service Support MX Connect MTips
• 10117762Jan 28, 2016Electrical system, Transmission and drivetrain. Mazda Motor Corporation has decided to conduct a Special Service Program (SSP) on certain 2014 Mazda6 vehicles produced from November 8, 2012 through September 27, 2013. On certain 2014 Mazda6 vehicles, a concern has been identified with the software of the vehicle control module (VCM), which controls the Smart Brake Support (SBS) and Mazda Radar Cruise Control (MRCC) features.
• 10213421Jan 25, 2016Exterior lighting. Condensation/Fog in front and rear combination lights
• 10213405Jan 25, 2016Transmission and drivetrain. ATFFZ required for SKYACTIV drive 6speed automatic transaxle
• 10100889Jan 25, 2016Transmission and drivetrain. The new skyactiv-drive fw6a-el at uses “automatic transmission fluid (atf) type: fz”. Only use “atf-fz” to fill or top off the fluid level. Atf-fz is specially designed for use in the skyactiv-drive series at. It is a low viscosity formula with less friction for better fuel economy. Note: atf-fz is colored blue for easy identification. To check the fluid level, remove the bolt, then remove the dipstick. The…
• 10100888Jan 25, 2016Exterior lighting. Some customers may complain of condensation/fog inside the front (headlamp/headlight) or rear (taillamp/tail-light) combination lights. The recent new models have been fitted with a clear lens which can cause the symp-tom to be more noticeable, however, it does not affect the performance of the light. This condensation/fog is a natural phenomenon that occurs when there is a fairly large temperature difference…
• 10213325Jan 14, 2016Equipment. Special service tool shipment Janaurary 2016
• 10105849Jan 14, 2016Equipment. In support of improved electrical diagnosis on skyactiv vehicles, mazda will ship a terminal test kit to all dealers. The test kit is designed pecifically for skyactiv module terminals.• the sst will be shipped by mazda’s tool vendor bosch starting january 15, 2016.• procedures for usage are found in the skyactiv wiring terminal test kit wbt, course #1649.• the following sst is the latest addition to the mazda…
• 10213385Jan 8, 2016Wheels. Stains appear on wheels
• 10105855Jan 8, 2016Wheels. Some automotive cleaning products contain strong acid or alkali. When these types of cleaners are used to clean the wheels on mazda vehicles, the chemicals contents penetrate the clear coating of the wheel surface and damage the paint under the clear coating. The damaged area has the appearance of dark stains.
• 10213440Dec 22, 2015Vehicle speed control. White door armrest(s) pink discoloration
• 10213409Dec 22, 2015Brakes. Ignition does not turn off when pressing start/stop button
• 10213379Dec 22, 2015Engine, Electrical system. Rough Idle with MIL on and DTC P0015/P0524
• 10105639Dec 22, 2015Engine. Some vehicles may experience a rough idle with the mil on and dtc p0015 / p0524 stored in memory. • p0015:00 - exhaust cmp timing over-retarded • p0524:00 - engine oil pressure too low this is caused by a drop in engine oil pressure due to a piece of foreign object stuck on the oil pump pressure relief valve or ocv. The temporary entry of the foreign object triggers a mil illumination, but rough idle will not be…
• 10105638Dec 22, 2015Body and structure. Some customers may complain about a white door armrest(s) pink discoloration. The discolored armrest does not match the other white parts of the door panel. Replace all 4 door panels.
• 10105637Dec 22, 2015Transmission and drivetrain, Electrical system. When pressing the start/stop button, the ignition may not turn off on some vehicles equipped with a gate type at shifter. Although the shift lever is in “p” position and the engine shuts off normally, the ignition may stay on (in accessory mode). This concern may be caused by a worn switch unit. To eliminate this concern, the switch unit material has been changed to improve wear resistance. Modified switch units…
• 10076691Dec 22, 2015Body and structure. White door armrest(s) pink discoloration. Some customers may complain about a white door armrest(s) pink discoloration. The discolored armrest does not match the other white parts of the door panel.
• 10076663Dec 22, 2015Electrical system. Summary to be provided on a future date.
• 10213386Dec 17, 2015Suspension. Knocking/squeaking noise from front shock absorber
• 10213378Dec 17, 2015Electrical system, Engine cooling. Engine Oil seepage from engine oil pressure switch
• 10105646Dec 17, 2015Steering, Suspension. Some vehicles may exhibit a knocking / squeaking noise from the front shock absorber when driving on rough roads and/or when turning the steering wheel while the vehicle is stopped. The noise may be due to: • upper front strut bearing (a) damage. (cx-5 and mazda6) • stick/slip between the front strut bearing and coil spring. • the bump stopper (c) may be contacting the strut bearing when the front shock absorber is…
• 10105644Dec 17, 2015Engine. Frequent engine starts under extremely cold ambient temperatures may result in oil seepage from the engine oil pressure switch. This concern may be caused by a lack of durability of the oil pressure switch under these conditions. To correct the problem, the oil pressure switch has been improved to increase the durability in cold ambient temperatures.
• 10076642Dec 17, 2015Suspension. Summary to be provided on a future date.

← All problems reported for the 2014 Mazda MAZDA6