2017 Mercedes-Benz AMG C43 Seat belts Problems

“Both front seat belts on the driver and passenger side fail to retract. Looking up my car model I found the following: Mercedes-Benz USA, LLC (MBUSA) is recalling certain 2017-2021 C300, 2017-2020 AMG C43, and AMG C63 vehicles. The front seat belts might not fully retract to their stowed position. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 208, Occupant Crash Protection. However my vin number was not marked for the repair and the dealer refused to cover it. I ended up paying for the repair out of pocket for safety.”

“The contact owns a 2017 Mercedes-Benz AMG C43. The contact stated that the front driver’s side seat belt failed to retract as intended. No warning light was illuminated. The vehicle was taken to a local dealer for diagnosis but was not repaired due to the cost. Upon further investigation, the contact related the failure to NHTSA Campaign Number: 21V032000 (Seat Belt); however, the VIN was not included. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 70,000.”

“The contact owns a 2017 Mercedes-Benz AMG C43. The contact stated that the driver’s and passenger’s side front seat belt retractors had malfunctioned, and the seat belts would not retract after unlocking. The vehicle was taken to the local dealer who performed the recall repair under the NHTSA Campaign Number: 21V032000 (Seat Belts). The contact indicated that after retrieving the vehicle, the failure was still present. The cause of the failure was not yet determined. The manufacturer was notified of the failure. The failure mileage was 50,000.”

“The contact owns a 2017 Mercedes-Benz C43 AMG. The contact received a recall notification for NHTSA Campaign Number: 21V032000 (Seat Belts) however, the dealer informed the contact that the part for the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was notified of the issue but provided no assistance. The contact had not experienced a failure. Parts distribution disconnect.”