Skip to content
Recall campaign97V237000

Recall 97V237000: 1995–1997 BMW R1100 and 1 other model

Electrical system › Wiring
Report received
Dec 31, 1997
Manufacturer
Bayerische motoren werke
Potentially affected
2,000vehicles
Model years
1995–1997

Check your own vehicle. A recall applies only to vehicles within the affected build range. Enter your VIN at nhtsa.gov/recalls. Recall repairs are free at a franchised dealer.

What NHTSA recorded

Vehicle description: motorcycles. A sheet metal plate mounted to the front of the frame below the instrument cluster can cause the wiring harness to be stretched too tight as the handlebars are turned fully to one side. In addition, the wiring harness is attached to another harness with a cable tie that is placed too far forward limiting the handlebar movement.

Possible consequence

The harness wires can be damaged or could break or pull out of the ignition switch. If the harness wires were damaged but not broken or disconnected, the electrical system could be affected while the motorcycle is being driven. Hesitation, misfiring, or "cutting out" could occur increasing the risk of a vehicle crash.

Remedy

Dealers will relocate the wire tie connecting the two wiring harnesses to a point further back from the original location so that the ignition switch wiring harness has sufficient freedom of movement. Also if the wiring harness is found to be damaged, the ignition switch (with harness) will be replaced.

Affected model years

Pages for each model year show complaints, parts, mileage and other recalls.

About this data. Data from NHTSA (ODI) complaints, recalls, TSBs and investigations, updated Oct 28, 2026. Complaints are unverified consumer reports and may be duplicated or inaccurate.