1989 Suzuki Swift Recalls

NHTSA lists 2 recall campaigns for the 1989 Suzuki Swift. A recall applies only to vehicles built within the affected range, so check your own VIN at nhtsa.gov/recalls. Repairs for recalls are free at a franchised dealer.

• 95V103008May 24, 1995127,155 vehicles potentially affected
  Seat belts › Front › Buckle assembly
  Covers: Suzuki Swift 1989–1991, Samurai 1988–1991, Sidekick 1989–1991

  Reported issue: The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." if a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.

  Possible consequence: The safety belts would not provide adequate protection to an occupant in a vehicle crash.

  Remedy: Owners should promptly check the condition and operation of both front safety belt buckles and carefully inspect the red release button for any breaks or cracks. They should ensure that both buckles are operating properly by inserting each latch plate into its buckle, tugging on the belt to make sure the latch is…

  Full campaign details →

• 93V189000Nov 30, 199338,229 vehicles potentially affected
  Latches/locks/linkages › Hood › Latch
  Covers: Suzuki Swift 1989–1993

  Reported issue: Mislocated attaching spot welds of the hood striker assembly cause cracks to start on the hood inner panel. If cracks occur, the hood striker assembly may not properly engage the hood latch when the hood is closed.

  Possible consequence: An improperly engaged hood latch may result in a hood fly-up while the vehicle is in motion. This could obstruct the driver's view and could cause a vehicle crash.

  Remedy: Suzuki will (a) install two bolts and nuts to secure the striker assembly to the hood inner panel, and (b) ensure that the hood latch assembly fasteners are properly tightened.

  Full campaign details →

← All problems reported for the 1989 Suzuki Swift