2008 Mercedes-Benz C63 Technical Service Bulletins

98 technical service bulletins (TSBs) are on record for the 2008 Mercedes-Benz C63. TSBs are notes manufacturers send to dealers about repair procedures for issues seen in the field. They are not recalls and do not by themselves mean a vehicle has a fault.

• 10205225Aug 26, 2016Exterior lighting. Headlamps fogged.
• 10205239Aug 16, 2016Equipment. "Anti-theft protection activated".
• 10235983Feb 26, 2016Equipment, Electrical system, Air bags. Daimler AG (DAG) has decided that a supplier production error in the SRS control unit could lead to a failure of the SRS control unit. This malfunction of the SRS control unit would illuminate the SRS warning lamp and subsequently deactivate the SRS components. Additionally, in the event one specific electrical connection is interrupted, several SRS components could inadvertently deploy, increasing the risk for…
• 10235978Feb 11, 2016Air bags. Recall Campaign announcement for Takata driver airbags.
• 10135599Mar 24, 2015Suspension. Clunking noise from front axle suspension strut or rear axle shock absorber on short strokes of the damper
• 10166093Jul 12, 2014Seats. Noises from flat spring core in backrest
• 10166080Jul 12, 2014Seats. The pneumatic 4-way lumbar support fails. Lumbar support pockets cannot be filled up or they drain.
• 10166099Jul 10, 2014Seats. Pneumatic comfort systems with insufficient performance, entirely inoperative or leaky.
• 10167489Mar 19, 2014Engine cooling. Noise: A rattling noise may be heard from the area of the chain drive for approx. 2-5 seconds after engine start. And/or: Fault code entries in engine control unit: SIM271DE20: P001177 The position of the intake camshaft (cylinder bank 1) deviates from the specified value. The commanded position cannot be reached. P001762 The position of the exhaust camshaft (cylinder bank 1) is implausible in comparison with the…
• 10167532Mar 10, 2014Equipment. A production fault means that the telematics DVD A 166 827 14 00 cannot be used. Because of this the previous telematics DVDs A 204 827 03 65 and A 204 827 10 65 must continue to be used for control unit programming. If required, these are still available for ordering. With XENTRY DVD 03/2014 a new telematics DVD with part number A 166 827 21 00 is being shipped. This telematics DVD replaces the previous telematics…
• 10167525Mar 3, 2014Equipment. Apple products (iPhone or iPod) are not charged via the serial USB interface of the COMAND Online control unit (A40/3) in the stowage compartment of the center console.
• 10167510Feb 28, 2014Electrical system, Transmission and drivetrain. The vehicle cannot be started The vehicle may start by itself shortly after the startup attempt with a delay, as the relay can be late closing. and/or The gear selection is displayed, but no gear is engaged. Gear selection is not possible. and/or Rear window wiper inoperative. and/or Various fault codes concerning disrupted communication paths are stored and/or the corresponding control units are not displayed in…
• 10167009Feb 25, 2014Electrical system. Battery discharged, vehicle does not start.
• 10167007Feb 25, 2014Electrical system. Engine diagnosis warning lamp active. Fault code 20BE1B and/or 20BD1B (The heating element of the AdBlue tank has a malfunction) is logged in the Blue-Tec control unit.
• 10167002Feb 25, 2014Steering. Creaking noise when making vertical or longitudinal adjustment to electrical steering column
• 10166994Feb 25, 2014Transmission and drivetrain. Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end). Heard once when changing from forward to reverse (and vice versa)
• 10167003Feb 18, 2014Steering. Fault code U41600 logged in 'ES' (electric steering) control unit after software update or steering gear replacement. Note: Fault code U41600 means: Implausible data were received from the control unit "Traction system". This fault code can be erased, but is logged again after another ignition sequence. There is no fault message in the multifunction display.
• 10167006Feb 12, 2014Electrical system. Engine diagnosis warning lamp active. Fault code 20BE1B and/or 20BD1B (The heating element of the AdBlue tank has a malfunction) is logged in the Blue-Tec control unit.
• 10166975Feb 11, 2014Equipment. This Customer 1 Action has been initiated because certain mbrace subscribers were recently contacted by mbrace informing them that they need to have an i-button call performed to ensure their mbrace device has registered with the Verizon Telematics systems. If the i-button call failed or if the customer was unable to perform the i-button call, the mbrace agent instructed the customer to make an appointment with…
• 10167015Feb 10, 2014Electrical system. The key is not recognized in the electronic ignition switch, the vehicle cannot be started and/or the automatic transmission may perform an "Automatic P function" at speeds below 6 km/h.
• 10166978Feb 6, 2014Engine cooling. Engine diagnosis warning lamp lights up - Fault code entry (FC) 14A600 or 14A700
• 10167040Feb 1, 2014Electrical system. This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes-Benz vehicles, has determined that the mbrace software does not correspond to current production configuration. An authorized Mercedes-Benz dealer will update the mbrace control module software at the next workshop visit.
• 10167038Feb 1, 2014Body and structure, Tires. This Service Campaign has been initiated because Daimler AG (DAG), manufacturer of Mercedes-Benz vehicles, has determined that the seam seal at the spare tire well may not be to specification. To correct this condition, an authorized Mercedes-Benz dealer will rework the seam seal at the spare tire well at the next workshop visit.
• 10167016Dec 12, 2013Electrical system. The Parktronic system switches to malfunction. The driver notices a fault message (4 red LEDs and 2 sec continuous signal). The following fault codes are stored in the PTS control unit (N62): A23400 - Rear PARKTRONIC warning element 1 has a malfunction. - STORED A23300 - Front PARKTRONIC warning element 1 has a malfunction. - STORED
• 10205234Aug 21, 2013Electrical system. Software update of COMAND Online control unit.
• 10205237Aug 5, 2013Electrical system. The COMAND unit does not start or the display remains dark.
• 10205233Aug 5, 2013Electrical system. Mobile phone cotacts are not transferred completely.
• 10167546Jul 30, 2013Transmission and drivetrain. FC 2783 (Friction power of torque converter lockup clutch is too high) or FC 0741 (Actuation of torque converter lockup clutch not possible) stored in transmission control unit. One possible additional customer complaint could be "poor acceleration" e.g. due to engine intervention. This can affect all NAT2FE+ (7G-TRONIC PLUS) vehicles with engines OM651, OM642LS and M278 in the production period from 04/2011 to…
• 10167550Jul 18, 2013Steering. Single, throttle lift-off, clunking noise from the side shaft when starting off (audible at the wheel). The clunk is heard once when changing from forward to reverse (and vice versa).
• 10167564Jul 12, 2013Electrical system. Customer experiences low battery conditions, resulting in jump starts, and eventually requiring battery replacement.
• 10167554Jul 10, 2013Engine cooling. Engine diagnosis warning lamp activated. Fault code P045600 "Very fine leak" or P044200 "Fine leak" stored in engine control unit.
• 10167563Jul 8, 2013Electrical system. The COMAND unit does not start or the COMAND display remains dark. The COMAND unit cannot be operated. Note: The problem disappears after a lengthy idle period (>6h) or after interrupting the power supply (circuit 30).
• 10167560Jul 8, 2013Exterior lighting. Fault message in display - Right rear turn signal light inoperative
• 10205265Jul 3, 2013Visibility (wipers, defrost, mirrors). Outside mirror fogged.
• 10167536Jul 1, 2013Tires. Model X204 (GLK 250 BT) with AMG Styling Package 321. Model Year 2013 Install Tire Fit Kit, Replace Monroney Label
• 10167552Jun 28, 2013Electrical system. Engine does not start, or various fault messages in instrument cluster immediately after engine start and servo assistance is reduced.
• 10048279Nov 1, 2012Electrical system. Mercedes: camshaft adjustment solenoid may leak oil due to settling properties of seal and the engine wiring harness will be retrofitted with four adapter harnesses as a precautionary measure. Models 2005-2011 164, 171, 203, 204, 207, 209, 211, 212, 216. 219, 221, 230, 251, 463. *pe updated 12/18/12. *pe updated 3/18/2013
• 10044603Apr 18, 2012Exterior lighting. Xentry (mercedes): the signal light for right rear turn is inoperative. Fault message displayed.
• 10039256May 31, 2011Engine cooling. Mercedes-benz: the malfunction light is on with multiple possible trouble codes stored. There could be a problem with the camshaft and/or scoring of a piston.
• 10037967Dec 13, 2010Interior lighting, Electrical system, Exterior lighting. Mercedez-benz: auto lights inoperative mesage is displayed. This is a software problem.
• 10037988Dec 8, 2010Body and structure. Mercedes-benz: on rough roads there is a knocking noise in the liftgate area. The stop buffers are too hard and are creating the noise during vibration.
• 10037408Nov 19, 2010Suspension. Mercedes-benz: shock absorber procedure.
• 10033072Dec 17, 2009Exterior lighting. Xentry: exterior lights constantly on. Possible components: low beams; front fog lamp; high beams; washer fluid pump and the headlamp cleaning system are also potentially affected. Hardware fault in driver side sam. Model 204. No model years listed.
• 10033073Dec 3, 2009Steering. Xentry: steering leaky at internal oil lines. Connector of internal oil line or sealing washers/o-rings damaged. Not necessary to replace the entire steering system. Remove steering; replace both internal oil lines; install steering. Models 204 (except 4matic) and all model 207. No model years listed.
• 10034566Nov 1, 2009Electrical system. Mercedes benz: reprogram mbrace (n123/4) dialed numbers to hughes. This action applies to new vehicle inventory only.
• 10032708Sep 29, 2009Seat belts. Mercedes: seat belts, emergency tensioning retractors. A new reversible emergency tensioning retractor cannot be installed. As of modification , the connector housing of the reversible emergency tensioning retractor was revised and is incompatible with the vehicle wiring harness as a result. Year of manufacture 09/01.
• 10032726Sep 3, 2009Seat belts. Mercedes: fault message in instrument cluster (pre-safe inactive) and fault code 530630 is current and stored in the reversible emergency tensioning retractor control unit. Left front reversible emergency tensioning retractor control unit (a76) or right front reversible emergency tensioning retractor control unit (a76/1) cannot be started up.
• 10033632Sep 1, 2009Body and structure. Mercedes benz: adjust trunk lid stops. Due to tolerance and settling of the rubber seal the trunk lid may touch the bumper during closing on the affected vehicles. Dealers will adjust the trunk lid stops at the next workshop visit.

← All problems reported for the 2008 Mercedes-Benz C63